Voltcraft DT-30LK manual

Voltcraft DT-30LK
8.4 · 1
PDF manual
 · 64 pages
English
manualVoltcraft DT-30LK
Bedienungsanleitung

DT-30LK Drehzahlmesser

Best.-Nr. 1012206
Seite 2 - 16
Operating Instructions

DT-30LK Tachometer

Item No. 1012206 Page 17-31
Mode d’emploi

DT-30LK Compte Tours/Min

Nº de commande 1012206 Page 32-46
Gebruiksaanwijzing

DT-30LK Toerentalmeter

Bestelnr. 1012206 Pagina 47-63

View the manual for the Voltcraft DT-30LK here, for free. This manual comes under the category tachometers and has been rated by 1 people with an average of a 8.4. This manual is available in the following languages: English. Do you have a question about the Voltcraft DT-30LK or do you need help? Ask your question here

Need help?

Do you have a question about the Voltcraft and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

General
BrandVoltcraft
ModelDT-30LK | DT-30LK
Producttachometer
EAN4016138861648
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Voltcraft DT-30LK below.

How should I insert or replace the battery in the Voltcraft DT-30LK tachometer?

To insert or replace the battery in the Voltcraft DT-30LK tachometer, follow these steps: 1. Use a Phillips screwdriver to loosen the screw from the battery compartment lid and remove the lid. 2. Connect a 9 V block battery to the corresponding connection inside the battery compartment. Ensure correct orientation without applying force. 3. Store the battery and the cable inside the compartment and close it, ensuring the cable is not pinched. 4. Replace the battery when "BAT" appears on the display or if the tachometer is not used for a long time. 5. To attach the case handle, insert the pegs on the handle into the holes on the case lock, stretching the handle carefully. 6. Remove the handle by reversing the attachment steps.

How do I conduct contact measurements with the Voltcraft DT-30LK tachometer?

To conduct contact measurements with the Voltcraft DT-30LK tachometer, follow these steps: 1. Screw the included extension attachment into the thread on the device. 2. Screw the adapter holder into the extension attachment thread. 3. Select one of the three contact adapters: Outer cone for concave shaft ends, Inside cone for conical shaft ends, or Friction wheel for measuring belt speed. 4. Place the chosen contact adapter on the adapter holder's axis, aligning the axis locking pin with one of the short slots. 5. Press the MEAS button briefly to turn on the device. 6. Use the MEM button to select a memory cell for storing measured values. 7. Choose the desired unit of measurement by pressing the MODE button. 8. Press and hold the MEAS button, then press the contact adapter against the test object at a right angle. 9. Release the MEAS button when measurement is complete, and the device will turn off automatically after 15 seconds.

Is the manual of the Voltcraft DT-30LK available in English?

Yes, the manual of the Voltcraft DT-30LK is available in English .

Is your question not listed? Ask your question here

No results