View the manual for the Tunturi F330 here, for free. This manual comes under the category hometrainers and has been rated by 2 people with an average of a 5.8. This manual is available in the following languages: English. Do you have a question about the Tunturi F330 or do you need help? Ask your question here
| Brand | Tunturi |
| Model | F330 |
| Product | hometrainer |
| Language | English |
| Filetype | User manual (PDF) |
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Tunturi F330 below.
As an adult, it is recommended to do moderately intensive exercise for at least 2.5 hours per week. Preferably spread over several days.
As a rule of thumb for your maximum heart rate, you can use 220 minus your age.
To properly adjust the seat height on the Tunturi F330 hometrainer, follow these steps: 1. Start by loosening the locking knob under the seat by turning it counterclockwise. This will allow the seat tube to move freely up and down. 2. Adjust the seat height so that the middle part of your foot reaches the pedal with your leg almost straight and the pedal at its lowest point. Make sure to keep your back straight during this process. 3. Once you have set the desired seat height, release the locking knob. The seat will lock into place. 4. Tighten the locking knob by turning it clockwise to secure the seat in its adjusted position. It is important to note that you can also adjust the horizontal seat position forward and back by loosening the locking screws under the seat. Additionally, you can adjust the seat inclination from this position. Always ensure that the locking screws under the seat are properly fastened before starting to exercise. Similarly, make sure that the locking knob is securely fastened to prevent any movement during your workout. By following these steps, you can properly adjust the seat height on the Tunturi F330 hometrainer for a comfortable and effective exercise experience.
To troubleshoot why the resistance level is not changing on the Tunturi F330 hometrainer, follow these steps: 1. Check if the adjustment knob at the top of the handlebar support tube is properly tightened. If it is loose, tighten it by turning it clockwise. 2. Ensure that the adjustment knob is not stuck or obstructed. Clean any dirt or debris that may be preventing it from turning smoothly. 3. Verify that the scale above the adjustment knob is functioning correctly. Make sure it is aligned with the desired resistance level. If it is not, try turning the knob in both directions to see if the scale responds. 4. If the resistance level still does not change, check the connection between the adjustment knob and the resistance mechanism. Ensure that there are no loose or disconnected parts. 5. If none of the above steps resolve the issue, it is recommended to contact Tunturi customer support for further assistance. They can provide specific troubleshooting steps or arrange for a repair if necessary. By following these steps, you can troubleshoot and address the issue of the resistance level not changing on the Tunturi F330 hometrainer.
To attach the rear support to the frame during the assembly of the Tunturi F330 hometrainer, follow these steps: 1. Lift the equipment frame onto the top of the package. 2. Take the rear support and align it with the frame. 3. Use the four black washers and four black Allen screws to secure the rear support to the frame. Tighten the screws carefully in a crosswise pattern. 4. After one hour of use, check that the screws are tight to ensure the stability of the rear support. By following these steps, you can successfully attach the rear support to the frame of the Tunturi F330 hometrainer during the assembly process.
If the display screen on the Tunturi F330 hometrainer is not showing any data when you start using it, you can try the following steps to troubleshoot the issue: 1. Check if the batteries in the meter are properly installed and have sufficient power. If the battery level is low, replace the batteries with new ones. 2. Ensure that the meter is switched on by either starting to pedal or pressing any key on the meter. The meter should automatically switch on when you start pedaling or press a key. 3. Verify that the meter is not in sleep mode. If the meter has not detected any activity for about 4 minutes, it may go into sleep mode to conserve power. Try pressing any key on the meter to wake it up. 4. Make sure that the meter is not exposed to direct sunlight, as this can damage the display. Also, protect the meter from water and avoid severe impacts. 5. Check if the connections between the meter and the sensors are secure. Ensure that the sensors in the handlebars are in contact with your skin and slightly moist for reliable pulse measurement. If the issue persists after trying these steps, it is recommended to contact Tunturi customer support for further assistance. They can provide specific troubleshooting steps or arrange for a repair if necessary.
To ensure the safety of children while using the Tunturi F330 hometrainer, follow these steps: 1. Keep the hometrainer in a secure and designated area away from children's play areas to prevent accidental access. 2. Store the hometrainer in a locked room or use safety locks to prevent children from using it unsupervised. 3. Educate children about the potential dangers of the hometrainer and explain that it is not a toy. Emphasize that it should only be used by adults or under adult supervision. 4. Never leave the hometrainer unattended while it is in use, especially if there are children around. Supervise children closely to ensure they do not come into contact with moving parts or get their fingers caught. 5. Teach children to keep a safe distance from the hometrainer while it is in operation and to never touch or play with any buttons, knobs, or moving parts. By following these steps, you can help ensure the safety of children while using the Tunturi F330 hometrainer. It is important to prioritize their safety and provide proper supervision to prevent accidents or injuries.
Yes, the manual of the Tunturi F330 is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Tunturi and is the answer not in the manual?
Question and answer
Number of questions: 1On my Tunturi model E330 Ergometer / Tunturi E3**027684, the handle has become loose. When I tighten the two allen bolts, they just spin as if they are stripped out. But I believe the nuts on the backside have become loose and will not let it tighten. How do I get to these two nuts to tighten the handle so it doesn't wobble?