Whirlpool WTW5010LW manual

Whirlpool WTW5010LW
8.7 · 6
PDF manual
 · 21 pages
English
manualWhirlpool WTW5010LW
15

Pièces nécessaires : (si non fournies avec la

laveuse)

Tuyaux d’arrivée d’eau avec
rondelles plates.
REMARQUE: Différentes
options de tuyau d’arrivée
d’eau sont offertes; consulter
votre guide de démarrage
rapide pour les informations de
commande.

Pièces alternatives : (non fournies avec la

laveuse)

Il se peut que l’installation nécessite des pièces supplémentaires.
Pour commander, consulter les coordonnées indiquées dans le
guide de démarrage rapide.
Si vous avez : Il faut :
Égout surélevé
Tuyau rigide d’évacuation standard de
20 gallon (76 L) de 39 po (990 mm) de
haut ou évier de décharge, pompe de
puisard et connecteurs (disponibles
chez les vendeurs de matériel de
plomberie locaux)
Tuyau de rejet à l’égout
de 1 po (25 mm)
Adaptateur de 2 po (51 mm) à 1 po (25
mm) de diamètre pour le tuyau rigide de
rejet à l’égout et ensemble de
raccordement
Tuyau de vidange trop
court
Rallonge de tuyau de vidange et
ensemble de raccordement
Système d’évacuation
obstrué par de la
charpie
Protecteur de canalisation et ensemble
de raccordement

Exigences d’emplacement

Le choix d’un emplacement approprié pour la laveuse en améliore
le rendement et réduit au minimum le bruit et le “déplacement”
possible de la laveuse. La laveuse peut être installée dans un
sous-sol, une salle de buanderie, un placard ou un encastrement.
IMPORTANT: Ne pas installer, remiser ou faire fonctionner la
laveuse à un emplacement elle sera exposée aux intempéries
ou à des températures inférieures à 32 °F (0 °C). De l’eau restée
dans la laveuse après utilisation peut causer des dommages à
basse température. Voir la section « Entretien et réparation de la
laveuse » pour des renseignements sur la préparation de la
laveuse pour l’hiver.
C’est à l’utilisateur qu’incombe la responsabilité de réaliser une
installation correcte.
Il vous faudra :
Un chauffe-eau réglé à 120 °F (49 °C).
Une prise électrique reliée à la terre et située à moins de 4
pies (1,2 m) du cordon d’alimentation situé à l’arrière de la
laveuse.
Des robinets d’eau chaude et d’eau froide situés à moins de 3
pies (0,9 m) des électrovannes de remplissage d’eau chaude
et d’eau froide situées sur la laveuse et une pression d’eau de
20-100 lb/po² (138 à 690 kPa).
Un plancher de niveau avec une pente maximale de 1 po (25
mm) sous l’ensemble de la laveuse. Il n’est pas recommandé
de l’installer sur un tapis, de la moquette ou des surfaces avec
endos en mousse.
Un plancher capable de supporter le poids total de 315 lb (143
kg) de la laveuse (eau et charge comprises).

Installation dans un encastrement ou placard

REMARQUE: Toutes les laveuses de 27 po de large devraient
avoir un dégagement de 19 po, alors que les laveuses de 29 po
devraient avoir un dégagement de 22 po.
Toutes les dimensions représentent les dégagements
recommandés permis, hormis pour les ouvertures de ventilation
de la porte de l’armoire qui correspondent aux dimensions
minimales nécessaires. Cette laveuse a été testée pour une
installation avec dégagement de 0 po (0 mm) sur les côtés. On
peut éventuellement laisser davantage de dégagement pour
faciliter l’installation et l’entretien, ainsi que des distances de
séparation pour les appareils ménagers voisins et des
dégagements pour les murs, portes et plinthes. Ajouter un espace
supplémentaire de 1 po (25 mm) de tous les côtés de la laveuse
pour réduire le transfert de bruit. Si l’on installe une porte de
placard ou une porte à persiennes, des ouvertures d’aération au
sommet et au bas de la porte sont nécessaires.
*Pour obtenir plus de détails (ou d’informations) spécifiques à
votre modèle, consulter votre guide de démarrage rapide.

Système de vidange

Le système de vidange de la laveuse peut être installé à l’aide
d’un conduit d’évacuation au plancher, un tuyau de rejet à l’égout
au plancher ou mural ou un évier de buanderie. Sélectionner la
méthode à utiliser.
IMPORTANT: Pour éviter un effet de siphon, ne pas introduire
plus de 4,5 po (114 mm) de tuyau de vidange à l’intérieur du tuyau
de rejet à l’égout ou sous la partie supérieure d’évier de
buanderie. Immobiliser le tuyau de vidange avec un attache-
câble.

Système de vidange avec tuyau de rejet à l’égout

au plancher

View the manual for the Whirlpool WTW5010LW here, for free. This manual comes under the category washing machines and has been rated by 6 people with an average of a 8.7. This manual is available in the following languages: English. Do you have a question about the Whirlpool WTW5010LW or do you need help? Ask your question here

Need help?

Do you have a question about the Whirlpool and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 79
M
Mike MermelsteinDecember 29, 2022

Where should I pour my fabric softener in this model?

This message has been automatically translated
4 comments
E
Emma of manua.lsOctober 24, 2023

You can put fabric softener in the Whirlpool WTW5010LW washing machine by following these steps: 1. Open the washer lid and remove any clothing or items. 2. Place the fabric softener in the designated fabric softener dispenser. 3. Close the washer lid. 4. Select the desired wash cycle and start the machine.

This answer is automatically generated
L
Linda ThomasApril 6, 2023

where do i put my fabric softner

L
Linda TrimbleJune 9, 2023

Since no manual came with the washer, I cannot find where the fabric softner goes.

E
elliJune 11, 2024

hello, the washer only soaks, but doesn’t complete the cycle. it’s a wtw5010lw0 type 589-20

H
Heidi A GambacciniJune 11, 2024

how do I open the washer to add laundry I've forgotten once Ive started machine?

T
Tony AmitranoMay 11, 2024

The Cycle Modifiers have a "faucet" selection to run water. Can I change the water to be used to a certain temperature setting or will it always use a set water temp? If set, is it Hot or Cold water inlet selected?

L
Larry PattonMarch 20, 2022

Machine’s on and off button and hold to start button do not work. I press them and nothing happens. Other lights are working so the power is on.

D
Dorinda A StewartAugust 28, 2022

What are the recommendations for the amount of clothing, towels, sheets, etc. that can be safely put in the machine?

R
Ray BoldosserNovember 18, 2022

Washer drains upward to sewer connection approximately 6 feet. The installer looped (in a circle) the drain hose just behind the washer discharge and placed the hose in an extension hose that feeds into the outside sewer connection. That top section of hose does have a "question mark" type hook end (like a small case f) that is inserted to the outside drain. I am being told by the store that a "loop" near the bottom discharge connection is needed as an air pocket similar to what is found on a kitchen sink drain. Is that the proper installation, or can I just do a straight connection into the second part of the discharge line? Installers have been out twice as the hose once popped off, and several weeks later the bottom hose wore through where it was looped. I'm trying to avoid flooding the laundry room for the third time. :)

A
Amy jonesDecember 15, 2022

I can’t get my washer to start. Some of the lights will flash, but nothing happens.

I can’t get my washer to start. Some of the lights will flash, but nothing happens.
zoom-in
View photo
B
Brian WilsonDecember 24, 2022

Is there a final rinse alert on this model for the final rinse? We are having a hard to catching it at the right time to add fabric softener

1 comment
T
Teresa Campbell June 10, 2024

@Brian Wilson Me, too!

J
Judy WilsonApril 30, 2023

Wash cycle times,capacities,usuage. How long does the “quick wash” take vs the normal. How long and when used is the drain and spin cycle? Just bought washing machine…want to use correctly. Thanks.

The Whirlpool WTW5010LW is a washing machine that offers efficient and reliable performance. Designed to handle various laundry loads, this washer is equipped with a spacious drum that can accommodate large items such as bedding and towels. With its multiple wash cycles and options, users can select the appropriate settings for their specific needs. Featuring a top-loading design, the WTW5010LW has a generous capacity, allowing users to wash more laundry in one go. The machine also incorporates a number of advanced features, including a high-efficiency impeller that thoroughly cleans clothes while using less water and energy. This ensures that clothes are not only cleaned effectively but also helps save on utility bills. The washer also comes with a variety of convenient features such as a delay start option, which allows users to set the machine to start at a later time. This feature is particularly useful for busy households with varying schedules. In addition, the WTW5010LW boasts a durable construction, ensuring that it can withstand regular use over time. Its sleek and modern design adds a touch of style to any laundry room, while its quiet operation minimizes noise disruption. Overall, the Whirlpool WTW5010LW is a reliable and efficient washing machine that offers convenient features and delivers exceptional cleaning results.

General
BrandWhirlpool
ModelWTW5010LW
Productwashing machine
EAN883049604817
LanguageEnglish
FiletypeUser manual (PDF), Quickstart Guide (PDF), Energy label (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool WTW5010LW below.

What temperature should I use for my laundry?

The washing label of your garment shows the recommended washing temperature.

Do I need to use an anti-scaling agent for my washing machine?

It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.

How do I prevent my washing machine from smelling?

Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.

Why is my washing machine not turning on?

Check if the power cord is securely plugged into a functioning electrical outlet and if the circuit breaker has not tripped.

Why is my washing machine not filling with water?

Ensure that both the hot and cold water supply faucets are fully turned on and that the water inlet hoses are not kinked or clogged.

How can I resolve excessive vibrations during the spin cycle?

Make sure the washing machine is properly leveled on a sturdy surface and that the load inside the drum is balanced.

Why is my washing machine not draining water after a cycle?

Verify that the drain hose is not kinked or blocked, and that the drain hose is inserted at the correct height to allow for proper drainage.

What should I do if my clothes come out still wet after a completed cycle?

Check if the spin speed was set appropriately for the load size and if the wash cycle selected includes a high-speed spin. Additionally, the washer's drain pump filter may need to be cleaned if it is clogged.

Is the manual of the Whirlpool WTW5010LW available in English?

Yes, the manual of the Whirlpool WTW5010LW is available in English .

Is your question not listed? Ask your question here

No results