Zanussi ZWF 71263 W LINDO 100 manual

Zanussi ZWF 71263 W LINDO 100
(85)
  • Number of pages: 20
  • Filetype: PDF

Possible failures

Problem Possible solution
The programme does not
start.
Make sure that the mains plug is connected to the mains socket.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the end of count-
down.
Deactivate the Child Lock function if it is on.
The appliance does not fill
with water properly.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter of the inlet hose and the filter of the valve are
not clogged. Refer to “Care and cleaning”.
Make sure that the inlet hose has no kinks or bends.
Make sure that the connection of the water inlet hose is correct.
The appliance does not drain
the water.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Make sure that the connection of the drain hose is correct.
Set the drain option if you set a programme without drain phase.
Set the drain option if you set an option which ends with water in the
drum.
If above mentioned solutions do not help, contact the Authorised
Service Centre (as the filter of the drain pump may be clogged).
The spin phase does not op-
erate or the washing cycle
lasts longer than usually.
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
Set the spin option.
Set the drain option if you set an option which ends with water in the
drum.
If above mentioned solutions do not help, contact the Authorised
Service Centre (as the filter of the drain pump may be clogged).
There is water on the floor.
Make sure that the couplings of the water hoses are tight and there is
not water leakages.
Make sure that the water inlet hose and the drain hose have no dam-
ages.
Make sure you use the correct detergent and the correct quantity of
it.
You cannot open the appli-
ance door.
Make sure that the washing programme is finished.
Set the drain or the spin option if there is water in the drum.
Do the emergency drain procedure. See "Frost precautions" (in "Care
and Cleaning" chapter).
The appliance makes an un-
usual noise.
Make sure the levelling of the appliance is correct. Refer to 'Installa-
tion instruction'.
Make sure that the packaging and/or the transit bolts are removed.
Refer to 'Installation instruction'.
Add more laundry in the drum. The load may be too small.

16 www.zanussi.com

Zanussi ZWF 71263 W LINDO 100

Need help?

Number of questions: 91

Do you have a question about the Zanussi ZWF 71263 W LINDO 100 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Zanussi ZWF 71263 W LINDO 100 owners to properly answer your question.

Cherryl wingham • 3-2-2021 4 comments

What are the times of each washing program

What are the times of each washing program
Vanessa • 11-2-2021

Hi how do I use the rapid wash

Stella Lawlor • 14-6-2021

How do I use the rapid wash on ZWF71263W for temp 40 degree

Stella Lawlor • 14-6-2021

What's the best way to do a half wash

Vanessa • 20-10-2021

Anyone know how to fix rubber part?

Anyone know how to fix rubber part?
Answer this question
Sarah Mills • 17-6-2021 No comments

How long do each of the washing cycles take please?

How long do each of the washing cycles take please?
Answer this question
Mariya • 20-9-2021 No comments

How can I wash my clothes with in 15 minutes?

How can I wash my clothes with in 15 minutes?
Answer this question
Bobbi Edwards • 20-7-2021 No comments

I want to turn off beep but mine is an older model than shown and hasn't got the same dial configuration.. help its driving me crazy!

I want to turn off beep but mine is an older model than shown and hasn't got the same dial configuration.. help its driving m...
Answer this question
Manu • 13-5-2021 No comments

How to unlock

How to unlock
Answer this question
Aneta • 11-10-2021 No comments

Hi, what are the times of each washing program , how do I use the rapid wash?

Hi, what are the times of each washing program
, how do I use the rapid wash?
Answer this question
Catherine devine • 10-12-2021 No comments

When it's filling it tripping the electric off

When it's filling it tripping the electric off
Answer this question
Aisling • 28-1-2022 No comments

How long is each washing cycle please

How long is each washing cycle please
Answer this question
Christopher Collington • 31-12-2021 No comments

For installation purposes, I need exact overall dimensions please

For installation purposes, I need exact overall dimensions please
Answer this question
Louis Attard • 8-12-2021 1 comment

How to release open the door after the washing is done and the washing programme is finished. Door cannot open as usual, it is stuck.

How to release open the door after the washing is done and the washing  programme is finished. Door cannot open as usual, it ...
Youssef Boutros-Ghali • 10-1-2022

The door is stuck and won’t open

Answer this question

View the manual for the Zanussi ZWF 71263 W LINDO 100 here, for free. This manual comes under the category Washing Machines and has been rated by 85 people with an average of a 8.4. This manual is available in the following languages: English. Do you have a question about the Zanussi ZWF 71263 W LINDO 100 or do you need help? Ask your question here

Zanussi ZWF 71263 W LINDO 100 specifications

General
Brand Zanussi
Model ZWF 71263 W LINDO 100
Product Washing Machine
Language English
Filetype PDF

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Zanussi ZWF 71263 W LINDO 100.

Is your question not listed? Ask your question here