Whirlpool WFW5605MW manual

Whirlpool WFW5605MW
9.5 · 4
PDF manual
 · 32 pages
English
manualWhirlpool WFW5605MW
20
Ajouter du détergent HE au distributeur Load & Go
Distributeur (sur certains modèles) :
Utiliser uniquement un détergent liquide Haute efficacité (HE). Les
distributeurs Load & Go peuvent contenir jusqu’à 67,6 oz (2 L) ou
33,8 oz (1 L) de détergent HE liquide ou suffisamment pour
plusieurs charges de lessive.
Remplissage du distributeur en vrac (sur certains modèles) :
Ouvrir le tiroir distributeur en tirant sur la poignée à la base de la
laveuse.Si désiré, le tiroir peut être complètement retiré de la
laveuse.
Trouver le distributeur de vrac Load & Go.
Tirer doucement sur la languette située sur le
couvercle du distributeur pour soulever la porte
de remplissage.
Remplir jusqu’à la ligne « MAX » (voir les
illustrations ci-contre) avec du détergent HE
liquide ou de l’assouplissant liquide (distributeur
1 litre seulement). Fermer la porte de
remplissage. Elle s’emboîte. S’assurer que le
réglage de concentration est correct (voir le
« guide des programmes » en ligne).
Il est recommandé de rincer les distributeurs
avant son remplissage, lorsqu’on change de
type ou de concentration de détergent ou si on
n’utilise pas la laveuse pendant une période
prolongée. Pour les instructions concernant le
nettoyage de la cartouche du distributeur,
consulter le point « Entretien de la laveuse »
dans la section « Entretien et réparation de la
laveuse » de votre manuel de l’utilisateur.
Ajouter du détergent HE au distributeur pour charge unique :
Verser une mesure de détergent HE
dans le compartiment à détergent.
Pour du détergent en poudre,
soulever le sélecteur vers la position
supérieure. Pour le détergent liquide,
abaisser le sélecteur jusqu’en
position inférieure.
Ne pas remplir excessivement; ajouter trop de détergent peut
entraîner sa distribution prématurée dans la laveuse.
IMPORTANT:
Désactiver l’option Load & Go Avant de lancer une charge
unique (sur certains modèles). Le tiroir distributeur optimal
ne peut pas être désactivé.
Ne pas ajouter de sachet de lessive à dose unique dans le
tiroir distributeur.
Détergent en poudre : Détergent liquide :
Soulever le sélecteur en
position élevée. Ajouter
directement dans le
compartiment.
Appuyer sur le sélecteur pour
le placer en position basse.
Ajouter directement dans le
compartiment.
Noter la date de remplacement au marqueur indélébile sur
l’étiquette.
Vérifier que les vieilles rondelles ne sont pas coincées dans
les valves d’arrivée d’eau de la laveuse.
Utiliser de nouvelles rondelles avec les nouveaux tuyaux
d’entrée pour assurer une bonne étanchéité.

Entretien de la laveuse

Recommandations pour une laveuse propre et
pour un niveau de performance optimal
1. Utiliser toujours un détergent HE (haute efficacité) et
employer la quantité de détergent recommandée par le
fabricant du détergent HE. Ne jamais utiliser plus que la
quantité recommandée de détergent, car ceci peut augmenter
le taux d’accumulation de résidus de détergent et de
souillures à l’intérieur de la laveuse, ce qui pourrait entraîner
la formation d’odeurs indésirables.
2. Exécuter périodiquement des lavages avec de l’eau tiède ou
chaude (pas exclusivement des lavages à l’eau froide), car
l’eau chaude facilite l’élimination des résidus de détergent et
de souillures.
3. Veiller à toujours laisser le couvercle de la laveuse ouvert
entre deux utilisations pour qu’elle puisse sécher, et pour
éviter l’accumulation de résidus générateurs d’odeurs.
4. Nettoyer périodiquement les résidus s’accumulant sur les
surfaces intérieures du hublot. Pour un meilleur entretien,
passer un linge humide sur toute la partie intérieure de la
porte.
ENTRETIEN ET RÉPARATION DE

LA LAVEUSE

Nettoyage de l'emplacement de la

laveuse

Éviter de laisser autour de la laveuse des éléments qui pourraient
obstruer la circulation de l’air et empêcher le bon séchage. Ceci
implique de dégager également les éventuelles piles de
vêtements placées devant la laveuse.
Tuyaux d’arrivée d’eau
Remplacer les tuyaux d’arrivée d’eau après 5 ans d’utilisation
pour réduire le risque de défaillance intempestive. Inspecter
périodiquement les tuyaux; les remplacer en cas de renflement,
de déformation, de coupure et d’usure ou de fuite.
Lors du remplacement de vos tuyaux d’arrivée d’eau :
REMARQUE : Il est déconseillé d’utiliser du détergent en poudre à moins que tiroir distributeur optimal est vide.

View the manual for the Whirlpool WFW5605MW here, for free. This manual comes under the category washing machines and has been rated by 4 people with an average of a 9.5. This manual is available in the following languages: English. Do you have a question about the Whirlpool WFW5605MW or do you need help? Ask your question here

Need help?

Do you have a question about the Whirlpool and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 91
L
Lori hayesJuly 23, 2023

How do you access the drain pump on my whirlpool washing machine when it’s in the front of my front loader

How do you access the drain pump on my whirlpool washing machine when it’s in the front of my front loader
zoom-in
View photo
1 comment
E
Emma of manua.lsDecember 21, 2023

To access the drain pump of the Whirlpool WFW5605MW washing machine when it is located at the front of the front loader, follow these steps: 1. Turn off the washer before cleaning the drain pump filter. 2. Open the dispenser drawer by pulling on the handle at the base of the washer. This will reveal the drain pump filter. 3. Remove the drawer by releasing the tab on each side. Push down on the tab on the right side and up on the tab on the left side. 4. Place a broad, flat container beneath the drain pump filter to collect the drain water. Release the black hose from the hose clip, remove the plug, and drain the hose into the container. Empty the container. Repeat this procedure if necessary until all the water has drained. Make sure the black hose is completely dry, replace the plug, and secure the hose in the clip. 5. Lay a cotton cloth beneath the drain pump filter to absorb any remaining water. Then, turn the drain pump filter counterclockwise to remove it. 6. Remove any large clumps of lint by hand from the filter and dispose of them in a suitable waste container. Rinse the filter with water to remove any remaining residue. 7. Reinsert the drain pump filter by turning it clockwise. Make sure to turn it as far as it will go, with the filter handle remaining as close as possible to the vertical position. 8. Replace and close the dispenser drawer. Make sure to insert both rails simultaneously when replacing the drawer. You will hear a clicking sound that indicates the rails have engaged. To ensure proper placement of the drawer, pull it out fully. The drawer should be fully engaged and the rails locked in place. Make sure the drain hose is secured in the hose clip and tucked underneath the cutout.

This answer is automatically generated
B
BlancaFebruary 29, 2024

How do I stop or cancel the washer, keeps blinking, turned off and doesn't stop when turned on again?

How do I stop or cancel the washer, keeps blinking, turned off and doesn't stop when turned on again?
zoom-in
View photo
1 comment
E
Emma of manua.lsMarch 18, 2024

To stop the washer from blinking and not stopping when turned on again, unplug the machine for a few minutes and then plug it back in. This can reset the washer and stop the blinking issue.

This answer is automatically generated
F
Fay johnsonSeptember 27, 2022

Why is my washer only showing a wash cycle and dosen't show when it's rinsing or spinning.is it rinsing it only show washing and end

1 comment
G
GloriaOctober 27, 2023

same problem

D
Deborah ShreckengostDecember 11, 2022

My washer keeps shutting off and displaying Lo Fl. Why is this happening? The first time it did it, the clothes were still dry.

1 comment
D
Debbie Laverdiere October 23, 2023

Mine is doing the same thing. Lo Fl

L
Lynne Susanne NiemanApril 25, 2023

My front load washer model wfw5605mw displays Loc with a red screwdriver image when I press the power button. How do I turn that off?

J
Julie RodriguezMay 6, 2023

My washer machine is showing LOC when I’m trying to wash it doesn’t let me do anything

K
KateJune 17, 2023

Can’t get the control lock off..held the extra rinse button for 3 seconds and screen displays…3 -2-1 LOC…..no power to power button

M
Martha June 18, 2023

I ran a load with bleach. The load is finished but the bleach dispenser is still full. How do I empty it and why didn't the bleach dispense properly?

P
PeggyJuly 11, 2023

My whirlpool washer doesn’t have the panel in the front to clean the filter. How am I supposed to clean it. took the back off and pump faces to the front

1 comment
R
Ron YDecember 11, 2023

Did you find the answer to your question? I’m having the same issue.

S
Steve NelsonSeptember 26, 2023

I turned on washer to wash, now the panel seems to have no power to operate after it started, no lights on the control panel and the machine has stopped/locked with laundry inside. Fuse panel reset in home, unplugged and plugged back in and tested outlet…it has power!

The Whirlpool WFW5605MW is a washing machine model that offers efficient and reliable performance. Designed with practicality in mind, this machine is built to effectively clean a variety of fabrics and garments. Featuring a spacious drum capacity, the Whirlpool WFW5605MW allows for larger loads, reducing the number of cycles needed. This not only saves time but also energy and water consumption. Equipped with advanced washing programs, this machine offers various options such as delicate, heavy-duty, and quick wash, catering to different cleaning needs. The intuitive control panel allows for easy program selection and adjustment, ensuring convenience for users. The Whirlpool WFW5605MW incorporates innovative technology to provide efficient cleaning results. The high-speed spin cycle helps to remove excess water, reducing drying time. Additionally, it features sensors that automatically adjust the water level and temperature based on the load, optimizing energy usage. Built with quality materials, this washing machine is durable and designed to withstand frequent use. The sturdy construction ensures that it can withstand the rigors of daily laundry tasks without compromising performance. In conclusion, the Whirlpool WFW5605MW is a reliable and efficient washing machine that offers a range of features to simplify laundry tasks. With its large capacity, advanced programs, and durable construction, it provides users with a practical and effective solution for their cleaning needs.

General
BrandWhirlpool
ModelWFW5605MW
Productwashing machine
LanguageEnglish
FiletypeUser manual (PDF), Quickstart Guide (PDF), Warranty information (PDF), Energy label (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool WFW5605MW below.

What temperature should I use for my laundry?

The washing label of your garment shows the recommended washing temperature.

Do I need to use an anti-scaling agent for my washing machine?

It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.

How do I prevent my washing machine from smelling?

Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.

Why is my Whirlpool WFW5605MW not turning on?

First, make sure the power cord is securely plugged into a functioning power outlet. If the machine still doesn't turn on, check the circuit breaker to ensure it hasn't tripped. Also, verify that the door is properly closed, as the machine won't start if the door is ajar.

How can I resolve excessive vibration and noise during the wash cycle?

It's important to ensure that the washing machine is properly leveled. Use a level tool to adjust the feet of the machine until it is balanced on all four corners. Uneven loads can also contribute to excessive vibrations, so make sure to distribute the clothes evenly inside the drum.

How do I clean the detergent dispenser drawer?

To clean the detergent dispenser, simply remove it from the machine by pulling it out until it stops and then lifting it out. Rinse the drawer under warm water to remove any residual detergent buildup and dry it thoroughly before reinserting it into the machine.

What to do if water is not draining properly?

Start by checking if the drain hose is kinked or clogged. Ensure that the hose is positioned correctly and not obstructed in any way. Additionally, inspect the drain pump filter for any debris or obstructions, and clean if necessary. If the issue persists, it might be necessary to contact a professional technician.

How can I troubleshoot if the clothes are not spinning or draining properly?

First, confirm that you have selected the appropriate wash cycle and that the machine is not overloaded. If the clothes are still not spinning or draining properly, check the drain hose for any clogs or blocks. Ensure that the machine is not unbalanced, as this can affect the spin cycle. If the problem persists, it is advisable to contact Whirlpool customer support for further assistance.

Is the manual of the Whirlpool WFW5605MW available in English?

Yes, the manual of the Whirlpool WFW5605MW is available in English .

Is your question not listed? Ask your question here

No results