Whirlpool is a registered trademark of Whirlpool USA
EN -1-
Chart
(see at right for options description)
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarily paused: the
Start indicator blinks.
To resume the cycle push the Start button and
close the door within 3 seconds.
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter ”What to do if...”.
1)Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary
depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration
system.
2)Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/
Standard loading comparison test and other tests, contact using following address: “contact@whirlpool.com”.
*Power consumption in: Left-on mode: 0.70 W / Off mode: 0.40 W.
Table of programs
Deter-
gent
Consumption
Drying
Phase
P
Programs
Available
options
Loading instructions
LitreskWh
Minutes
1)
1
Pre-Wash cold
DelayCrockery to be washed later.—4.00.0114-16NO
2
Fragile 40°C
Delay
Light soiling, for example glasses
and cups.
X10.50.85105-114Light
3
Rapid45°C
Delay
Lightly soiled crockery, with no
dried-on food.
X11.00.8530-50NO
4
Eco
2)
50°C
Delay,
1/2 Load
Normally soiled crockery.
Standard program, the most
efficient in terms of its combined
energy and water consumption.
X12.01.02170Full
5
Intensive65°C
Delay
Recommended program for heavily
soiled crockery, especially suitable
for pans and saucepans.
X15.01.60165-175Full
5019 300 02358
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATORWhen lit (at the end of the cycle), the salt reservoir needs to be refilled. RINSE AID INDICATORWhen lit (at the end of the cycle), the rinse aid dispenser needs to be refilled.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
1/2 LOAD BUTTONHalf load cycle can be used for the upper or lower rack.Select the required program then press the “Half Load” button - the light comes on.Turns off at the end of the program.The “Half Load” option can be used with the programs indicated in the table of programs.DELAYED START BUTTONThe wash cycle can be programmed to start after 2, 4 or 8 hours. Then press the Start button. The wash program will start after the set time.TABLET SETTINGThis setting allows to optimize the cycle performances according the type of detergent used.Push the Tablet button for 3 seconds (until the indicator lights up) if you are using the combined detergents in tablet (rinse aid, salt and detergent in 1 dose).If you are using powder detergent or liquid detergent, the Tablet indicator on the control panel has to be off.
Quick reference guide
Whatsapp
Mail
Facebook
Need help?
Number of questions: 0
Do you have a question about the Whirlpool ADG 6200 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Whirlpool ADG 6200 owners to properly answer your question.
About the Whirlpool ADG 6200
View the manual for the Whirlpool ADG 6200 here, for free. This manual comes under the category Dishwashers and has been rated by 1 people with an average of a 8.9. This manual is available in the following languages: English. Do you have a question about the Whirlpool ADG 6200 or do you need help? Ask your question here
Below, you will find the most frequently asked questions about the Whirlpool ADG 6200.
What do I do about a smelly dishwasher?
In the case of a smelly dishwasher, you can take the following steps:
- Clean the filters
- Clean the spray arms
- Clean the door rubbers
- Run a hot wash program
- Run an empty machine with a dishwasher cleaner
Do you have to pre-rinse the dishes?
It is not recommended to rinse dirty dishes before placing them in the dishwasher.
For the life cycle of the machine, it is better to put everything dirty in the dishwasher.
The grease on the dirty dishes is the lubrication for the pump in the machine.
How much dishwashing detergent should I use?
The average amount used is about 25 grams of dishwashing detergent. It is recommended to follow the advice on the packaging.
How do I add softening salt to my dishwasher?
Each dishwasher has a separate compartment for softening salt. It opens when you turn the knob on the compartment. The softening salt can then be poured into the compartment by means of a funnel.
What is the weight of the Whirlpool ADG 6200?
The Whirlpool ADG 6200 has a weight of 41000 g.
What is the height of the Whirlpool ADG 6200?
The Whirlpool ADG 6200 has a height of 820 mm.
What is the width of the Whirlpool ADG 6200?
The Whirlpool ADG 6200 has a width of 597 mm.
What is the depth of the Whirlpool ADG 6200?
The Whirlpool ADG 6200 has a depth of 555 mm.
Is the manual of the Whirlpool ADG 6200 available in English?
Yes, the manual of the Whirlpool ADG 6200 is available in English .
