Whirlpool ADP 5310 WH manual

Whirlpool ADP 5310 WH
9 · 5
PDF manual
 · 8 pages
English
manualWhirlpool ADP 5310 WH
GB
-1-

Chart

PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarely paused: the
Start indicator blinking. To restart the cycle close
the door and push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher (1
minute process).
If the indicator flashes repeatedly, see page 6 -
chapter ”What to do if ...”.
(see at right for options description)
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.

Table of programs

Deter-
gent
Consumption
P
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
1

Pre-Wash cold

Delay Crockery to be washed later. 5.0 0.02 10
2

Glasses 40°C

Delay
Light soiling, for example glasses
and cups.
X 13.0 0.90 97
3

Quickwash 40°C

Delay
Lightly soiled crockery, with no
dried-on food.
X 13.0 0.70 30
4
Eco
2)
50°C
Delay
Half load
Normally soiled crockery. X 15.0 1.05 150
5

Intensive 70°C

Delay
Recommended program for
heavily soiled crockery, especially
suitable for pans and saucepans.
X 15.0 1.50 140

5019 396 01837/B

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
HALF LOAD BUTTON
Half load cycle can be used
for the upper or lower rack.
Select the required program
then press the “Half Load”
button - the light comes on.
Turns off at the end of the
program. The “Half Load”
option can be used with the
programs indicated in the
table of programs.
TABLET SETTING
This setting allows to optimize the cycle performances
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and deteregent in 1 dose).
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.

ADP 5310

Options and display description
Quick reference guide

Manual

View the manual for the Whirlpool ADP 5310 WH here, for free. This manual comes under the category dishwashers and has been rated by 5 people with an average of a 9. This manual is available in the following languages: English. Do you have a question about the Whirlpool ADP 5310 WH or do you need help? Ask your question here

Need help?

Do you have a question about the Whirlpool and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 3
I
Inês NetoNovember 13, 2020

It doesn't empty the water and the cancel button is always flashing, what do I need to do?

This message has been automatically translated
A
Ana isabel GarciaDecember 29, 2020

How do you unlock the dishwasher when the cancel button keeps flashing and it doesn't start working?

This message has been automatically translated
B
Bura NicolaeJanuary 6, 2022

Hello. My name is Bura Nicolae. I bought a dishwasher model ADP 5300 WH, type WAYFS, a few years ago. I haven't used it yet, now I want to start it, but it's not taking water. Is there a phone number for service in Maramures county, can you provide it?

Hello. My name is Bura Nicolae. I bought a dishwasher model ADP 5300 WH, type WAYFS, a few years ago. I haven't used it yet, ...
zoom-in
View photo
This message has been automatically translated

Whirlpool ADP 5310 WH specifications

Below you will find the product specifications and the manual specifications of the Whirlpool ADP 5310 WH.

The Whirlpool ADP 5310 WH dishwasher is a freestanding appliance with a sleek design that allows for easy placement in any kitchen. With an energy efficiency class rating of A, it ensures energy-saving performance. It also boasts outstanding washing and drying capabilities, both classified as A, ensuring clean and thoroughly dried dishes. The dishwasher operates quietly, producing a noise level of 51 dB, providing a peaceful environment in the kitchen during operation. It has a water consumption per cycle of 15 liters, allowing for efficient use of water resources. Featuring five washing programs, the Whirlpool ADP 5310 WH offers versatility to suit different washing needs. It has a capacity of 12 place settings, accommodating a decent amount of dishes in one cycle. The cycle time lasts for 150 minutes, providing efficient and thorough cleaning. With a cord length of 1.5 meters, the dishwasher offers flexibility in terms of positioning within the kitchen. It is equipped with a self-cleaning filter, ensuring maintenance and cleanliness of the appliance. The AquaSensor function detects the level of soiling and adjusts the water consumption accordingly, enhancing its efficiency. Additionally, the dishwasher includes a delayed start timer, allowing for convenient programming to start the cleaning process at a desired time. The maximum delay start time is 8 hours, providing flexibility and convenience to the user. Overall, the Whirlpool ADP 5310 WH dishwasher offers a reliable and efficient solution for cleaning dishes. Its modern design, energy efficiency, and range of features make it a practical choice for households seeking a high-quality dishwasher.

General
BrandWhirlpool
ModelADP 5310 WH | ADP 5310 WH
Productdishwasher
LanguageEnglish
FiletypeUser manual (PDF)
Design
Appliance placementFreestanding
Cord length1.5 m
Cutlery compartment typeBasket
Door colorWhite
Water fillCold
Power
A
Water consumption per cycle15 L
AC input voltage220 - 230 V
AC input frequency50 Hz
Connected load2200 W
Energy consumption per cycle1.05 kWh
Other features
Washing classA
Drying classA
Annual energy consumption231 kWh
Annual water consumption3300 L
Performance
Noise level51 dB
Number of washing programs5
Number of place settings12 place settings
Cycle time150 min
Dishwashing programsIntensive, Pre-wash, Quick
AquaSensor functionYes
Delayed start timerYes
Delay start (max)8 h
Drying systemStatic
Ergonomics
Self-cleaning filterYes
Weight & dimensions
Weight58000 g
Width597 mm
Depth596 mm
Height850 mm
Depth with door open1170 mm
Packaging data
Package weight60000 g
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool ADP 5310 WH below.

What do I do about a smelly dishwasher?

In the case of a smelly dishwasher, you can take the following steps: - Clean the filters - Clean the spray arms - Clean the door rubbers - Run a hot wash program - Run an empty machine with a dishwasher cleaner

Do you have to pre-rinse the dishes?

It is not recommended to rinse dirty dishes before placing them in the dishwasher. For the life cycle of the machine, it is better to put everything dirty in the dishwasher. The grease on the dirty dishes is the lubrication for the pump in the machine.

How much dishwashing detergent should I use?

The average amount used is about 25 grams of dishwashing detergent. It is recommended to follow the advice on the packaging.

How do I add softening salt to my dishwasher?

Each dishwasher has a separate compartment for softening salt. It opens when you turn the knob on the compartment. The softening salt can then be poured into the compartment by means of a funnel.

What is the weight of the Whirlpool ADP 5310 WH?

The Whirlpool ADP 5310 WH has a weight of 58000 g.

What is the height of the Whirlpool ADP 5310 WH?

The Whirlpool ADP 5310 WH has a height of 850 mm.

What is the width of the Whirlpool ADP 5310 WH?

The Whirlpool ADP 5310 WH has a width of 597 mm.

What is the depth of the Whirlpool ADP 5310 WH?

The Whirlpool ADP 5310 WH has a depth of 596 mm.

Why isn't the dishwasher turning on?

Make sure the dishwasher is securely plugged into a power outlet and that the outlet is functioning properly. Check the circuit breaker to ensure it hasn't been tripped.

Why is the dishwasher not cleaning dishes properly?

Ensure that the dishes are loaded properly, leaving adequate space between them. Verify that the spray arms are not blocked and can freely rotate. Check the water temperature to ensure it's set to a sufficient level for effective cleaning.

Why do I see water leakage from the dishwasher?

Examine the door seal for any damage or food debris that may hinder a proper seal. Ensure the dishwasher is leveled properly to prevent water leakage. Check the water inlet hose and drain hose for any signs of damage or blockage.

Why is the dishwasher not draining?

Verify that the drain hose is not kinked or obstructed. Inspect the drain filter for any debris that may be preventing proper drainage. Ensure the dishwasher is not overloaded, as this can impede drainage.

Why is the dishwasher making unusual noises?

Check for any items, such as utensils or small dishes, that may have fallen into the bottom of the dishwasher and are causing a noise. Ensure that the spray arms are not obstructed or loose. Examine the pump motor for any signs of malfunction or foreign objects.

Does the Whirlpool ADP 5310 WH have a self-cleaning filter?

Yes, the Whirlpool ADP 5310 WH has a self-cleaning filter. This means that the user does not have to clean the filter manually, making maintenance easier and more convenient.

Is the energy efficiency class of the Whirlpool ADP 5310 WH A-rated?

Yes, the energy efficiency class of the Whirlpool ADP 5310 WH is A-rated. This means that it consumes less energy compared to lower-rated models, resulting in potential cost savings and a more environmentally friendly operation.

How many washing programs does the Whirlpool ADP 5310 WH have?

The Whirlpool ADP 5310 WH has 5 washing programs. This provides the user with various options to choose from, allowing for customized cleaning based on the specific needs of the dishes being washed.

Can the Whirlpool ADP 5310 WH be placed freestanding?

Yes, the Whirlpool ADP 5310 WH can be placed freestanding. This gives the user flexibility in terms of where they can install the dishwasher in their kitchen.

What is the water consumption per cycle of the Whirlpool ADP 5310 WH?

The water consumption per cycle of the Whirlpool ADP 5310 WH is 15 liters. This reflects a relatively low water usage, potentially leading to reduced water bills for the user and contributing to water conservation efforts.

Is the manual of the Whirlpool ADP 5310 WH available in English?

Yes, the manual of the Whirlpool ADP 5310 WH is available in English .

Is your question not listed? Ask your question here

No results