Teac W-1200 manual

Teac W-1200
8.9 · 5
PDF manual
 · 96 pages
English
manualTeac W-1200
ENGLISH
29
ATTENTION
The automatic power saving function is only included in
European models.
The automatic power saving function is ON when this unit is shipped
new, so it will automatically turn off if 30 minutes pass under the
conditions shown below.
Status Cassette tape
No cassette tape
Stopped
Recording paused
Automatic power saving function active
Automatic power saving function not active
To reactivate the unit after it has turned off automatically, press the
POWER button on the main unit twice.

Changing the automatic power saving

setting

1 Stop both TAPE 1 and TAPE 2.

2 Press the TAPE 1 and TAPE 2 (8) buttons at the

same time to show the current setting (“Apwr
OFF” or “Apwr On”) in the tape counter area.

3 Use the TAPE 2 play (y) button to change the

setting.

4 Press the TAPE 2 stop (8) button to return to

the ordinary state.

Automatic power saving function Troubleshooting

If you experience a problem with the unit, please take a moment
to review the following information before requesting service.
Moreover, the problem might be caused by something other than
this unit. Please also check the operation of the connected units.
If it still does not operate correctly, contact the retailer where you
purchased the unit.
The unit does not turn on.
e Check that the power cord is plugged into a working power
outlet.
e Check that the power cord is properly connected to this unit.
e Check that the power cord is completely plugged into the
power outlet.
When the unit is turned on, playback/recording starts
unexpectedly.
e Set the TIMER switch to OFF.
Remote control does not work.
e Press the POWER button to turn the unit on.
e If the batteries are exhausted, replace both of them with new
ones.
e Point the remote control at the front panel of the unit from a
distance of less than about 5 m (16 ft).
e The remote control will not work if there is an obstruction
between it and the main unit. In this case, try changing the
position.
e Turn off any strong light source near this unit.
When using the remote control, a television or another
device operates in error.
e The use of this unit’s remote control might cause some tele-
visions with wireless remote control functions to operate
incorrectly. If this should occur, use the main units buttons.
The unit does not respond when buttons are pressed.
e The unit sometimes does not respond when buttons are
pressed during operation. Try pressing the button again after
waiting a little while.
e Load a cassette if one is not already loaded.
e Insert the cassette correctly.
Continued on the next page e

Manual

View the manual for the Teac W-1200 here, for free. This manual comes under the category cassette players and has been rated by 5 people with an average of a 8.9. This manual is available in the following languages: English. Do you have a question about the Teac W-1200 or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Teac and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Teac W-1200 specifications

Below you will find the product specifications and the manual specifications of the Teac W-1200.

The Teac W-1200 is a cassette deck that features two decks for enhanced audio playback. With a built-in microphone and microphone input, it allows for convenient recording and playback options. It offers various I/O ports including USB 2.0 B, 6.3mm Out, RCA In, and RCA Out, allowing for versatile connectivity options. In terms of dimensions, the Teac W-1200 has a width of 435 millimeters, a depth of 285.8 millimeters, and a height of 145 millimeters. With a weight of 4600 grams, it is a relatively lightweight and compact device. The package also includes a remote control for seamless operation from a distance. This cassette player offers a 6.3mm headphone connectivity option, enabling users to enjoy private listening experiences. It comes equipped with a single 6.3mm headphone output. The Teac W-1200 offers multiple cassette playback modes, including forward, pause, repeat, and stop. These playback options provide flexibility and control over audio playback. In summary, the Teac W-1200 is a cassette deck with two decks, built-in microphone, and microphone input. It features various I/O ports such as USB 2.0 B, 6.3mm Out, RCA In, and RCA Out. With its compact dimensions of 435mm x 285.8mm x 145mm and weight of 4600g, it is a portable and lightweight device. Additionally, it includes a remote control for convenient operation and a 6.3mm headphone output for private listening. Its diverse cassette playback modes, including forward, pause, repeat, and stop, provide users with enhanced playback options.

General
BrandTeac
ModelW-1200 | W-1200-B
Productcassette player
EAN4907034221967
LanguageEnglish
FiletypeUser manual (PDF), Datasheet (PDF)
Technical details
Device typeCassette deck
Number of decks2 deck(s)
Microphone inYes
I/O portsUSB2.0 B, 6.3mm Out, RCA In, RCA Out
Handheld remote controlYes
Cassette playback modesForward, Pause, Repeat, Stop
AutostopYes
Channels quantity2 channels
Cassette deck technologyLogic
Color
Product colorBlack
Audio
Built-in microphoneYes
Frequency range30 - 1500 Hz
Weight & dimensions
Width435 mm
Depth285.8 mm
Height145 mm
Weight4600 g
Display
Display type-
Ports & interfaces
Headphone connectivity6.3 mm
Headphone outputs1
Power
Power consumption (typical)22 W
Input voltage230 V
Input frequency50 Hz
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Teac W-1200 below.

What is the weight of the Teac W-1200?

The Teac W-1200 has a weight of 4600 g.

What is the height of the Teac W-1200?

The Teac W-1200 has a height of 145 mm.

What is the width of the Teac W-1200?

The Teac W-1200 has a width of 435 mm.

What is the depth of the Teac W-1200?

The Teac W-1200 has a depth of 285.8 mm.

How do I properly insert a cassette tape into the Teac W-1200?

Ensure that the cassette tape is properly aligned and flat, then gently insert it into the cassette slot of the Teac W-1200 until it clicks into place.

Why is my cassette tape not playing or producing any sound?

Make sure the cassette tape is properly seated in the tape deck and that it is not tangled or twisted. Also, check that the playback function is selected and the volume is turned up. If the issue persists, clean the tape heads with a head cleaning cassette to remove any dirt or debris.

How can I record audio from an external source using the Teac W-1200?

Connect your desired audio source (such as a microphone or another audio player) to the LINE IN jacks on the back of the Teac W-1200. Set the input selector to LINE and adjust the input level to an appropriate setting. Then, press the Record button and the Play button together to start recording.

How can I enhance the audio quality when recording with the Teac W-1200?

Ensure that the recording input level is properly adjusted to prevent distortion or clipping. Experiment with different recording levels until you achieve a balanced and clear sound. Additionally, using high-quality blank cassette tapes will contribute to better recording results.

Can I connect the Teac W-1200 to external speakers or headphones?

Absolutely! The Teac W-1200 has a built-in speaker, but you can also connect external speakers or headphones to the LINE OUT or HEADPHONES jack on the back of the unit for a more personalized listening experience.

Does the Teac W-1200 have a built-in microphone?

Yes, the Teac W-1200 has a built-in microphone. This means that the user can use the cassette player to record their own audio directly onto the cassette.

How many cassette decks does the Teac W-1200 have?

The Teac W-1200 has 2 cassette decks. This allows the user to play and record on separate decks, providing more versatility and convenience.

Can the Teac W-1200 be controlled remotely?

Yes, the Teac W-1200 comes with a remote control. This allows the user to control the cassette player from a distance, providing added convenience and ease of use.

What types of input and output ports does the Teac W-1200 have?

The Teac W-1200 has USB2.0 B, 6.3mm Out, RCA In, and RCA Out ports. This means that the user can connect the cassette player to other devices such as computers, speakers, and amplifiers for playback and recording.

Does the Teac W-1200 have autostop feature?

Yes, the Teac W-1200 has an autostop feature. This means that the cassette player will automatically stop playing or recording when the end of the tape is reached. This helps protect the cassette and prevents any damage from occurring.

Is the manual of the Teac W-1200 available in English?

Yes, the manual of the Teac W-1200 is available in English .

Is your question not listed? Ask your question here

No results