Zibro SRE 346 E manual

Zibro SRE 346 E
7.4 · 3
PDF manual
 · 18 pages
English
manualZibro SRE 346 E
E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E E
1 LISEZ PRÉALABLEMENT LE MANUEL D’UTILISATION.
2 EN CAS DE DOUTE, CONTACTEZ VOTRE REVENDEUR ZIBRO.
3 POUR LIRE, DÉPLIEZ LA DERNIÈRE PAGE. E E E E E E E E E E E E E 3 POUR LIRE, DÉPLIEZ LA DERNIÈRE PAGE. E E E E E E E E E E E E E
AFNOR CERTIFICATION - 11, RUE FRANCIS DE PRESSENSE
93571 LA PLAINE SAINT-DENIS CEDEX

FICHE INFORMATIVE

La marque NF garantit
la qualité de cet article
suivant les normes françaises
et Règles de certification
de l’application NF 128
CONFORME A LA NORME NF D 35-300 ET AUX SPECIFICATIONS
COMPLEMENTAIRES DEFINIES PAR LES REGLES
DE CERTIFICATION DE LA MARQUE NF 128
PRINCIPALES CARACTERISTIQUES CERTIFIEES:
• Sécurité du dispositif d’allumage
• Débit calorifique
• Efficacité des dispositifs de sécurité
• Stabilité
• Contrôle de la teneur en NO
x
dans les produits de combustion
• Contrôle de la qualité de la combustion (absence de CO)
• Endurance
• Intermittence
CONSEILS D’UTILISATION ET D’ENTRETIEN
Se reporter à la notice jointe à l’appareil et à la plaque de sécurité sur
l’appareil
Référence et numéro de lot ou de série de l’article : se reporter au produit
Distributed in Europe by:
PVG International B.V.

P.O.Box 96, 5340 AB OSS

Pays-Bas Tél.: +31 (0) 412 694670
En cas d’insatisfaction, consultez d’abord votre revendeur :
Si une difficulté subsistait, vous pouvez écrire à
CERTITA
39/41, rue Louis Blanc
92400 COURBEVOIE
NF 128 02 / 02
co_R22xC.qxd:co_R22xC.qxd 03-05-11 16:14 Page 4

Manual

View the manual for the Zibro SRE 346 E here, for free. This manual comes under the category heaters and has been rated by 3 people with an average of a 7.4. This manual is available in the following languages: English. Do you have a question about the Zibro SRE 346 E or do you need help? Ask your question here

Need help?

Do you have a question about the Zibro and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Zibro SRE 346 E specifications

Below you will find the product specifications and the manual specifications of the Zibro SRE 346 E.

General
BrandZibro
ModelSRE 346 E
Productheater
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Zibro SRE 346 E below.

What is the ideal room temperature?

Most people find that the ideal room temperature is between 19 and 22 degrees Celsius.

How do I troubleshoot if the Zibro SRE 346 E heater does not ignite?

To troubleshoot if the Zibro SRE 346 E heater does not ignite, follow these steps: 1. Check the fuel level: Ensure that the tank is not empty and has enough fuel to ignite the heater. 2. Verify the fuel quality: Make sure you are using high-quality fuel recommended for the Zibro SRE 346 E heater, such as Zibro Extra, Zibro Kristal, or Zibro Bio. Using low-quality or contaminated fuel can prevent ignition. 3. Check the tank closure: Ensure that the tank is properly closed after filling it. A loose or improperly closed tank can prevent ignition. 4. Improve ventilation: If the room where the heater is installed has poor ventilation, the heater may not ignite. Open a door or window slightly to improve air circulation. 5. Reset the heater: If the heater has a reset function, try resetting it by turning it off and unplugging it from the power source for a few minutes. Then, plug it back in and try igniting it again. If the issue persists after following these troubleshooting steps, it is recommended to contact your Zibro dealer for further assistance or repairs.

What should I do if the Zibro SRE 346 E heater does not produce enough heat?

To troubleshoot if the Zibro SRE 346 E heater does not produce enough heat, follow these steps: 1. Check for sufficient ventilation: Ensure that the room where the heater is installed has proper ventilation. Open a door or window slightly to allow fresh air to circulate. 2. Verify the room size: Make sure the room is large enough for the heater to operate effectively. If the room is too big, the heater may struggle to provide sufficient heat. Consider using the heater in a smaller, more enclosed space. 3. Clean the air intake and exhaust: Check for any obstructions or blockages in the air intake and exhaust vents of the heater. Remove any dust, debris, or objects that may be hindering airflow. 4. Adjust the temperature setting: Increase the temperature setting on the heater to a higher level. Ensure that the thermostat is set correctly to the desired temperature. 5. Check the fuel quality: Ensure that you are using high-quality fuel recommended for the Zibro SRE 346 E heater. Using low-quality or contaminated fuel can affect the heat output. If the issue persists after following these troubleshooting steps, it is recommended to contact your Zibro dealer for further assistance or repairs.

How can I troubleshoot if the Zibro SRE 346 E heater keeps turning off unexpectedly?

To troubleshoot if the Zibro SRE 346 E heater keeps turning off unexpectedly, follow these steps: 1. Check for proper ventilation: Ensure that the room where the heater is located has sufficient ventilation. Open a door or window slightly to improve air circulation. 2. Verify the room temperature: If the room temperature exceeds 32°C, the heater may automatically turn off. Lower the room temperature and try igniting the heater again. 3. Clean the air filter and fuel pump: A dirty air filter or fuel pump can cause the heater to shut off. Clean the air filter with a vacuum cleaner and tap the fuel pump upside-down to remove any dirt or debris. 4. Check for fuel level: Ensure that the removable tank is not empty. If the fuel level is low, refill the tank with the recommended fuel. 5. Reset the heater: If the heater has a reset function, try resetting it by turning it off and unplugging it from the power source for a few minutes. Then, plug it back in and try igniting it again. If the issue persists after following these troubleshooting steps, it is recommended to contact your Zibro dealer for further assistance or repairs.

What should I check if the Zibro SRE 346 E heater is not maintaining the set temperature?

To troubleshoot if the Zibro SRE 346 E heater is not maintaining the set temperature, follow these steps: 1. Check the thermostat setting: Ensure that the thermostat is set to the desired temperature. Adjust the thermostat if necessary to match your comfort level. 2. Verify the room size: Make sure the heater is suitable for the size of the room. If the room is too large, the heater may struggle to maintain the set temperature. Consider using the heater in a smaller, more enclosed space. 3. Check for drafts: Inspect the room for any drafts or air leaks that may affect the heater's performance. Seal any gaps around windows, doors, or vents to prevent cold air from entering the room. 4. Clean the air filter: A dirty air filter can restrict airflow and impact the heater's ability to maintain the set temperature. Clean the air filter regularly to ensure proper airflow. 5. Ensure proper fuel supply: Check the fuel level in the removable tank and ensure it is not empty. Refill the tank with the recommended fuel if necessary. If the issue persists after following these troubleshooting steps, it is recommended to contact your Zibro dealer for further assistance or repairs.

How do I troubleshoot if the Zibro SRE 346 E heater is leaking fuel?

To troubleshoot if the Zibro SRE 346 E heater is leaking fuel, follow these steps: 1. Check the tank closure: Ensure that the removable tank is properly closed and sealed. Make sure the tank cap is securely tightened to prevent any fuel leakage. 2. Inspect the fuel lines: Check the fuel lines for any signs of damage or cracks. If you notice any leaks or damage, it is recommended to replace the fuel lines. 3. Verify the fuel quality: Ensure that you are using high-quality fuel recommended for the Zibro SRE 346 E heater, such as Zibro Extra or Zibro Kristal. Using low-quality or contaminated fuel can cause fuel leakage. 4. Clean the fuel filter: A clogged or dirty fuel filter can lead to fuel leakage. Clean the fuel filter regularly to ensure proper fuel flow and prevent leaks. 5. Contact customer support: If the issue persists or you are unable to identify the source of the fuel leakage, it is recommended to contact Zibro customer support for further assistance and guidance. Remember, it is important to address fuel leakage issues promptly to ensure safe and proper operation of the heater.

Is the manual of the Zibro SRE 346 E available in English?

Yes, the manual of the Zibro SRE 346 E is available in English .

Is your question not listed? Ask your question here

No results