•Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
•Do not use water spray and steam to clean the appliance.
•Clean the appliance with a moist soft cloth. Only use neutral
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
•Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
•If the supply cord is damaged, it must be replaced by the
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
SAFETY INSTRUCTIONS
INSTALLATION
WARNING! Only a qualified person
must install this appliance.
•Remove all the packaging and the transit bolts.
•Do not install or use a damaged appliance.
•Follow the installation instructions supplied with
the appliance.
•Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
•Make sure the air can circulate around the
appliance.
•At first installation or after reversing the door
wait at least 4 hours before connecting the
appliance to the power supply. This is to allow
the oil to flow back in the compressor.
•Before carrying out any operations on the
appliance (e.g. reversing the door), remove the
plug from the power socket.
•Do not install the appliance close to radiators or
cookers, ovens or hobs.
•Do not install the appliance where there is direct
sunlight.
•Do not install this appliance in areas that are too
humid or too cold.
•When you move the appliance, lift it by the front
edge to avoid scratching the floor.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electric
shock.
•The appliance must be earthed.
•Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.
•Always use a correctly installed shockproof
socket.
•Do not use multi-plug adapters and extension
cables.
•Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable,
compressor). Contact the Authorised Service
Centre or an electrician to change the electrical
components.
•The mains cable must stay below the level of the
mains plug.
•Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
installation.
•Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
USE
WARNING! Risk of injury, burns,
electric shock or fire.
•Do not change the specification of this
appliance.
3
Manual
View the manual for the Zanussi ZQF 11430 DV here, for free. This manual comes under the category freezers and has been rated by 1 people with an average of a 9.8. This manual is available in the following languages: English. Do you have a question about the Zanussi ZQF 11430 DV or do you need help? Ask your question here
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Zanussi ZQF 11430 DV below.
How often should I defrost my freezer?
It is recommended to completely defrost your freezer at least once every six months.
How should I transport a freezer?
A freezer must be transported upright at all times. It is very bad for a freezer to be transported on its side as oil from the compressor can end up in the evaporator.
What do I do about a smelly freezer?
A commonly used method is to temporarily place a cup of vinegar in the freezer.
Is the manual of the Zanussi ZQF 11430 DV available in English?
Yes, the manual of the Zanussi ZQF 11430 DV is available in English .
Need help?
Do you have a question about the Zanussi and is the answer not in the manual?
Question and answer
Number of questions: 0