Whirlpool WRS325SDHZ manual

Whirlpool WRS325SDHZ
9.3 · 3
PDF manual
 · 64 pages
English
manualWhirlpool WRS325SDHZ
10
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn cooling off or turn the control
(thermostat, refrigerator, or freezer control depending on the
model) to Off. Then disconnect the refrigerator from the electrical
source. When you are finished, reconnect the refrigerator to the
electrical source. Turn cooling on or reset the control (thermostat,
refrigerator, or freezer control depending on the model) to the
desired setting. See “Control Descriptions” in the Quick Start
Guide.

Water Supply Requirements

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed:
Flat-blade screwdriver
7/16" and 1/2" open-end or two
adjustable wrenches
1/4" nut driver
1/4" drill bit
Cordless drill
NOTE: Your refrigerator dealer has a kit available with a 1/4"
(6.35 mm) saddle-type shutoff valve, a union, and copper or PEX
tubing. Before purchasing, make sure a saddle-type valve
complies with your local plumbing codes. Do not use a piercing-
type or 3/16" (4.76 mm) saddle valve, which reduces water flow
and clogs more easily.
IMPORTANT:
All installations must meet local plumbing code requirements.
Use copper or PEX tubing and check for leaks. Install copper
or PEX tubing only in areas where the household temperatures
will remain above freezing.

Water Pressure

A cold water supply with water pressure of between 30 psi and
120 psi (207 kPa and 827 kPa) is required to operate the water
dispenser and ice maker. If you have questions about your water
pressure, call a licensed, qualified plumber.
If your refrigerator has a water dispenser: After installation is
complete, use the water dispenser to check the water pressure.
With the water filter removed, dispense 1 cup (237 mL) of
water. If 1 cup of water is dispensed in 8 seconds or less, the
water pressure to the refrigerator meets the minimum
requirement.
If it takes longer than 8 seconds to dispense 1 cup of water, the
water pressure to the refrigerator is lower than recommended.
See online “Troubleshooting” for suggestions.

Reverse Osmosis Water Supply

IMPORTANT: The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet valve of the
refrigerator needs to be between 30 psi and 120 psi (207 kPa and
827 kPa).
If a reverse osmosis water filtration system is connected to your
cold water supply, the water pressure to the reverse osmosis
system needs to be a minimum of 40 psi to 60 psi (276 kPa to
414 kPa).
If the water pressure to the reverse osmosis system is less than
40 psi to 60 psi (276 kPa to 414 kPa):
Check to see whether the sediment filter in the reverse
osmosis system is blocked. Replace the filter if necessary.
Allow the storage tank on the reverse osmosis system to refill
after heavy usage.
If your refrigerator has a water filter, it may further reduce the
water pressure when used in conjunction with a reverse
osmosis system. Remove the water filter. See “Water Filtration
System”.
If you have questions about your water pressure, call a licensed,
qualified plumber.

Connect Water Supply

Read all directions before you begin.
IMPORTANT:
Connect to potable water supply only.
Plumbing shall be installed in accordance with the
International Plumbing Code and any local codes and
ordinances.
The gray water tubing on the back of the refrigerator (which is
used to connect to the household water line) is a PEX (cross-
linked polyethylene) tube. Copper or PEX tubing connections
from the household water line to the refrigerator are
acceptable, and will help avoid off-taste or odor in your ice or
water. Check for leaks. For recommended parts if PEX tubing
is used instead of copper:
W10505928RP (7 ft. [2.14 m] jacketed PEX),
8212547RP (5 ft. [1.52 m] PEX), or
W10267701RP (25 ft. [7.62 m] PEX).
Install tubing only in areas where temperatures will remain
above freezing.
Tools Needed:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Flat-blade screwdriver
7/16" and 1/2" open-end wrenches or two adjustable wrenches
1/4" nut driver

Connect to Water Line

IMPORTANT: If you turn on the refrigerator before the water line is
connected, turn off the ice maker.
Style 1 (Recommended)
1. Unplug refrigerator or disconnect power.
2. Turn off main water supply. Turn on nearest faucet long
enough to clear line of water.
3. Use a quarter-turn shutoff valve or the equivalent, served by a
1/2" copper or PEX household supply line.
NOTE: To allow sufficient water flow to the refrigerator, a
minimum 1/2" size copper or PEX household supply line is
recommended.
A. Bulb
B. Nut
C. Copper or PEX tubing (to refrigerator)
D. Household supply line (½" minimum)

View the manual for the Whirlpool WRS325SDHZ here, for free. This manual comes under the category refrigerators and has been rated by 3 people with an average of a 9.3. This manual is available in the following languages: English. Do you have a question about the Whirlpool WRS325SDHZ or do you need help? Ask your question here

Need help?

Do you have a question about the Whirlpool and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 56
T
Trichel VaheyApril 18, 2023

The freezer door will not close tightly. It looks like it’s too tight on the hinge side but cannot understand how to align it. The refrigerator side door closes firmly

The freezer door will not close tightly. It looks like it’s too tight on the hinge side but cannot understand how to align it...
zoom-in
View photo
1 comment
E
Emma of manua.lsDecember 19, 2023

To adjust the freezer door on the Whirlpool WRS325SDHZ refrigerator, please follow these steps: 1. Open both doors of the refrigerator. 2. Check the levelness of the floor where the rear side of the refrigerator will rest. If the refrigerator is not leveled, adjust or add shims on the flooring to create a leveled floor for the rear side wheels. A leveled rear side prevents the refrigerator cabinet from forming a twist. 3. Use a bubble level to check the levelness of the refrigerator. Place the bubble level on top of the refrigerator or on its side to ensure it is level. 4. Use a 3/8" nut driver to turn the leveling screws located on both sides of the refrigerator. Depending on the uneven floor conditions, you may need to turn one or both screws to the right or left several times to raise or lower the refrigerator. 5. Close both doors and check that they close easily. If not, turn both screws to the right to raise the refrigerator by tilting it more to the back until the doors close easily.

This answer is automatically generated
D
Denise MetcalfMay 26, 2024

The temperature settings bars including the check marks have been illuminated since I’ve had the refrigerator which I purchased in April. While cleaning the screen the check marks no longer appear and the bars go off after a few months minutes. Is this normal?

S
Samantha h.May 14, 2024

My fridge and freezer are no longer getting cold. It's not even a month old. Everything is getting soggy . Who do I call?

L
L SHERWOODOctober 16, 2023

There is a red light that shows H2O but I cannot find what or where I am to look for place to correct.

There is a red light that shows H2O but I cannot find what or where I am to look for place to correct.
zoom-in
View photo
1 comment
D
DIANNA BAILEYJanuary 28, 2024

@L SHERWOOD

A
Annette C. WlliamsFebruary 7, 2023

There is a red light that shows H2O but I cannot find what or where I am to look for place to correct.

1 comment
F
Felix Bruno October 26, 2023

Where do u press to turn the reset for the filter light off

M
Maggie May 10, 2023

There is a red light that shows H2O but I cannot find what or where I am to look for

1 comment
J
JoshApril 17, 2024

@Maggie This means the water filter should be replaced. It is timer-based, so you can reset the timer by holding the "Light" and "Ice type" buttons for a few seconds.

J
JohnJuly 22, 2023

I accidentally got the parts of the drawers mixed up what page do I find to reinstall the drawers back in place

T
Tom TrippJuly 27, 2023

Just received delivery of WR325SDHZ08 side-by-side refrigerator. In the last hour the interior has only gotten 4 degrees (F) cooler. Is this normal or should I worry?

T
TomAugust 11, 2023

The top light bulb in my wrs325sdhz08 freezer is not working. Can it be replaced and if so, how is it done

S
SamirSeptember 18, 2023

Coloque la temperatura del refrigerador lo menos Frio y aún sigue congelando mis artículos frescos. Que debo hacer?

The Whirlpool WRS325SDHZ is a refrigerator that offers ample storage space and reliable performance. With its spacious 24.6 cubic feet capacity, you can easily store all your groceries and beverages. The refrigerator features adjustable glass shelves, allowing you to customize the layout to suit your needs and accommodate larger items. It also has adjustable gallon door bins, providing convenient storage for milk jugs and other large containers. The WRS325SDHZ includes two humidity-controlled crispers, designed to keep your fruits and vegetables fresh for longer. It also features a temperature-controlled full-width drawer, which is ideal for storing deli meats and cheeses. The refrigerator is equipped with LED interior lighting, ensuring that the contents are well-illuminated, making it easy to find what you need. In terms of functionality, the WRS325SDHZ features a through-the-door ice and water dispenser, providing chilled water and ice cubes on demand. The dispenser also includes a water filter, ensuring that you have clean and fresh-tasting water. In terms of design, the refrigerator has a sleek stainless steel exterior, adding a touch of modernity to your kitchen. It features a fingerprint-resistant finish, keeping the appliance looking clean and polished. With its Energy Star certification, the WRS325SDHZ is designed to be energy-efficient, helping you to conserve electricity and reduce your utility bills. In summary, the Whirlpool WRS325SDHZ is a spacious and reliable refrigerator, offering customizable storage options, advanced features such as an ice and water dispenser, and a sleek design.

General
BrandWhirlpool
ModelWRS325SDHZ | WRS325SDHZ
Productrefrigerator
LanguageEnglish
FiletypeUser manual (PDF), Installation Guide (PDF), Quickstart Guide (PDF), Datasheet (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool WRS325SDHZ below.

How do I prevent drops from forming on the glass plates of my fridge?

There may be various causes for this, it is recommended to check the following: - Is the drain hole free of dirt? - Does the refrigerator door close properly? - Is the refrigerator not too full so that air can circulate properly? - Is the temperature not set below 5 degrees?

What do I do about a smelly fridge?

A common method for solving the problem of a smelly fridge is to pour vinegar into the drain and temporarily place a cup of vinegar in the fridge.

How much free space does my fridge need?

A minimum of 2.5 centimetres of free space around the fridge is needed to ventilate properly.

What does R-410A stand for?

R-410A is a refrigerant used in machines that cool to zero degrees Celsius.

Why is my refrigerator not cooling properly?

There could be various reasons for this issue, such as a dirty condenser coil, improper temperature settings, or a faulty temperature control. Troubleshooting these areas can help resolve the cooling problem.

What should I do if my refrigerator is making strange noises?

Unusual noises coming from your refrigerator could indicate a faulty fan motor, a clogged drain, or even a loose component. Inspecting and potentially repairing these areas can help eliminate the noises.

How can I prevent frost buildup in my freezer?

Frost buildup can occur due to a damaged door gasket, frequent door openings, or improper temperature settings. Checking and replacing the gasket if needed, minimizing door openings, and adjusting the temperature can help prevent frost accumulation.

How do I resolve ice dispenser issues?

If your ice dispenser is not working correctly, it might be due to a clogged water line, an improperly installed water filter, or a faulty dispenser motor. Checking and addressing these potential issues can restore the ice dispenser's functionality.

Why is water leaking from my refrigerator?

Water leakage can be caused by a blocked defrost drain, a cracked water inlet valve, or a faulty water filter. Investigating and resolving these issues can help stop the water leakage and maintain a properly functioning refrigerator.

Is the manual of the Whirlpool WRS325SDHZ available in English?

Yes, the manual of the Whirlpool WRS325SDHZ is available in English .

Is your question not listed? Ask your question here

No results