information necessary to install, operate, and maintain
the V-9928, 5 Watt Amplifier with Volume Control.
Provides up to 5 watt of audio power for one-way
Electronic key or PABX page port
Use for remote amplifier
The V-9928, 5 watt amplifier with volume control,
will drive 6 (six) 45 Ohm speakers.
4.5"H x 2.75"W x 2.8"D
(11.43cm H x 6.99cm W x 7.11cm D)
0.8 lb. (.36 kg)
Voltage Range: –21 to –26 Vdc signal battery
Idle Current: 8 mA
Operating Current: 267 mA
Frequency response 80 Hz to 10,000 Hz + 3 dB
600 Ohm input
8 Ohm output
8 mA at 1000 Hz idle
267 mA at 1000 Hz operating
Mount the V-9928 to any suitable surface using two
screws to fasten the box to the surface.
Audio and Power Connections
Standard twisted pair telephone cable.
a. Connect amplifier input to terminals of the page
output terminals of the telephone system.
b. Connect amplifier output terminals to speaker
c. Connect battery and ground terminals of V-9928
to signal battery and signal ground respectively.
Refer to Figure 1 for connections.
Number of questions: 0
Do you have a question about the Valcom V-9928 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Valcom V-9928 owners to properly answer your question.
About the Valcom V-9928
View the manual for the Valcom V-9928 here, for free. This manual comes under the category Receivers and has been rated by 1 people with an average of a 9.4. This manual is available in the following languages: Engels. Do you have a question about the Valcom V-9928 or do you need help? Ask your question here