Whirlpool WTW5015LW manual

Whirlpool WTW5015LW
9 · 2
PDF manual
 · 24 pages
English
manualWhirlpool WTW5015LW
18

Raccordement du tuyau de vidange

5. Fixation du tuyau de vidange à l’orifice de

vidange

Le cas échéant, retirer le bouchon en plastique rouge de
l’orifice de vidange noir situé à l’arrière de la laveuse.
Si la bride n’est pas déjà installée sur l’extrémité coudée du
tuyau de vidange, la faire glisser sur l’extrémité tel qu’indiqué.
Pour un évier de buanderie ou un tuyau de rejet à l’égout
rigide, passer à l’étape 6.
Pour une vidange au plancher, retirer la bride de retenue pour
tuyau de vidange préinstallée tel qu’indiqué à l’étape 7. Des
pièces supplémentaires avec des instructions distinctes
s’avèreront peut-être nécessaires. Voir la section « Pièces
supplémentaires ».

6. Placer le tuyau de vidange dans le tuyau de

rejet à l’égout

IMPORTANT : 4,5 po (114 mm) de tuyau de vidange soit se
trouver à l’intérieur du tuyau de rejet à l’égout; ne pas forcer
l’excédent de tuyau dans le tuyau de rejet à l’égout ni le
placer dans l’évier de buanderie. Un collet du tuyau de
vidange doit être utilisé.
On doit utiliser la bride de retenue pour tuyau de vidange.
Placer le tuyau dans le tuyau de rejet à l’égout (illustré à
l’image) ou par-dessus le côté de l’évier de buanderie.

7. Enlever la bride de retenue pour tuyau de

vidange (installations avec vidange au

plancher seulement)

Pour les installations avec vidange au plancher, il faut retirer
la bride de retenue pour tuyau de vidange de l’extrémité du
tuyau de vidange. Des pièces supplémentaires avec des
directives distinctes seront peut-être nécessaires. Voir la
section « Outils et pièces ».
Il incombe à l’installateur d’installer et de fixer solidement le
tuyau de vidange à la canalisation d’évacuation de manière
que le tuyau de vidange ne puisse sortir et causer
d’éventuelles fuites de la canalisation d’évacuation.

Raccordement des tuyaux

d’alimentation

La laveuse doit être raccordée aux robinets d’eau à l’aide des
tuyaux d’arrivée d’eau et des rondelles neufs (non compris). Ne
pas utiliser de tuyaux usagés.
REMARQUE : Les deux tuyaux doivent être fixés et l’eau doit
pénétrer dans les robinets d’arrivée d’eau. Si l’on effectue un
raccordement uniquement à un robinet d’eau froide, on doit
utiliser un adaptateur en Y (non fourni).

8. Connecter les tuyaux d’arrivée d’eau aux

robinets

IMPORTANT : Ne pas trop serrer le tuyau, utiliser du ruban
ou appliquer du calfeutrant sur le robinet. Cela pourrait
endommager le robinet.
Fixer le tuyau au robinet d’eau chaude. Visser le raccord à la
main pour qu’il repose sur la rondelle. Serrer les raccords de
deux tiers de tour supplémentaires à l’aide d’une pince.
Répéter cette étape avec le deuxième tuyau pour le robinet
d’eau froide.

View the manual for the Whirlpool WTW5015LW here, for free. This manual comes under the category washing machines and has been rated by 2 people with an average of a 9. This manual is available in the following languages: English. Do you have a question about the Whirlpool WTW5015LW or do you need help? Ask your question here

Need help?

Do you have a question about the Whirlpool and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 46
D
DianaOctober 19, 2022

How do operate the washer? I can't seem to get to the wash. cycle

2 comments
E
Emma of manua.lsOctober 25, 2023

To use the Whirlpool WTW5015LW washing machine and access the wash cycle, follow these steps: 1. Cleaning the dispensers: - For dispensers that cannot be removed, wipe them with an affresh® Machine Cleaning Wipe or a damp cloth and then dry with a towel. - For removable dispensers, take out the drawer (if applicable) and clean it with an affresh® Machine Cleaning Wipe or a damp cloth before or after running the Clean Washer cycle. 2. Cleaning the outside of the washer: - Use an affresh® Machine Cleaning Wipe, a soft damp cloth, or a sponge to wipe away any spills. - Avoid using abrasive products to prevent damaging the washer's finish. 3. Operating the washer: - Plug the washer into a grounded 3-prong outlet. - Do not remove the ground prong or use an adapter or extension cord. - Flush water pipes and hoses before using the washer again. - Reconnect water inlet hoses and turn on both water faucets. - Select the desired wash cycle according to the online Cycle Guide for your specific model. - Use only HE (High Efficiency) detergent and follow the manufacturer's recommended amount for a medium-size load.

This answer is automatically generated
T
TimSeptember 21, 2023

Did you ever figure it out? I have the same problem.

R
Rachel September 1, 2022

Is there a reset button ? I even tried to run the clean machine and ask it does is click

G
GwenOctober 29, 2022

The model has a d on the end. I can’t get the washer to start. It’s filled with water

D
Donna L MeckfesselJune 18, 2023

Why do my dark clothes have a white residue on them? I don't add too much detergent. It happens with liquid and the pods.

T
TanyaJuly 1, 2023

How can I keep the water filling up with the lid open? I like to add my detergent and add water to get soapy before I adding the clothes. With the lid lock option on, everytime I open the lid water drains out.

F
Fitzhugh Havens August 14, 2023

No instructions how to start the washer,I push the button to turn it on,then push and hold the start button until my thumb hurts and nothing happens.

2 comments
T
TimSeptember 21, 2023

Did you ever figure it out?I have the same problem.

C
Carol RossNovember 23, 2023

same

K
KathySeptember 5, 2023

Why does it take so long to wash a load? I'm a single person who only has small loads. I put it on Sense. It takes at least an hour to complete. How is this high efficiency?

M
Milicent December 6, 2023

The following lights are flaahing simultaneously Sense and Lid then Soak and Wash. What needs to be done to fix this problem?

S
Sharon Bagwell December 26, 2023

If you need to open the door of the washer after it’s started and it has locked how do you do that?

M
Maria ValadezApril 9, 2024

My washer machine is new one and the rinse switch is not working, what can I do, do I need to report to the company ?

The Whirlpool WTW5015LW washing machine is a standard top-loading unit that measures 27.5 x 26 x 42 inches and has a total capacity of 3.5 cubic feet. It comes equipped with 9 different washing cycles, including a deep-water wash cycle that allows users to customize the amount of water used for each load. The machine also features a heavy-duty agitator, which helps to remove tough stains and dirt from clothing and linens. This machine uses an impeller-type washing system, which is designed to be gentler on fabrics and more efficient at getting clothes clean. The unit includes a variety of different temperature settings, including hot, warm, and cold, allowing users to customize the wash to their specific needs. The Whirlpool WTW5015LW also features a number of other useful features, including a delay start option, which lets users program the machine to start washing at a later time. Additionally, this machine features a clean washer cycle, which helps to remove any built-up residue or odors that may be present inside the unit. Overall, the Whirlpool WTW5015LW is a reliable and efficient washing machine that offers a variety of useful features for users looking to get their laundry done quickly and efficiently.

General
BrandWhirlpool
ModelWTW5015LW
Productwashing machine
EAN883049604725
LanguageEnglish
FiletypeUser manual (PDF), Energy label (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool WTW5015LW below.

What temperature should I use for my laundry?

The washing label of your garment shows the recommended washing temperature.

Do I need to use an anti-scaling agent for my washing machine?

It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.

How do I prevent my washing machine from smelling?

Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.

Why is my washing machine not turning on?

Check if the power cord is properly plugged into the electrical outlet and ensure there is power supply. Additionally, ensure the lid is closed properly as some models may not start if the lid is not securely latched.

Why is my washing machine not filling with water?

Make sure the water supply faucets are fully turned on. Inspect the water hose connections at the back of the machine to ensure they are securely attached. Also, verify that the water inlet valve screens are not clogged.

My washing machine is not draining properly, what could be the cause?

Check if the drain hose is correctly installed, ensuring it is not kinked, twisted, or clogged. Ensure that the pump filter is clean and free from debris. Also, verify that the drain hose is not inserted too far into the standpipe, as this can cause siphoning.

Why is my washing machine not spinning during the cycle?

Ensure the load is properly balanced inside the drum. Large and heavy items may cause an imbalance, resulting in the machine not spinning. Additionally, check if the lid is closed tightly, as some models have a safety feature that stops spinning if the lid is not secure.

My clothes are not getting cleaned properly, what should I do?

Confirm that you are using the recommended amount of detergent according to the load size and soil level. Make sure the selected wash cycle is appropriate for the type of garments you are washing. Consider sorting the laundry by fabric type and adjust the water temperature setting accordingly.

Is the manual of the Whirlpool WTW5015LW available in English?

Yes, the manual of the Whirlpool WTW5015LW is available in English .

Is your question not listed? Ask your question here

No results