Whirlpool ADG 8200 IX manual

Whirlpool ADG 8200 IX
(1)
  • Number of pages: 8
  • Filetype: PDF
GB
-1-

Chart

PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
(see at right for options description)
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute (0:01
is shown into the display).
If pressed when the dishwasher is switched off, it
drains any possible liquids from dishwasher
(1 minute process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and
may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic
calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programs

Deter-
gent
Consumption
P
Programs
Availableoptions
Loading instructions
Litres kWhMinutes
1)
1
Aqua Steam 40-70°C
Delay
Multizone
Antibacterial
rinse
Normally or heavily soiled crockery, including
pots and pans. Thanks to steam action,
soaking or hand pretreatment is no longer
needed. In addition hygiene is ensured due to
the high temperature steam.
X 7-14 0.99-1.80 70-185
2
Pre-Wash cold
Delay
Multizone
Crockery to be washed later. 4.0 0.03 14
3
Glasses 40°C
Delay
Multizone
Light soiling, for example glasses and
cups.
X 10.0 0.85 100
4
Quickwash 45°C
Delay
Multizone
Lightly soiled crockery, with no
dried-on food.
X 11.0 0.80 30
5
Eco
2)
50°C
Delay
Multizone
Antibacterial
rinse
Normally soiled crockery.
Energy-saving program.
X 11.0 1.05 155
6
Daily 60°C
Delay
Multizone
Antibacterial
rinse
Normally to heavily soiled crockery. X 13.0 1.25 120

5019 396 01983ADG 8200

Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
MULTIZONE
Allows you to choose the washing
zones. Press this button (repeatedly)
to select the wash zones:
both racks
only lower rack
only upper rack
- indicator lits
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds (until
the indicator lights up) if
you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose). If you
are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours. With each press of
the button, the delayed
start indicator increases
by one hour and after 24
restarts from 0. Then
press the START button.
The dishwasher will start
after the set time.
ANTIBACTERIAL RINSE
3)
This function activates an
antibacterial rinse at the end of the
wash cycle, guaranteeing a further
reduction of bacteria. Press the
button to activate or deactivate the
function. This function can be used
with the programs indicated in the
table of programs. The dishwasher
door must be kept shut for the entire
duration of the program in order to
guarantee reduction of bacteria. If
the door is opened the indicator lamp
starts flashing.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Quick reference guide
Whirlpool ADG 8200 IX

Need help?

Number of questions: 1

Do you have a question about the Whirlpool ADG 8200 IX or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Whirlpool ADG 8200 IX owners to properly answer your question.

Simla • 8-9-2020 No comments

What settings do i use for daily wash and dry

Answer this question

View the manual for the Whirlpool ADG 8200 IX here, for free. This manual comes under the category Dishwashers and has been rated by 1 people with an average of a 7.9. This manual is available in the following languages: English. Do you have a question about the Whirlpool ADG 8200 IX or do you need help? Ask your question here

Whirlpool ADG 8200 IX specifications

General
Brand Whirlpool
Model ADG 8200 IX
Product Dishwasher
Language English
Filetype PDF

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Whirlpool ADG 8200 IX.

Is your question not listed? Ask your question here