Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarily paused: the
Start indicator blinks.
To resume the cycle push the Start button and
close the door within 3 seconds.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter ”What to do if ...”.
1)Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without
additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor
programs as a result of the appliance’s automatic calibration system.
2)Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information
on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
Table of programs
Deter-
gent
Consumption
P
Programs
Availableoptions
Loading instructions
Litres kWhMinutes
1)
1
Aqua Steam 40-70°C
Delay
Normally or heavily soiled crockery,
including pots and pans. Thanks to
steam action, soaking or hand
pretreatment is no longer needed. In
addition hygiene is ensured due to
the high temperature steam.
X7-140.99-1.8070-185
2
Pre-Wash cold
DelayCrockery to be washed later.—4.00.0314
3
Quickwash45°C
Delay
Lightly soiled crockery, with no dried-
on food.
X11.00.8030
4
Eco
2)
50°C
Delay
Normally soiled crockery.
Energy-saving program.
X12.01.05170
5
Intensive70°C
Delay
Recommended program for heavily
soiled crockery, especially suitable for
pans and saucepans.
X14.01.55155
5019 396 01985ADG 9300
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATORWhen lit (at the end of the cycle), the salt reservoir needs to be refilled. DELAYED START BUTTONThe wash cycle can be programmed to start after 2, 4 or 8 hours. Then press the Start button. The wash program will start after the set time.RINSE AID INDICATORWhen lit (at the end of the cycle), the rinse aid dispenser needs to be refilled.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
TABLET SETTING
This setting allows to optimize the cycle performances according the type of detergent used.Push the Tablet button for 3 seconds (until the indicator lights up) if you are using the combined detergents in tablet (rinse aid, salt and deteregent in 1 dose).If you are using powder detergent or liquid detergent, the Tablet indicator on the control panel has to be off.
Quick reference guide
View the manual for the Whirlpool ADG 9300 here, for free. This manual comes under the category Dishwashers and has been rated by 1 people with an average of a 5.7. This manual is available in the following languages: English. Do you have a question about the Whirlpool ADG 9300 or do you need help? Ask your question here
Need help?
Do you have a question about the Whirlpool and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Whirlpool owners to provide you with a good answer.
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Whirlpool ADG 9300 below.
What do I do about a smelly dishwasher?
In the case of a smelly dishwasher, you can take the following steps: - Clean the filters - Clean the spray arms - Clean the door rubbers - Run a hot wash program - Run an empty machine with a dishwasher cleaner
Do you have to pre-rinse the dishes?
It is not recommended to rinse dirty dishes before placing them in the dishwasher. For the life cycle of the machine, it is better to put everything dirty in the dishwasher. The grease on the dirty dishes is the lubrication for the pump in the machine.
How much dishwashing detergent should I use?
The average amount used is about 25 grams of dishwashing detergent. It is recommended to follow the advice on the packaging.
How do I add softening salt to my dishwasher?
Each dishwasher has a separate compartment for softening salt. It opens when you turn the knob on the compartment. The softening salt can then be poured into the compartment by means of a funnel.
Is the manual of the Whirlpool ADG 9300 available in English?
Yes, the manual of the Whirlpool ADG 9300 is available in English .
Need help?
Do you have a question about the Whirlpool and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Whirlpool owners to provide you with a good answer.
Number of questions: 0