View the manual for the Whirlpool WRX735SDH here, for free. This manual comes under the category refrigerators and has been rated by 1 people with an average of a 7.3. This manual is available in the following languages: English. Do you have a question about the Whirlpool WRX735SDH or do you need help? Ask your question here
| Brand | Whirlpool |
| Model | WRX735SDH |
| Product | refrigerator |
| Language | English |
| Filetype | Installation Guide (PDF), Use and Care Manual (PDF), Datasheet (PDF), Energy label (PDF) |
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool WRX735SDH below.
There may be various causes for this, it is recommended to check the following: - Is the drain hole free of dirt? - Does the refrigerator door close properly? - Is the refrigerator not too full so that air can circulate properly? - Is the temperature not set below 5 degrees?
A common method for solving the problem of a smelly fridge is to pour vinegar into the drain and temporarily place a cup of vinegar in the fridge.
A minimum of 2.5 centimetres of free space around the fridge is needed to ventilate properly.
R-410A is a refrigerant used in machines that cool to zero degrees Celsius.
To prime the water filter in the Whirlpool WRX735SDH refrigerator, follow these steps: 1. Locate the water filter in the top-right corner of the refrigerator compartment. 2. Lift open the filter cover door to release the filter and allow it to eject as the door is opened. 3. When the door is completely open, pull the filter straight out. Note that there may be some water in the filter, so be prepared for spills and use a towel to wipe up any spills. 4. Take the new filter out of its packaging and remove the covers from the O-rings. Ensure that the O-rings are still in place after removing the covers. 5. With the arrow on the filter pointing up, align the new filter with the filter housing and slide it into place. The filter cover door will automatically begin to close as the new filter is inserted. 6. Close the filter cover door completely to snap the filter into place. You may need to apply some pressure. 7. Flush the water system. Refer to the "Water and Ice Dispensers" section in the manual for detailed instructions on how to flush the water system. Following these steps will ensure that the water filter in your Whirlpool WRX735SDH refrigerator is properly primed and ready to use.
If there is still air in the water system after priming the water filter in the Whirlpool WRX735SDH refrigerator, you can follow these steps: 1. Use a sturdy container and press on the water dispenser paddle for 5 seconds. 2. Release the dispenser paddle for 5 seconds. 3. Repeat steps 1 and 2 until water starts to flow. 4. Once water starts to flow, continue pressing and releasing the dispenser paddle (press for 5 seconds, release for 5 seconds) until a total of 3 gallons (12 liters) of water has been dispensed. These steps will help remove any remaining air from the water system and ensure a steady flow of water from the dispenser.
To move and install the Whirlpool WRX735SDH refrigerator and avoid excessive weight, it is recommended to have at least two people. Follow these steps: 1. Ensure that both people are wearing appropriate footwear and have a firm grip on the refrigerator. 2. Open the refrigerator doors and remove any items from inside. 3. Unplug the refrigerator from the power source. 4. Carefully tilt the refrigerator backward, keeping a firm grip on the sides. 5. Lift the refrigerator, using your legs and not your back, and move it to the desired location. 6. Place the refrigerator on a level surface, ensuring that it is stable and not wobbling. 7. Once the refrigerator is in place, level it by adjusting the front leveling legs. 8. Reconnect the refrigerator to the power source and ensure that it is properly plugged in. 9. Allow the refrigerator to stabilize for a few hours before loading it with food. By following these steps and having at least two people to move and install the refrigerator, you can ensure the process is done safely and avoid excessive weight on a single person.
The minimum required opening size for delivery of the Whirlpool WRX735SDH refrigerator is a minimum of 33 inches (838 mm). If the opening is smaller or equal to 36 inches (914 mm), the doors, drawers, and hinges will need to be removed. It is important to ensure that there is enough space to accommodate the refrigerator during delivery and installation.
To prime the water filter in the Whirlpool WRX735SDH refrigerator, follow these steps: 1. Locate the water filter in the top-right corner of the refrigerator compartment. 2. Lift open the filter cover door to release the filter and allow it to eject as the door is opened. 3. When the door is completely open, pull the filter straight out. Note that there may be some water in the filter, so be prepared for spills and use a towel to wipe up any spills. 4. Take the new filter out of its packaging and remove the covers from the O-rings. Ensure that the O-rings are still in place after removing the covers. 5. With the arrow on the filter pointing up, align the new filter with the filter housing and slide it into place. The filter cover door will automatically begin to close as the new filter is inserted. 6. Close the filter cover door completely to snap the filter into place. You may need to apply some pressure. 7. Flush the water system. Refer to the "Water and Ice Dispensers" section in the manual for detailed instructions on how to flush the water system. Following these steps will ensure that the water filter in your Whirlpool WRX735SDH refrigerator is properly primed and ready to use.
If there is still air in the water system after priming the water filter in the Whirlpool WRX735SDH refrigerator, you can follow these steps to resolve the issue: 1. Use a sturdy container and press on the water dispenser paddle for 5 seconds. 2. Release the dispenser paddle for 5 seconds. 3. Repeat steps 1 and 2 until water starts to flow. 4. Once water starts to flow, continue pressing and releasing the dispenser paddle (press for 5 seconds, release for 5 seconds) until a total of 3 gallons (12 liters) of water has been dispensed. By following these steps, you can remove any remaining air from the water system and ensure a steady flow of water from the dispenser in your Whirlpool WRX735SDH refrigerator.
To move and install the Whirlpool WRX735SDH refrigerator and avoid excessive weight, it is recommended to have at least two people. Follow these steps for safe and efficient moving and installation: 1. Ensure that both people are physically capable of lifting and moving heavy objects. 2. Clear a path from the refrigerator's current location to its new location, removing any obstacles that may hinder the movement. 3. Open the refrigerator doors and remove any items from inside, including shelves and drawers, to reduce the weight and prevent damage during the move. 4. Stand on opposite sides of the refrigerator and firmly grip the handles or sides of the appliance. 5. Lift the refrigerator using your legs, not your back, to avoid strain or injury. 6. Walk slowly and carefully to the new location, ensuring that both people maintain a secure grip on the refrigerator. 7. Once in the new location, gently lower the refrigerator onto the floor or onto its designated spot. 8. Level the refrigerator using the adjustable feet or wheels, ensuring that it is stable and balanced. 9. Reinstall any shelves and drawers that were removed during the move. 10. Plug in the refrigerator and allow it to stabilize for a few hours before loading it with food. By following these steps and having at least two people, you can safely move and install the Whirlpool WRX735SDH refrigerator without risking excessive weight or injury.
The minimum required opening size for delivery of the Whirlpool WRX735SDH refrigerator is a minimum of 33 inches (838 mm). If the opening is smaller or equal to 36 inches (914 mm), the doors, drawers, and hinges will need to be removed. It is important to ensure that there is enough space for the refrigerator to fit through the opening during delivery.
Yes, the manual of the Whirlpool WRX735SDH is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Whirlpool and is the answer not in the manual?
Question and answer
Number of questions: 2Ice maker stop working
Reset water filter