Zanussi ZHT631B manual

Zanussi ZHT631B
8.5 · 1
PDF manual
 · 120 pages
English
manualZanussi ZHT631B
2
www.zanussi.com

Recommendations

and suggestions

The Instructions for Use apply
to several versions of this ap-
pliance. Accordingly, you may
nd descriptions of individual
features that do not apply to
your specic appliance.
The manufacturer will not be
held liable for any damages
resulting from incorrect or
improper installation.
The minimum safety distance
between the cooker top and
the extractor hood is 650 mm
(some models can be installed
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
Check that the mains voltage
corresponds to that indicated
on the rating plate xed to the
inside of the hood.
For Class I appliances, check
that the domestic power supply
guarantees adequate earthing.
Connect the extractor to the
exhaust ue through a pipe
of minimum diameter 120 mm.
The route of the ue must be
as short as possible.
Do not connect the extractor
hood to exhaust ducts carrying
combustion fumes (boilers,
replaces, etc.).
If the extractor is used in
conjunction with non-electrical
appliances (e.g. gas burning
appliances), a sufcient degree
of aeration must be guaranteed
in the room in order to pre-
vent the backow of exhaust
gas. The kitchen must have
an opening communicating
directly with the open air in
order to guarantee the entry
of clean air. When the cooker
hood is used in conjunction
with appliances supplied with
energy other than electric,
the negative pressure in the
room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by
the cooker hood.
The air must not be discharged
into a ue that is used for ex-
hausting fumes from applianc-
es burning gas or other fuels
(not applicable to appliances
that only discharge the air back
into the room).
In the event of damage to
the power cable, it must be
replaced by the manufacturer
or by the technical service de-
partment, in order to prevent
any risks.
If the instructions for installa-
tion for the gas hob specify
a greater distance specied
above, this has to be taken
into account. Regulations
concerning the discharge of
air have to be fullled.
Use only screws and small
parts in support of the hood.
Warning: Failure to install
the screws or xing device in
accordance with these instruc-
tions may result in electrical
hazards.
Connect the hood to the mains
through a two-pole switch hav-
ing a contact gap of at least
EN

Manual

View the manual for the Zanussi ZHT631B here, for free. This manual comes under the category exhaust hoods and has been rated by 1 people with an average of a 8.5. This manual is available in the following languages: English. Do you have a question about the Zanussi ZHT631B or do you need help? Ask your question here

Need help?

Do you have a question about the Zanussi and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Zanussi ZHT631B specifications

Below you will find the product specifications and the manual specifications of the Zanussi ZHT631B.

General
BrandZanussi
ModelZHT631B | ZHT631B
Productexhaust hood
EAN7332543603176
LanguageEnglish
FiletypeUser manual (PDF)
Power
Energy efficiency classD
Energy efficiency scaleA+++ to D
Annual energy consumption57 kWh
AC input voltage220 - 240 V
Performance
Type of extractionDucted
Fluid dynamic efficiency classF
Lighting efficiency classF
Grease filtering efficiency classD
Number of speeds2
Maximum extraction power220 m³/h
Noise level67 dB
Noise level (low speed)56 dB
Filtering
Removable filterYes
Dishwasher proof filterYes
Washable filterYes
Grease filter typeCarbon
Lighting
Number of bulbs1 bulb(s)
Lighting positionFront
Bulb typeLED
Design
TypeBuilt-in
Product colorBlack
Number of motors1
Motor includedYes
Built-in display-
Exhaust locationTop
Exhaust connection diameter120 mm
Control typeLever
Weight & dimensions
Width598 mm
Depth482 mm
Height (max)150 mm
Packaging content
Quick installation guideYes
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Zanussi ZHT631B below.

When should I replace the carbon filter on my extractor hood?

The carbon filter should be replaced every three to twelve months.

How often should I clean the metal hood grease filters?

The metal grease filters should be cleaned every eight to ten weeks.

Where can I find the model number of my cooker ectractor hood?

The model number of the hood is usually found on a white label inside the hood.

What is the width of the Zanussi ZHT631B?

The Zanussi ZHT631B has a width of 598 mm.

What is the depth of the Zanussi ZHT631B?

The Zanussi ZHT631B has a depth of 482 mm.

What energy label does the Zanussi ZHT631B have?

The Zanussi ZHT631B has energy label D.

Is the manual of the Zanussi ZHT631B available in English?

Yes, the manual of the Zanussi ZHT631B is available in English .

Is your question not listed? Ask your question here

No results