Toyota Corolla (2010) manual

1 mile equals 1.609344 kilometers and 1 kilometer equals 0.62137119 miles.

The location of the VIN number of the car differs per brand and type of car. The code may be stamped on the frame of the car or mounted on a plate. It is best to consult the manual of the Toyota Corolla (2010)for the exact location of the VIN number.

The VIN number of a car is an identification number unique to each car. The abbreviation VIN therefore stands for Vehicle Identification Number.

Regular maintenance is necessary for every car. How often the car needs maintenance and what exactly needs to be done can be found in the maintenance instructions. For major periodic service, this should generally be done every 2 years or after 30,000 kilometres.

It is recommended to change the brake fluid every two years.

E10 petrol consists of up to ten per cent ethanol while E5 petrol will contain less than five per cent ethanol. As a result, the percentage of E10 petrol is lower than that of E5 petrol, making it less bad for the environment.

The lock is most likely set to the child safety lock so it cannot be opened from the inside. How to unset the child safety lock differs per brand and type.

If your car radio does not turn on, it will not receive any power. Check that the red wire is connected to the contact power supply and the yellow wire to the constant power supply.

To change the oil in your Toyota Corolla (2010), you need to locate the oil drain plug underneath the engine and remove it using the appropriate wrench. Make sure to have a drain pan ready to collect the old oil. Once drained, replace the drain plug and proceed to remove the oil filter using the appropriate filter wrench. After installing a new oil filter, pour the recommended type and amount of oil into the engine through the oil filler cap.

To reset the maintenance light on your Toyota Corolla (2010), start with the key in the ignition but turned off. Press and hold the odometer/trip reset button, then turn the key to the "On" position without starting the engine. Continue holding the button until the maintenance light flashes and resets, which usually takes about 10 seconds. Once the light stops flashing, you can release the button, and the maintenance light should be reset.

The recommended tire pressure for your Toyota Corolla (2010) can be found on the driver's side doorjamb. There is usually a sticker that displays the correct tire pressure for both the front and rear tires. Make sure to check the tire pressure when the tires are cold and use a reliable tire pressure gauge to inflate or deflate the tires accordingly.

To replace a headlight bulb in your Toyota Corolla (2010), open the hood and locate the back of the headlight assembly. Depending on the specific bulb, you may need to remove a cover or disconnect a wiring harness. Once accessed, twist the bulb socket counterclockwise to remove it. Gently remove the old bulb and replace it with a new one, being careful not to touch the glass portion of the bulb. Reinstall the socket and any necessary covers or wiring harnesses, ensuring a secure fit.

To pair your smartphone with the Bluetooth system in your Toyota Corolla (2010), start by ensuring that both your phone and the car's Bluetooth system are in pairing mode. This usually involves enabling Bluetooth on your phone and accessing the Bluetooth settings in the car's audio system. Look for a "Pair" or "Add Device" option and select it. Follow the on-screen prompts or refer to your car's audio manual to complete the pairing process. Once paired, you should be able to make and receive calls and play audio through the car's speakers using your smartphone.

Yes, the manual of the Toyota Corolla (2010) is available in English .