L
E
A
R
N
O
N
/O
F
F
L
E
A
R
N
O
N
/O
F
F
L
E
A
R
N
O
N
/O
F
F
RC270+TR430 Indoor Remote Control Set OWNERS MANUAL Congratulations on your
purchase of a UPM
remote control set. Please
take the time to read and
understand this manual so
you can begin to enjoy the
convenience this product
can offer.
FEATURES ! 433 MHz RF technology ! Control up to 4 remote receivers
! ON/OFF function ! 15A / 1800W resistive ! Transmission range of up to 130 feet in open
area
GETTING STARTED battery installation LEARN FUNCTION 1
2
remove the battery cover from
the back of the transmitter
place two button cell batteries
between terminals observing
proper polarity then replace cover
2
Press LEARN on receiver while
simultaneously pressing the desired
channel button on the transmitter
Receiver
Transmitter
Batteries are not required in the
RC270 receiver. T wo button cell
batteries are included for the TR430
transmitter
3
the green LED will light up
with any key press once the
battery is installed correctly
1
Plug receiver into wall socket
4
If LEARN is completed successfully,
the LED on the receiver should light
up when ON is pressed
button descriptions ON/OFF
LEARN - used when
programming receiver
channel
2
The ON/OFF button on the receiver
also turns power on and off
1
Power On/Off by using the ON/OFF
keys on the transmitter
ON/OFF FUNCTION 2
2
3
4
3
Repeat and for any additional
receivers (available at your local
retailer)
1
2
CH 1 OFF
CH 4 OFF
ALL OFF
CH 3 OFF
CH 2 OFF
CH 1 ON
CH 4 ON
ALL ON
CH 3 ON
CH 2 ON
LED Indicator
1
2
3
1
TROUBLESHOOTING Transmitter stops turning
receiver on and off.
Use the LEARN function to
reprogram the receiver
or
Check the battery
problem solution TECHNICAL SPECIFICATIONS Ratings: 120 V AC
Maximum Load: 1800W resistive; 600W tungsten
Transmission Range: up to 130 feet in open area
Transmission Frequency: 433.92 MHz
This device complies with Part 15 of the FCC Rules of Operation and is
subjected to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired operation.
FCC COMPLIANCE LEAR
N
ON/
OFF
*
If you have more than one receiver set up,
you can use the ALL ON or ALL OFF
button to simultaneously turn ALL the
receivers ON or OFF .
*
http://waterheatertimer.org/UPM-timers-and-manuals.html
Need help?
Do you have a question about the UPM and is the answer not in the manual?
Question and answer
Number of questions: 0