Zanussi ZCG43200BA manual

Zanussi ZCG43200BA
7 · 1
PDF manual
 · 28 pages
English
manualZanussi ZCG43200BA

WARNING!

Only a qualified and competent
person can do the gas installation.
Before you connect te gas,
disconnect the appliance from the
electricity supply or switch off the
fuse in the fuse box. Close the
primary valve of the gas supply.
Supply piping should not be less
than R3/8. Connection is made to
the Rc 1/2 (1/2 “ B.S.P.) female
threaded. The entry pipe is located
just below the hob level on the rear
left hand side of the appliance.
The gas supply ramp is on the rear
side of the appliance.

WARNING!

Only liquid sealants can be used
when the inlet gas pipe is fitted i.e.:
do not use the P.T.F.E. sealant tape.
When the installation is complete,
carry out a gas tightness test and
make sure that the seal of each pipe
fitting does not leak.
Use flexible tubing, which comply
with the BS.669 current edition.
B
C
C
D
E
A

WARNING!

The gas bayonet connector must be
in the marked area.
Dimension mm
A 250
B 680
C 50
D 250
E 580

Pressure test

The Rapid injector is used as a pressure test
point.
1. Connect the pressure gauge to the Rapid
injector.
2. Examine the supply pressure by turning the
Rapid burner and one other burner fully on,
and lighting them. The pressure must be:
a) 20 mbar for Natural Gas
b) 29 mbar for LPG, butane only
c) 37 mbar for LPG, propane only.
3. Turn the taps off and disconnect the
pressure gauge.
4. Make sure that all burners work correctly.

Checking the hob burners

1. Lift the lid.
2. Put on the burner crowns and caps. Make
sure that they are correctly seated.
3. Put on the pan supports.
4. Light one of the hob burners.
To light the hob burner refer to the "Ignition
of the hob burners".
Check if the flame is regular.
Check each of the burners.
5. Turn the knob for the hob to the off position.

Checking the oven burners and the grill

1. Put in the deep pan and the trivet.
2. Light the oven burner.
To light the oven burner refer to the "Ignition
of the oven burners".
Check if the flame is regular.
Check each of the burners.
3. Turn the knob to the off position.

Checking the Lid Safety Device

1. Lift the lid.
2. Light one of the hob burners.

www.zanussi.com 23

Manual

View the manual for the Zanussi ZCG43200BA here, for free. This manual comes under the category stoves and has been rated by 1 people with an average of a 7. This manual is available in the following languages: English. Do you have a question about the Zanussi ZCG43200BA or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Zanussi and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Zanussi ZCG43200BA specifications

Below you will find the product specifications and the manual specifications of the Zanussi ZCG43200BA.

General
BrandZanussi
ModelZCG43200BA | 948 905 039
Productstove
EAN7332543291731
LanguageEnglish
FiletypeUser manual (PDF)
Design
Product typeFreestanding cooker
Product colorBlack
Control typeButtons, Rotary
Cord length1.6 m
Built-in displayYes
Oven
Number of ovens2
Total oven(s) interior capacity111 L
Total oven power- W
Oven power sourceNatural gas
Oven size-
Oven gross capacity77 L
Oven power- W
Noise level- dB
Cool doorYes
Oven net capacity77 L
Oven 2
Oven 2 gross capacity34 L
Oven 2 grillYes
Hob
Hob typeGas
Number of cooking zones4 zone(s)
Number of gas cooking zones4 zone(s)
Hob coverYes
Power
Energy efficiency classA
Energy consumption (conventional)1.73 kWh
Energy consumption (forced convection)- kWh
Energy consumption (conventional)6.23 MJ
Energy consumption (forced convection)- MJ
Weight & dimensions
Width550 mm
Depth600 mm
Height900 mm
Weight56500 g
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Zanussi ZCG43200BA below.

What is the weight of the Zanussi ZCG43200BA?

The Zanussi ZCG43200BA has a weight of 56500 g.

Can I use my pans on induction?

Nowadays almost all pans are suitable for induction. You can easily test whether your old pans can also be used on induction by holding a magnet against the bottom of the pan. If the magnet stays on the pan, your old pan is suitable for induction.

How do I reset my induction hob?

Most induction hobs can be reset by disconnecting the hob from power by unplugging it from the power outlet. You will then have to wait at least 60 minutes.

What is a Perilex connection?

A Perilex connection is a special connection that can handle more power than a normal connection. This connection has five holes instead of two and is often used for induction hobs.

Is cooking on induction dangerous?

No, cooking on induction is not dangerous.

What is the height of the Zanussi ZCG43200BA?

The Zanussi ZCG43200BA has a height of 900 mm.

What is the width of the Zanussi ZCG43200BA?

The Zanussi ZCG43200BA has a width of 550 mm.

What is the depth of the Zanussi ZCG43200BA?

The Zanussi ZCG43200BA has a depth of 600 mm.

What energy label does the Zanussi ZCG43200BA have?

The Zanussi ZCG43200BA has energy label A.

Is the manual of the Zanussi ZCG43200BA available in English?

Yes, the manual of the Zanussi ZCG43200BA is available in English .

Is your question not listed? Ask your question here

No results