WAGAN Power Dome NX manual

WAGAN Power Dome NX
8.7 · 16
PDF manual
 · 19 pages
English
manualWAGAN Power Dome NX

www.wagan.com

Power Dome™ NX by Wagan Tech

2
© 2010 Wagan Corporation.
All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.

User’s Manual—Please read before using this equipment.

3

POWER DOME NX COMPONENTS

LEFT SIDE:

1. Inverter AC Outlets
2. Inverter ON/OFF Switch
3. Work Light
4. Black Negative (−) Jumper Cable
5. Inverter Power Indicator
6. 25 Amp Fuse
7. USB/DC Power Indicator
8. USB/DC Power Switch
9. Hazard Flasher Lens
10. Compressor Hose
11. USB Power Port
12. DC Power Port
13. Compressor Pressure Gauge
14. Battery Status Voltmeter
15. Charging Indicator
16. Charging Jack
17. Battery Check Button
18. Compressor ON/OFF Switch
19. Work-Light/Blinker/OFF Switch
20. Red Positive (+) Jumper Cable
13.
14.
15.
17.
16.
19.
18.
20.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.

RIGHT SIDE:

*MP3 player and Audio
Cable not included
21. Extendable Antenna
22. Jump Starter Safety Switch
23. 3.5mm Audio Input Jack
24. Red Positive (+) Jumper Cable
25. Storage Compartment
26. Rubber Handle
27. Clock Radio LED Display
28. Clock Radio Controls
29. Speakers
26.
27.
28.
29.
21.
23.
22.
24.
25.

View the manual for the WAGAN Power Dome NX here, for free. This manual comes under the category chargers for mobile devices and has been rated by 16 people with an average of a 8.7. This manual is available in the following languages: English. Do you have a question about the WAGAN Power Dome NX or do you need help? Ask your question here

Need help?

Do you have a question about the WAGAN and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 4
R
Rene LozaAugust 22, 2022

"Did the batteries burn out because the connecting rod of the compressor that moves the piston up and down broke? Do you have the little compressor?"

"Did the batteries burn out because the connecting rod of the compressor that moves the piston up and down broke? Do you have...
zoom-in
View photo
This message has been automatically translated
T
Tyrone James June 7, 2015

How long do I recharge so it can work good and also my charging indicator staying on when I'm not charging it it has not went off for two days

T
Terence SheahanJanuary 16, 2023

How do I know when the battery is fully charged? The light is solid red all the time on power dome nx . Have replaced with new battery.

E
Ezoo abotalibSeptember 9, 2020

Why when i connect the powerdomenx2 to ac charger its just flashing red light ?

The WAGAN Power Dome NX is a versatile charger designed for auto and outdoor use. It is compatible with a wide range of mobile devices, making it a universal charger. The charger can be powered by both AC and battery sources, providing flexibility in different situations. One of the key features of the WAGAN Power Dome NX is its power protection capabilities. It has built-in safeguards to prevent overheating and overloading, ensuring the safety of both the charger and the connected devices. This overheat protection feature enhances the durability and longevity of the product. For charging convenience, the WAGAN Power Dome NX is equipped with a single USB 2.0 port. This allows users to connect their devices and charge them efficiently. LED indicators are present, providing a visual indication of the charging status. The charger comes with a built-in sealed lead acid (VRLA) battery with a capacity of 14000 mAh. This large capacity battery ensures extended usage and allows for multiple device charges before needing to be recharged. However, it is important to note that the charger has a basic device charge time of 38 hours, which may be longer compared to other chargers on the market. In terms of portability, the WAGAN Power Dome NX weighs approximately 8200 grams. While its weight might be a consideration for those seeking ultra-portability, it offers a robust and sturdy build that ensures a reliable charging experience. Overall, the WAGAN Power Dome NX is a versatile and durable charger for mobile devices. Its wide compatibility, power protection features, and convenient USB port make it a practical choice for auto and outdoor charging needs.

General
BrandWAGAN
ModelPower Dome NX | 2485
Productcharger for mobile device
EAN191120020075, 84367024855, 0084367024855, 0191120020075
LanguageEnglish
FiletypeUser manual (PDF)
Performance
Charger typeAuto, Outdoor
Charger compatibilityUniversal
Power source typeAC, Battery
Compatibility-
Power protection featuresOverheating, Overload
Operating principleContact
USB 2.0 ports quantity1
Other features
Overheat protectionYes
Built-in batteryYes
Battery technologySealed Lead Acid (VRLA)
Battery capacity14000 mAh
Basic device charge time38 h
Connector(s)2 x DC 12V
AC outlets quantity2 AC outlet(s)
Design
LED indicatorsYes
Product colorBlack, Red
Weight & dimensions
Weight8200 g
Weight8200 g
Packaging data
Quantity per pack1 pc(s)
Cables includedAC, DC
Power
Power supply200 W
Power source typeAC, Battery
Features
Charger compatibilityUniversal
Battery technologySealed Lead Acid (VRLA)
LED indicatorsYes
Product colorBlack, Red
Packaging content
Cables includedAC, DC
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the WAGAN Power Dome NX below.

What is the weight of the WAGAN Power Dome NX?

The WAGAN Power Dome NX has a weight of 8200 g.

Does the WAGAN Power Dome NX have overheat protection?

Yes, the WAGAN Power Dome NX has overheat protection. This ensures the safety of the charger and prevents any damage caused by overheating.

How many USB 2.0 ports does the WAGAN Power Dome NX have?

The WAGAN Power Dome NX has 1 USB 2.0 port. This allows the user to charge their mobile devices conveniently.

Does the WAGAN Power Dome NX have a built-in battery?

Yes, the WAGAN Power Dome NX has a built-in battery. This means that it can provide power to mobile devices even when not connected to an external power source.

What is the battery capacity of the WAGAN Power Dome NX?

The battery capacity of the WAGAN Power Dome NX is 14000 mAh. This high capacity allows for multiple device charges before the charger needs to be recharged itself.

How many AC outlets does the WAGAN Power Dome NX have?

The WAGAN Power Dome NX has 2 AC outlets. This provides convenient power access for electronic devices that require a standard wall outlet.

How do I check the current state of charge on the internal battery of the WAGAN Power Dome NX charger for mobile device?

To check the current state of charge on the internal battery of the WAGAN Power Dome NX charger for mobile device, follow these steps: 1. Make sure all chargers are disconnected from the Power Dome NX. 2. Press and hold the battery status button on the Power Dome NX. 3. The battery status meter (DC voltmeter) will indicate the voltage of the battery. 4. Read the battery status (voltage) when the chargers are disconnected. - If the voltage is 12.6 V DC or higher, the battery is ready to use. - If the voltage is 12.0 V DC or lower, the battery needs to be recharged. - If the voltage is less than 10.5 V DC, the battery is discharged and needs to be recharged immediately. It is recommended to recharge the Power Dome NX every 3 months if it is not being used. To recharge the Power Dome NX using AC power, follow the instructions provided in the manual.

What should I do if the battery status indicators on the Power Dome NX are not displaying correctly?

If the battery status indicators on the Power Dome NX are not displaying correctly, you can try the following troubleshooting steps: 1. Check the power connection: Ensure that the Power Dome NX is properly connected to a power source. Make sure the AC or DC charging adapter is securely plugged into the Power Dome NX and the power outlet or vehicle's power port. 2. Restart the Power Dome NX: Turn off the Power Dome NX and disconnect it from the power source. Wait for a few seconds, then reconnect it and turn it back on. This can help reset the indicators. 3. Check the battery voltage manually: Use a voltmeter to measure the voltage of the Power Dome NX battery. Compare the measured voltage with the expected voltage range mentioned in the manual. If the measured voltage is significantly different, it may indicate a problem with the battery. 4. Recharge the Power Dome NX: If the battery voltage is low, recharge the Power Dome NX using the appropriate charging adapter. Follow the instructions provided in the manual for the recommended charging duration. 5. Contact customer support: If the battery status indicators still do not display correctly after trying the above steps, it is recommended to contact WAGAN customer support for further assistance. They can provide specific troubleshooting guidance or arrange for repairs if necessary. Remember to refer to the manual for detailed instructions and safety precautions related to troubleshooting the battery status indicators on the Power Dome NX.

How long does it take to fully charge the Power Dome NX using the AC charging adapter?

To fully charge the Power Dome NX using the AC charging adapter, follow these steps: 1. Make sure all Power Dome switches are set to OFF. 2. Open the dust cover on the Charging Jack. 3. Connect the AC Charging Adapter to the AC outlet. 4. Plug the Charging Adapter's cord into the Power Dome's Charging Jack. 5. The Charging Indicator will light up during the charging process. 6. The initial AC charge can take up to 48 hours, so leave the Power Dome connected to the AC power source. 7. Do not charge for more than 48 hours to prevent overcharging. 8. After charging the battery, disconnect the adapter from the AC outlet first, then from the charging jack. 9. Replace the dust cover on the charging jack. It is important to note that the charging time may vary depending on the current state of the battery and the charging conditions. It is recommended to refer to the manual for more specific information on charging times and safety precautions related to charging the Power Dome NX using the AC charging adapter.

What should I do if the Power Dome NX is not charging properly with the DC charging adapter in my vehicle?

If the Power Dome NX is not charging properly with the DC charging adapter in your vehicle, you can try the following troubleshooting steps: 1. Check the power connection: Ensure that the DC charging adapter is securely plugged into the Power Dome NX and the vehicle's power port. Make sure there is no loose connection or debris obstructing the charging port. 2. Verify the vehicle's power source: Check if the vehicle's power port is functioning properly. Try using the power port with another device or charging adapter to confirm if it is providing power. 3. Restart the Power Dome NX: Turn off the Power Dome NX and disconnect it from the DC charging adapter. Wait for a few seconds, then reconnect it and turn it back on. This can help reset the charging process. 4. Check the vehicle's engine: Ensure that the vehicle's engine is running while charging the Power Dome NX. Some vehicles may require the engine to be running for the power port to provide sufficient power. 5. Test with another DC charging adapter: If possible, try using a different DC charging adapter to see if the issue is with the original adapter. This can help determine if the problem lies with the adapter or the Power Dome NX. 6. Contact customer support: If the Power Dome NX still does not charge properly after trying the above steps, it is recommended to contact WAGAN customer support for further assistance. They can provide specific troubleshooting guidance or arrange for repairs if necessary. Remember to refer to the manual for detailed instructions and safety precautions related to troubleshooting the charging issues with the Power Dome NX using the DC charging adapter in a vehicle.

How do I access the storage compartment and handle on the Power Dome NX?

To access the storage compartment and handle on the Power Dome NX, follow these steps: 1. Locate the storage compartment: The storage compartment is located on the side of the Power Dome NX. 2. Open the storage compartment: Slide the latch or unlock mechanism to open the storage compartment. 3. Store or retrieve items: Use the storage compartment to store small accessories or items that you may need while using the Power Dome NX. 4. Close the storage compartment: After storing or retrieving items, close the storage compartment securely to ensure everything is safely stored. 5. Locate the handle: The handle is located on the top of the Power Dome NX. 6. Lift the Power Dome NX: Grasp the handle firmly and lift the Power Dome NX to carry or transport it. 7. Ensure the handle is securely attached: Make sure the handle is securely attached to the Power Dome NX before lifting or carrying it. 8. Use the handle for stability: The handle provides stability and grip while carrying the Power Dome NX. Remember to refer to the manual for any specific instructions or safety precautions related to accessing the storage compartment and using the handle on the Power Dome NX.

Is the manual of the WAGAN Power Dome NX available in English?

Yes, the manual of the WAGAN Power Dome NX is available in English .

Is your question not listed? Ask your question here

No results