Winegard AP8700 manual

Winegard AP8700
7.8 · 2
PDF manual
 · 2 pages
English
manualWinegard AP8700
Fig. 2
Fig. 1
Fig. 3
SINGLE INPUT MODELS

Chromstar

®

2000

Antenna Preamplifiers

INSTRUCTIONS
Models AP-2870 & AP-2880 Dual Input, 82 Channel
Models AP-8275, AP-8700 & AP-8780, 8800, & HDP-269 82 Channel
Models AP-4700 & AP-4800 UHF Only
Models AP-3700 & AP-3800 VHF Only
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE POWER SUPPLY SECTION OF THIS
APPLIANCE TO RAIN OR MOISTURE.
NOTE
If FM interference is a problem in your area, it is
recommended that you temporarily hook up the pre-
amplifier near the TV for ease of tuning the variable FM
trap.
NOTE
The further the preamplifier from the antenna(s), the
lower the input signal.
STEP 2: Slide weather boots over the antenna downlead(s) and
attach connectors. See Figure 2.
STEP 3: Attach the antenna downlead(s) to antenna(s) and other
end(s) to preamplifier, leaving a sufficient slack in the cable(s) to
form a drain loop. See Figure 3.
STEP 4: Slide the weather boots over the cable connector(s) and
boot collar(s) on the preamplifier and antenna(s).
STEP 5: The 75 ohm coaxial downlead may be secured to the
mast by taping or the use of stand-off insulators.
STEP 6. Attach “F” connector on downlead cable to power
injector jack marked “ANTENNA”. See figure 4.
STEP 7. Attach “F” connector on cable to analog TV/DTV
receivers to jack marked “TV”. See figure 4.
STEP 8. Connect one “F” connector on supplied black RG-6
cable to jack marked “PWR IN”. Connect the other “F”
connector on supplied RG-6 cable to jack on supplied AC
wall transformer. See Figure 4.
STEP 9. Mount power injector to wall using supplied screws.
Plug in AC wall transformer to household wall outlet.
PREAMPLIFIER INSTALLATION
STEP 1: Mount the preamplifier on the mast within easy reach.
See Figure 1.
MADE IN U.S.A.

WINEGARD

®
SUPPORT
PLATE
HEX NUT
MAST
U-BOLT
300 OHM DOWNLEAD
HOUSING
PREAMPLIFIER
PREAMPLIFIER
MAST
CLAMP
TO POWER
SUPPLY
75 OHM COAXIAL
DOWNLEAD
DRAIN LOOP
ANT.
INPUT
75 OHM COAXIAL
DOWNLEAD
TO POWER
SUPPLY
MAST
CLAMP
PREAMPLIFIER
UHF
INPUT
DRAIN LOOP
VHF
INPUT
CONNECTORS
WEATHER
BOOTS
DUAL INPUT MODELS
Fig. 4
AC Adapter/ Wall Transformer
$
1
7
(
1
1
$
7
9
3
2
:
(
5
$17(11$
79
32:(5
Coax Cable
(To Preamp or
Amplified Antenna)
Coax Cable
(To TV)
Power Injector
6’ Standard
Coax Cable

Manual

View the manual for the Winegard AP8700 here, for free. This manual comes under the category TV signal amplifiers and has been rated by 2 people with an average of a 7.8. This manual is available in the following languages: English. Do you have a question about the Winegard AP8700 or do you need help? Ask your question here

Need help?

Do you have a question about the Winegard AP8700 and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Winegard AP8700 owners to provide you with a good answer.

jerry • 8-4-2020 No comments

yes

Answer this question

Number of questions: 1

Winegard AP8700 specifications

Below you will find the product specifications and the manual specifications of the Winegard AP8700.

General
Brand Winegard
Model AP8700
Product TV signal amplifier
EAN 615798100186, 0615798100186
Language English
Filetype Usermanual (PDF)
Technical details
Noise figure 2.8 dB
Gain 19 dB
Frequency range 88 - 108 MHz
Product colour Black
Power
Input voltage 120 V
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Winegard AP8700 below.

Is your question not listed? Ask your question here

No results