Winora Pedelec manual

Winora Pedelec
7 · 3
PDF manual
 · 252 pages
English
manualWinora Pedelec

Cycle Maintenance

119

14.11.7 Fitting UST tyres

No separate inner tube is needed with UST (universal system tubeless) tyres.
The tyre and rim are connected in such a way that no air can escape.
UST tyres may only be used with a UST rim or a UST wheel.
Have UST tyres fitted by your dealer only. Do not fit UST tyres yourself
unless you have the necessary expertise.
x Only fit UST tyres by hand. Do not use a tyre lever.
x Remove dirt and lubricant before fitting. UST tyres must be free of dust and grease
inside and around the tyre bead.
x Moisten the tyre bead with soap or tyre fitting lubricant before fitting so as not to
damage the UST tyre.
1. Using your hands, press the UST tyre onto the rim from outside.
2. First lift one tyre bead completely over one rim flange, then the other.
3. Centre the UST tyre in the rim well.
4. Centre the valve between the tyre sidewalls.
5. Inflate the UST tyre to the maximum tyre pressure.
6. Check whether the UST tyre is correctly positioned using the fine witness line,
which must be an even distance from the rim all around the UST tyre.
x Use the valve to reduce the tyre pressure if necessary.

Manual

View the manual for the Winora Pedelec here, for free. This manual comes under the category bicycles and has been rated by 3 people with an average of a 7. This manual is available in the following languages: English. Do you have a question about the Winora Pedelec or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Winora and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Winora Pedelec specifications

Below you will find the product specifications and the manual specifications of the Winora Pedelec.

General
BrandWinora
ModelPedelec
Productbicycle
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Winora Pedelec below.

How do I remove rust from my Winora bicycle?

1. Soak the rusty part in vinegar until completely soaked through. 2. Let the vinegar work on the rust for 24 hours. 3. Remove the rust with a wire brush or aluminium foil.

How much should I exercise as an adult per week?

As an adult, it is recommended to do moderately intensive exercise for at least 2.5 hours per week. Preferably spread over several days.

How can I adjust the pedal assist level on my Winora Pedelec S-pedelec?

To adjust the pedal assist level on your Winora Pedelec S-pedelec, follow these steps: 1. Familiarize yourself with the pedal assist system on your Winora Pedelec. 2. Locate the control panel or display on your bike that allows you to adjust the pedal assist level. 3. Use the buttons or controls on the panel to increase or decrease the pedal assist level according to your preference. 4. Test ride the bike after adjusting the pedal assist level to ensure it meets your desired level of assistance. 5. If you are unsure about adjusting the pedal assist level, contact your dealer for assistance. Remember to always adjust the pedal assist level safely and according to your riding needs.

How do I adjust the seat height on the Winora Children’s bike?

To adjust the seat height on the Winora Children’s bike, follow these steps: 1. If your bike has a seat post clamp with a clamp bolt: - Hold the saddle firmly and loosen the clamp bolt by turning it anticlockwise. - Pull the seat post out to the desired height, following the minimum insertion depth and pull-out height specifications. - Tighten the clamp bolt by turning it clockwise to secure the seat post clamp. - Check that the saddle is correctly positioned and does not twist. 2. If your bike has a seat post clamp with a quick release: - Hold the saddle firmly and pull the quick-release lever outwards. - Pull the seat post out to the desired height, following the minimum insertion depth and pull-out height specifications. - Secure the seat post clamp by pushing the quick-release lever inwards until it touches the seat tube. - Check that the saddle is correctly positioned and does not twist.

What should I do if the brakes on the Winora Children’s bike feel loose?

To address loose brakes on the Winora Pedelec bicycle, follow these steps: 1. Adjust the brake cable tension in mechanical brakes: - Loosen the lock nut by turning it anticlockwise. - Gradually turn the knurled screw anticlockwise to increase the cable tension until the distance between the brake block holders and the rim is 1–2 millimeters on each side. - Ensure that the brake block holders meet the rim simultaneously on both sides and that the wheel turns smoothly. - Tighten the lock nut by turning it clockwise. 2. Adjust the pressure point in hydraulic brakes: - Locate the pressure point adjustment screw on the brake lever. - Gradually turn the adjustment screw until the distance between the rim and each brake pad is 1–2 millimeters. - Ensure that the brake block holders meet the rim simultaneously on both sides and that the wheel turns smoothly.

Is the manual of the Winora Pedelec available in English?

Yes, the manual of the Winora Pedelec is available in English .

Is your question not listed? Ask your question here

No results