Zanussi ZHV64450WA manual

Zanussi ZHV64450WA
6 · 1
PDF manual
 · 96 pages
English
manualZanussi ZHV64450WA
2
www.zanussi.com

Recommendations

and suggestions

The Instructions for Use apply
to several versions of this appli-
ance. Accordingly, you may nd
descriptions of individual features
that do not apply to your specic
appliance.
The manufacturer will not be held
liable for any damages resulting
from incorrect or improper instal-
lation.
The minimum safety distance
between the cooker top and the
extractor hood is 650 mm (some
models can be installed at a
lower height, please refer to the
paragraphs on working dimensions
and installation).
Check that the mains voltage
corresponds to that indicated on
the rating plate xed to the inside
of the hood.
For Class I appliances, check that
the domestic power supply guaran-
tees adequate earthing. Connect
the extractor to the exhaust ue
through a pipe of minimum diam-
eter 120 mm. The route of the
ue must be as short as possible.
Do not connect the extractor hood
to exhaust ducts carrying combus-
tion fumes (boilers, replaces, etc.).
If the extractor is used in conjunc-
tion with non-electrical appliances
(e.g. gas burning appliances),
a sufcient degree of aeration
must be guaranteed in the room
in order to prevent the backow
of exhaust gas. The kitchen must
have an opening communicating
directly with the open air in order
to guarantee the entry of clean air.
When the cooker hood is used
in conjunction with appliances
supplied with energy other than
electric, the negative pressure in
the room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by the
cooker hood.
In the event of damage to the
power cable, it must be replaced
by the manufacturer or by the
technical service department, in
order to prevent any risks.
If the instructions for installation
for the gas hob specify a greater
distance specied above, this has
to be taken into account. Regula-
tions concerning the discharge of
air have to be fullled.
Use only screws and small parts
in support of the hood.
Warning: Failure to install the
screws or xing device in accord-
ance with these instructions may
result in electrical hazards.
Connect the hood to the mains
through a two-pole switch having
a contact gap of at least 3 mm.
Use
The extractor hood has been
designed exclusively for domestic
use to eliminate kitchen smells.
Never use the hood for purposes
other than for which it has been
designed.
Never leave high naked ames
under the hood when it is in op-
eration.
Adjust the ame intensity to direct
it onto the bottom of the pan only,
EN

Manual

View the manual for the Zanussi ZHV64450WA here, for free. This manual comes under the category exhaust hoods and has been rated by 1 people with an average of a 6. This manual is available in the following languages: English. Do you have a question about the Zanussi ZHV64450WA or do you need help? Ask your question here

Need help?

Do you have a question about the Zanussi and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Zanussi ZHV64450WA specifications

Below you will find the product specifications and the manual specifications of the Zanussi ZHV64450WA.

General
BrandZanussi
ModelZHV64450WA | ZHV64450WA
Productexhaust hood
EAN7332543476992
LanguageEnglish
FiletypeUser manual (PDF)
Design
Control typeTouch
Product colorWhite
Exhaust connection diameter150 mm
Number of motors1
TypeWall-mounted
Built-in displayNo
Weight & dimensions
Height (max)1172 mm
Height (min)912 mm
Width598 mm
Depth379 mm
Weight16800 g
Packaging data
Package weight21000 g
Filtering
Grease filter typeAluminum
Power
AC input voltage220 - 240 V
Energy efficiency classD
Annual energy consumption- kWh
Motor power- W
Performance
Lighting efficiency classA
Noise level67 dB
Grease filtering efficiency classG
Fluid dynamic efficiency classE
Number of speeds3
Maximum extraction power- m³/h
Type of extraction-
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Zanussi ZHV64450WA below.

What is the weight of the Zanussi ZHV64450WA?

The Zanussi ZHV64450WA has a weight of 16800 g.

When should I replace the carbon filter on my extractor hood?

The carbon filter should be replaced every three to twelve months.

How often should I clean the metal hood grease filters?

The metal grease filters should be cleaned every eight to ten weeks.

Where can I find the model number of my cooker ectractor hood?

The model number of the hood is usually found on a white label inside the hood.

What is the width of the Zanussi ZHV64450WA?

The Zanussi ZHV64450WA has a width of 598 mm.

What is the depth of the Zanussi ZHV64450WA?

The Zanussi ZHV64450WA has a depth of 379 mm.

What energy label does the Zanussi ZHV64450WA have?

The Zanussi ZHV64450WA has energy label D.

Is the manual of the Zanussi ZHV64450WA available in English?

Yes, the manual of the Zanussi ZHV64450WA is available in English .

Is your question not listed? Ask your question here

No results