Vaddio RoboSHOT 12E HDBT manual

Vaddio RoboSHOT 12E HDBT
6.8 · 1
PDF manual
 · 140 pages
English
manualVaddio RoboSHOT 12E HDBT

Camera Behavior Settings – RoboSHOT 12 and RoboSHOT 30

Older RoboSHOT cameras use DIP switches to set camera behaviors; the RoboSHOT Elite series
cameras set all camera behaviors in the web interface.
A label on the bottom of the camera provides a quick reference for setting the switches.
Set the switches appropriately before mounting the camera.
After the camera is installed, you can read the switches from the camera's web interface.
Note
When the camera is not inverted, DIP switches are in their default positions when they are up.
(RoboSHOT 30 shown; Switch 5 is Super Wide Mode if the camera is a RoboSHOT 12.)
IR1, IR2, IR3 (Frequency Selection): If there are multiple cameras in the room, use switches 1 and 2 to
configure each with a different IR frequency to allow the IR Remote Commander to control them
independently. Then use the Camera Select buttons at the top of the remote to select the camera you want
to control.
n SW1 and SW2 up: IR frequency 1
n SW1 down, SW2 up: IR frequency 2
n SW1 up, SW2 down: IR frequency 3
IR Out: Leave switch 3 UP if the IR remote will be used. If the system will be controlled from another
device, set the switch DOWN. This turns off the IR sensors in the front of the camera, so that all control is
via the RS-232 connection.
Image Flip: If mounting the camera upside-down, set switch 4 DOWN: IMAGE FLIP ON. This orients the
video image correctly and sets the tilt motors to respond appropriately to tilt up and down commands from
the remote, web interface, and connected control devices.
Super Wide Mode (RoboSHOT 12 only): To use Super-wide mode, set switch 5 DOWN. This gives
12X zoom with a 73º horizontal field of view. Normal mode provides 10X zoom with a 67.2º horizontal field
of view (HFOV).
Baud Rate:Set switch 6 to the baud rate of the device connected to the RS-232 port. The default is 9600
bps. The 38400 baud setting is optional if the connected control device supports it.
For RoboSHOT 30, Switch 5 is not used. Switches 7 and 8 are not currently used on either RoboSHOT
12 or RoboSHOT 30.
28
Complete Manual for RoboSHOT CAT-5 Professional PTZ Camera Systems

Manual

View the manual for the Vaddio RoboSHOT 12E HDBT here, for free. This manual comes under the category video conferencing systems and has been rated by 1 people with an average of a 6.8. This manual is available in the following languages: English. Do you have a question about the Vaddio RoboSHOT 12E HDBT or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Vaddio and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Vaddio RoboSHOT 12E HDBT specifications

Below you will find the product specifications and the manual specifications of the Vaddio RoboSHOT 12E HDBT.

General
BrandVaddio
ModelRoboSHOT 12E HDBT | 999-99600-000W
Productvideo conferencing system
EAN0840077504083
LanguageEnglish
FiletypeUser manual (PDF)
Camera
Megapixel8.57 MP
Sensor typeCMOS
Optical sensor size1/2.5 "
Effective sensor resolution8.51 MP
Optical zoom12 x
Focal length range4.4 - 88.4 mm
Horizontal field of view (wide)70.2 °
Horizontal field of view (tele)4.1 °
Minimum illumination1.6 lx
White balanceATW, Auto, Indoor, Manual, One push, Outdoor
Auto focusing (AF) modesOne Push Trigger
Signal-to-Noise Ratio (SNR)50 dB
Focus adjustmentAuto/Manual
Closest focusing distance0.08 m
Wide Dynamic Range (WDR)Yes
Back Light Compensation (BLC)Yes
Number of camera presets17
Aperture number of steps16
Gain control typeAuto/Manual
Aspect ratio3:2, 4:3, 16:9
PTZ controlYes
Aperture range (F-F)2 - 3.8
Slowest camera shutter speed1 s
Fastest camera shutter speed1/10000 s
Power
Power source typePoE
Operational conditions
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)20 - 80 %
Audio
Noise reductionYes
Network
Network streamingYes
Video
Maximum video resolution1920 x 1080 pixels
Supported video modes720p, 1080i, 1080p
Maximum frame rate60 fps
HD typeFull HD
Video formats supportedH.264
Design
Product colorWhite
Mounting typeStand
Tilt angle range-30 - 90 °
Pan range-160 - 160 °
Web-based managementYes
Tilt speed (min)0.35 °/sec
Tilt speed (max)120 °/sec
Pan speed (min)0.35 °/sec
Pan speed (max)120 °/sec
Ports & interfaces
HDMI ports quantity1
Power over Ethernet plus (PoE+) ports quantity1
RS-232 ports1
Weight & dimensions
Width179.1 mm
Depth171.5 mm
Height176.3 mm
Weight2200 g
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Vaddio RoboSHOT 12E HDBT below.

What is the weight of the Vaddio RoboSHOT 12E HDBT?

The Vaddio RoboSHOT 12E HDBT has a weight of 2200 g.

What is the height of the Vaddio RoboSHOT 12E HDBT?

The Vaddio RoboSHOT 12E HDBT has a height of 176.3 mm.

What is the width of the Vaddio RoboSHOT 12E HDBT?

The Vaddio RoboSHOT 12E HDBT has a width of 179.1 mm.

What is the depth of the Vaddio RoboSHOT 12E HDBT?

The Vaddio RoboSHOT 12E HDBT has a depth of 171.5 mm.

Is the manual of the Vaddio RoboSHOT 12E HDBT available in English?

Yes, the manual of the Vaddio RoboSHOT 12E HDBT is available in English .

Is your question not listed? Ask your question here

No results