Whirlpool WTW5057LW manual

Whirlpool WTW5057LW
8.7 · 10
PDF manual
 · 21 pages
English
manualWhirlpool WTW5057LW
15

Pièces nécessaires : (si non fournies avec la

laveuse)

Tuyaux d’arrivée d’eau avec
rondelles plates.
REMARQUE: Différentes
options de tuyau d’arrivée
d’eau sont offertes; consulter
votre guide de démarrage
rapide pour les informations de
commande.

Pièces alternatives : (non fournies avec la

laveuse)

Il se peut que l’installation nécessite des pièces supplémentaires.
Pour commander, consulter les coordonnées indiquées dans le
guide de démarrage rapide.
Si vous avez : Il faut :
Égout surélevé
Tuyau rigide d’évacuation standard de
20 gallon (76 L) de 39 po (990 mm) de
haut ou évier de décharge, pompe de
puisard et connecteurs (disponibles
chez les vendeurs de matériel de
plomberie locaux)
Tuyau de rejet à l’égout
de 1 po (25 mm)
Adaptateur de 2 po (51 mm) à 1 po (25
mm) de diamètre pour le tuyau rigide de
rejet à l’égout et ensemble de
raccordement
Tuyau de vidange trop
court
Rallonge de tuyau de vidange et
ensemble de raccordement
Système d’évacuation
obstrué par de la
charpie
Protecteur de canalisation et ensemble
de raccordement

Exigences d’emplacement

Le choix d’un emplacement approprié pour la laveuse en améliore
le rendement et réduit au minimum le bruit et le “déplacement”
possible de la laveuse. La laveuse peut être installée dans un
sous-sol, une salle de buanderie, un placard ou un encastrement.
IMPORTANT: Ne pas installer, remiser ou faire fonctionner la
laveuse à un emplacement elle sera exposée aux intempéries
ou à des températures inférieures à 32 °F (0 °C). De l’eau restée
dans la laveuse après utilisation peut causer des dommages à
basse température. Voir la section « Entretien et réparation de la
laveuse » pour des renseignements sur la préparation de la
laveuse pour l’hiver.
C’est à l’utilisateur qu’incombe la responsabilité de réaliser une
installation correcte.
Il vous faudra :
Un chauffe-eau réglé à 120 °F (49 °C).
Une prise électrique reliée à la terre et située à moins de 4
pies (1,2 m) du cordon d’alimentation situé à l’arrière de la
laveuse.
Des robinets d’eau chaude et d’eau froide situés à moins de 3
pies (0,9 m) des électrovannes de remplissage d’eau chaude
et d’eau froide situées sur la laveuse et une pression d’eau de
20-100 lb/po² (138 à 690 kPa).
Un plancher de niveau avec une pente maximale de 1 po (25
mm) sous l’ensemble de la laveuse. Il n’est pas recommandé
de l’installer sur un tapis, de la moquette ou des surfaces avec
endos en mousse.
Un plancher capable de supporter le poids total de 315 lb (143
kg) de la laveuse (eau et charge comprises).

Installation dans un encastrement ou placard

REMARQUE: Toutes les laveuses de 27 po de large devraient
avoir un dégagement de 19 po, alors que les laveuses de 29 po
devraient avoir un dégagement de 22 po.
Toutes les dimensions représentent les dégagements
recommandés permis, hormis pour les ouvertures de ventilation
de la porte de l’armoire qui correspondent aux dimensions
minimales nécessaires. Cette laveuse a été testée pour une
installation avec dégagement de 0 po (0 mm) sur les côtés. On
peut éventuellement laisser davantage de dégagement pour
faciliter l’installation et l’entretien, ainsi que des distances de
séparation pour les appareils ménagers voisins et des
dégagements pour les murs, portes et plinthes. Ajouter un espace
supplémentaire de 1 po (25 mm) de tous les côtés de la laveuse
pour réduire le transfert de bruit. Si l’on installe une porte de
placard ou une porte à persiennes, des ouvertures d’aération au
sommet et au bas de la porte sont nécessaires.
*Pour obtenir plus de détails (ou d’informations) spécifiques à
votre modèle, consulter votre guide de démarrage rapide.

Système de vidange

Le système de vidange de la laveuse peut être installé à l’aide
d’un conduit d’évacuation au plancher, un tuyau de rejet à l’égout
au plancher ou mural ou un évier de buanderie. Sélectionner la
méthode à utiliser.
IMPORTANT: Pour éviter un effet de siphon, ne pas introduire
plus de 4,5 po (114 mm) de tuyau de vidange à l’intérieur du tuyau
de rejet à l’égout ou sous la partie supérieure d’évier de
buanderie. Immobiliser le tuyau de vidange avec un attache-
câble.

Système de vidange avec tuyau de rejet à l’égout

au plancher

View the manual for the Whirlpool WTW5057LW here, for free. This manual comes under the category washing machines and has been rated by 10 people with an average of a 8.7. This manual is available in the following languages: English. Do you have a question about the Whirlpool WTW5057LW or do you need help? Ask your question here

Need help?

Do you have a question about the Whirlpool and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 253
P
Pete AtkinsonJuly 12, 2023

Is it normal at first to have a grinding sound at the first soak cycle when the agitator moves? How to balance, the tub bounces around when water going out?

B
BobbyJuly 15, 2023

How do we use our warranty on these? This machine clicks and makes a sound and switches to done

B
Brad Markell July 16, 2023

How THE HELL am I supposed to add the bleach? Are you saying I can’t use soap and bleach together?

J
JudyJuly 30, 2023

After being away, I ran my washer. After it finished, I remembered I never turned the water on. Will that do something to the washer?

J
Jeff NeelyAugust 13, 2023

Washer seems to be stuck in cycle, it is full of clothes with water and stop. It will not start. Is there a reset? What can I do

K
KellyAugust 15, 2023

I just purchased the whirlpool 2 in 1 agitator. I started the washer on bulky cycle and came back a couple hours later and it was doing nothing with water sitting in the drum. It showed done on the screen and sensor was flashing. I tried doing drain and spin and that did not work. I have tried unplugging it and that did not work. What do I need to do to get the water out?

R
Rita SmithNovember 3, 2023

I normally use normal cycle but the clothes are still pretty wet at cycle end so I have to switch over to drain and spin cycle Is this normal for this machine?

O
Olliver LarsonJanuary 7, 2024

How does one operate it how do you fill the machine how do you set the machine on the size of load that you want to wash how do you set the water temperature?

G
Gary HileJanuary 12, 2024

We need to use an additive for a Laundry Sanitizer in the Rinse Cycle. How do we make that happen during the laundry cycle.

1 comment
G
Gary HileJanuary 12, 2024

Whirlpool states that a fabric softener Ball is the only way to get the product into the rinse cycle.

W
Wendy February 6, 2024

Sometimes I just want to rinse and spin only and I see that cycle on my machine so wondering if it had it and I’m missing it

The Whirlpool WTW5057LW is a washing machine that is manufactured by Whirlpool, a renowned company in the home appliance industry. It is designed to effectively clean and remove dirt from various types of laundry. The washing machine has a capacity of X pounds, allowing users to wash a decent amount of clothes in a single cycle. Equipped with a X-horsepower motor, the Whirlpool WTW5057LW provides sufficient power to agitate clothes and remove stubborn stains. It features X wash cycles, including delicate, normal, and heavy-duty, to cater to different washing needs. The machine also offers X water temperature settings, allowing users to customize the washing process according to their preferences and garment requirements. The Whirlpool WTW5057LW is designed to be user-friendly, with a control panel that is easy to navigate. It has a clear and bright display, which makes it convenient for users to select their desired settings. The washing machine also features a programmable timer, which enables users to delay the start of a washing cycle to fit their schedule. In terms of energy efficiency, the Whirlpool WTW5057LW has a X-star energy rating, ensuring that it consumes less electricity and water compared to traditional washing machines. This not only helps users save on utility bills but also contributes to reducing environmental impact. Overall, the Whirlpool WTW5057LW is a reliable and durable washing machine that offers a range of features to effectively clean clothes.

General
BrandWhirlpool
ModelWTW5057LW
Productwashing machine
LanguageEnglish
FiletypeUser manual (PDF), Quickstart Guide (PDF), Safety instructions (PDF), Energy label (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool WTW5057LW below.

What temperature should I use for my laundry?

The washing label of your garment shows the recommended washing temperature.

Do I need to use an anti-scaling agent for my washing machine?

It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.

How do I prevent my washing machine from smelling?

Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.

Why is the washing machine not starting?

Make sure the power cord is securely plugged into a grounded outlet and try pressing the "Start" button again. Also, ensure that the lid is closed properly, as the machine will not start if the lid is open.

Why is the water not filling the machine?

Check that the water supply valves are fully open. Additionally, inspect the water inlet hoses for any kinks or clogs that might be blocking water flow. It's recommended to use a cold water supply for optimal performance.

How do I adjust the water level for different load sizes?

To adjust the water level, simply rotate the "Load Size" selector knob to the desired setting. Larger load sizes may require higher water levels, while smaller loads can be washed with lower water levels. Remember to distribute the clothes evenly in the drum.

Why is the washing machine not draining properly?

First, ensure that the drain hose is not kinked or blocked. If the drain hose is clear, check if the drain pump filter is clogged with lint or debris. Clean the filter if necessary. Additionally, verify that the drain hose is installed correctly at the appropriate height, as incorrect positioning may impact draining.

How do I resolve excessive vibration during the spin cycle?

Check if the washer is level by adjusting the feet underneath. Make sure all four feet are in firm contact with the floor. Uneven load distribution can also cause excessive vibration, so try redistributing clothes inside the drum. Finally, avoid overloading the machine, as this can disrupt balance and result in increased vibration.

Is the manual of the Whirlpool WTW5057LW available in English?

Yes, the manual of the Whirlpool WTW5057LW is available in English .

Is your question not listed? Ask your question here

No results