View the manual for the Troy-Bilt 2800 PSI 020676 here, for free. This manual comes under the category pressure washers and has been rated by 4 people with an average of a 7.7. This manual is available in the following languages: English. Do you have a question about the Troy-Bilt 2800 PSI 020676 or do you need help? Ask your question here
Troy-Bilt | |
2800 PSI 020676 | |
pressure washer | |
English | |
User manual (PDF) |
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Troy-Bilt 2800 PSI 020676 below.
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Troy-Bilt and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Troy-Bilt owners to provide you with a good answer.
Gas is getting from the tanK to the carburetor but not into the carburetor what would cause this?
** i realize that this is an old question **The 'needle' which is attached to the float, that opens a port to regulate incoming fuel from the tank is stuck closed, the main jet (integral within the 'bolt' holding the carb bowl on- this has a horizontal port through its base and a port drilled vertically for the passage of fuel) is plugged, or the emulsion tube passages are restricted or plugged.These carburetors are very reasonably priced on line. The questionable quality of fuel often causes corrosion within. I typically disassemble and soak these overnight in a carb cleaner, then insure that the individual passages are clear using compressed air and canned carb cleaner with the tube. (Protect your eyes)
What oil goes in the pump of troybilt 2800 max power washer
Non detergent sae 30
Where is the chock on a TROY-BILT pressure washer model # 020381, serial # 1017540428? And why can't I find a manual for it?
Will not crank
What oil used in pump
Bought this washer second hand. What kind of oil should I use in it
I just put on a new pump and water is shooting out between the pump and the base.
Engine not speeding up when trigger is depressed. When sped up by hand ( moving carb. linkage ) pressure washer seems to work
No pressure
Where do I find the model number on a Troy-Bilt 2800 PSI 020676? I need to order a pump, and I need it to find the right part. Is there another way to find the right part?
Why would the soap not be feeding when running
You need to use the correct spray tip (black).
Number of questions: 37