Zanussi ZCG63040XA manual

Zanussi ZCG63040XA
8.8 · 1
PDF manual
 · 24 pages
English
manualZanussi ZCG63040XA
BURNER NORMAL POWER kW
Natural Gas
INJECTOR MARK 1/100 mm Btu/h
Rapid 3 119 10236
Grill 2.7 122 9212
Top Oven 1.7 95 5804
Main Oven 1.7 95 5804
GAS CONNECTION
Use a flexible pipe in compliance with the
regulation in force. Make sure they do not come in
touch with mobile parts and are not squeezed.
WARNING! Only a qualified and
competent person can do the gas
installation.
Before you connect te gas, disconnect
the appliance from the electricity
supply or switch off the fuse in the
fuse box. Close the primary valve of
the gas supply.
Supply piping should not be less than
R3/8. Connection is made to the Rc
1/2 (1/2 “ B.S.P.) female threaded.
The entry pipe is located just below
the hob level on the rear left hand side
of the appliance.
The gas supply ramp is on the rear
side of the appliance.
WARNING! Only liquid sealants can
be used when the inlet gas pipe is
fitted i.e.: do not use the P.T.F.E.
sealant tape.
When the installation is complete,
carry out a gas tightness test and
make sure that the seal of each pipe
fitting does not leak.
Use flexible tubing, which comply with
the BS.669 current edition.
A
B
C
C
D
E
WARNING! The gas bayonet
connector must be in the marked area.
Dimension mm
A 250
B 680
C 50
D 250
E 580
PRESSURE TEST
The Rapid injector is used as a pressure test point.
1. Connect the pressure gauge to the Rapid
injector.
2. Examine the supply pressure by turning the
Rapid burner and one other burner fully on, and
21

Manual

View the manual for the Zanussi ZCG63040XA here, for free. This manual comes under the category stoves and has been rated by 1 people with an average of a 8.8. This manual is available in the following languages: English. Do you have a question about the Zanussi ZCG63040XA or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Zanussi and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Zanussi ZCG63040XA specifications

Below you will find the product specifications and the manual specifications of the Zanussi ZCG63040XA.

General
BrandZanussi
ModelZCG63040XA
Productstove
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Zanussi ZCG63040XA below.

Can I use my pans on induction?

Nowadays almost all pans are suitable for induction. You can easily test whether your old pans can also be used on induction by holding a magnet against the bottom of the pan. If the magnet stays on the pan, your old pan is suitable for induction.

How do I reset my induction hob?

Most induction hobs can be reset by disconnecting the hob from power by unplugging it from the power outlet. You will then have to wait at least 60 minutes.

What is a Perilex connection?

A Perilex connection is a special connection that can handle more power than a normal connection. This connection has five holes instead of two and is often used for induction hobs.

Is cooking on induction dangerous?

No, cooking on induction is not dangerous.

Is the manual of the Zanussi ZCG63040XA available in English?

Yes, the manual of the Zanussi ZCG63040XA is available in English .

Is your question not listed? Ask your question here

No results