Whirlpool ADG 9510 manual

Whirlpool ADG 9510
(1)
  • Number of pages: 8
  • Filetype: PDF
Whirlpool is a registered trademark of Whirlpool USA

5019 396 01197

Before using the dishwasher, read the installation and maintenance instructions carefully!
1
GB

ADG 9510

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra functions, different settings, water supply temperatures, water hardness and power supply voltage.2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories: for detailed
information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.

1. OVERVIEW

Programme selection button
Press the button (repeatedly) until the indicator lamp
of the desired programme lights up (see table 1.1).
At the end of the wash cycle, the last programme
selected is memorized.
Detergent setting upon initial use and when using a
different type of detergent
Indicator lamp off = Powder/gel detergent
(factory setting).
If using combined detergents, press and hold the
button for 3 seconds; the indicator lamp lights up =
rinse aid and salt indicators are deactivated.
From water hardness level 5, the salt indicator
remains active. At the end of the programme, the
most recently selected setting remains memorised.
Delayed Start button
Press the button repeatedly to delay the start of the
programme by 2, 4 or 8 hours. Then press the Start/
Resume button. The remaining time is indicated by the
corresponding indicator lamp. The wash programme
will start after the set time. The set delay will be
memorised at the end of the cycle, and can be selected
by pressing the button again.
Start/Resume button
The indicator lamp lights up during operation, flashes when
the programme is interrupted before completion and
switches off at the end of the programme.
Cancel/Off button
Press the button to switch the dishwasher off or to
interrupt the selected programme.
If the Cancel/Off indicator lamp flashes repeatedly, this
indicates a fault: see chapter 5 “What to do if...”.
Rinse aid level indicator and salt level indicator
These light up at the end of the programme if the rinse
aid or salt needs topping up. Only add just before
starting a wash cycle.

Table 1.1.

Table of programmes

Detergent
dispenser
Consumption
1)
P
Programmes
Available
options
Description of programme
large small Litres kWh Minutes
1
Pre-Rinse cold
Crockery to be washed later. 4.0 0.03
14 ±
1)
2
Quickwash 45°C
Lightly soiled crockery, with no
dried-on food.
X 11.0 0.80 30 ±
1)
3
Eco
2)
50°C
Normally soiled crockery.
Energy-saving programme.
X X 12.0 1.05 165 ±
1)
4
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pots and pans.
X X 14.0 1.55 155 ±
1)
5
Half Load 50°C
Ideal for washing a half load of lightly
or normally soiled crockery.
X X 10.0 1.04 145 ±
1)
Whirlpool ADG 9510

Need help?

Number of questions: 0

Do you have a question about the Whirlpool ADG 9510 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Whirlpool ADG 9510 owners to properly answer your question.

View the manual for the Whirlpool ADG 9510 here, for free. This manual comes under the category Dishwashers and has been rated by 1 people with an average of a 9.9. This manual is available in the following languages: English. Do you have a question about the Whirlpool ADG 9510 or do you need help? Ask your question here

Whirlpool ADG 9510 specifications

General
Brand Whirlpool
Model ADG 9510
Product Dishwasher
Language English
Filetype PDF
Design
Appliance placement Fully built-in
Water fill Cold
Cord length 1.6 m
Cutlery compartment type Basket
Door colour Not applicable
Control panel colour Stainless steel
Power
Energy efficiency class (old) A
Water consumption per cycle 12 L
AC input voltage 220 - 230 V
AC input frequency 50 Hz
Connected load 2200 W
Energy consumption per cycle 1.05 kWh
Other features
Washing class A
Drying class A
Annual energy consumption 294 kWh
Performance
Noise level 48 dB
Number of washing programs 5
Drying system Static
Number of place settings 12 place settings
Cycle time 165 min
Dishwashing programs intensive,pre-wash,quick
AquaSensor function
Delayed start timer
Delay start (max) 8 h
Ergonomics
Self-cleaning filter
Weight & dimensions
Weight 41000 g
Width 597 mm
Depth 555 mm
Height 820 mm
Depth with door open 1150 mm
Package weight 42200 g
show more

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Whirlpool ADG 9510.

Is your question not listed? Ask your question here