If you can make a local call by dialing only 7 digits instead of 10, you can program your local area code in your
phone. If you get a call from within your area code, you will only see the 7-digit phone number. If you get a call from
outside your area code, you will see all 10 digits. To enter an area code, follow the steps below:
Press
[menu/clear]. Select the GLOBAL SETUP menu, and then the AREA CODE submenu.
Use the number keypad
[0] to [9] to enter a 3-digit area code. If an area code has already been stored, it will
appear in the display. Press [menu/clear] to delete the stored code, and then enter a new one.
Press. A conrmation tone sounds.
NOTE: Do not program an area code if you must dial all 10 digits to make a local call.
Using.the.DirectLink.Feature
Using the DirectLink feature, a pair of handsets can function as two-way radios. You can
have up to two pairs of handsets using DirectLink at a time. DirectLink communication does
not interfere with the main base’s ability to make or receive telephone calls. You must set
both handsets to use DirectLink communication to activate this feature. Other handsets can
be used while two handsets are in DirectLink communication; however, the two handsets in
DirectLink operation are not able to make or receive calls until DirectLink communication is
canceled.
Press
[menu/clear]and move the cursor to the DIRECTLINK MODE menu.
Press
. The display shows TO ENTER DIRECTLINK MODE
PRESS SELECT.
Press
. A conrmation tone sounds, and DIRECTLINK MODE
COMPLETE appears in the display.
1.
2.
3.
1.
2.
3.
Manual
View the manual for the Uniden DCT 736 here, for free. This manual comes under the category phones and has been rated by 1 people with an average of a 9.4. This manual is available in the following languages: English. Do you have a question about the Uniden DCT 736 or do you need help? Ask your question here
Need help?
Do you have a question about the Uniden and is the answer not in the manual?
Question and answer
Number of questions: 0