Teac W-1200 manual

Teac W-1200
8.9 · 5
PDF manual
 · 96 pages
English
manualTeac W-1200
ENGLISH
11
M MIC connector and mic LEVEL knob
When using a mic to record, insert the mic cable plug into this
connector and turn the knob to a suitable level (page21).
o This unit does not support stereo mics. Use a mono mic.
o When a mic is connected, the tape playback level is lowered
slightly. When the mic is disconnected, the playback level
will return to normal.
N REC LEVEL (recording level) knob
Use to adjust the recording level.
O PHONES jack/LEVEL knob
Plug headphones into this jack to use them with this unit.
Sound will be output from the LINE OUT jacks even when
headphones are plugged in here.
Use the LEVEL knob to the left to adjust the headphone
volume.

V

CAUTION
While wearing headphones, do not connect or discon-
nect them or turn the unit on or off. Doing so could result
in a sudden loud noise that could harm your hearing.
P TIMER switch
Use this switch to set the timer setting mode (record, off or
play). Leave this switch in the OFF position for normal use.
To use timer playback/recording, connect a commercially-avail-
able timer to this unit (page26).
Q NOISE REDUCTION switch
This function reduces hiss during tape playback.
o It only functions during playback.
o Using this during playback of tapes recorded with Dolby B
noise reduction will reduce hiss. This cannot be used when
recording to achieve a noise reduction effect like Dolby B.

Using the remote control

Precautions for use

V

Misuse of batteries could cause them to rupture or leak, which might result in fire, injury or the staining of nearby materials.Please carefully read and observe the precau-tions on page3.
o When using the remote control, point it toward the remote con-
trol signal receiver on the main unit from a distance of 5 m (16 ft)
or less. Do not place obstructions between the main unit and the
remote control.
o The remote control might not work if the remote control signal
receiver on the unit is exposed to direct sunlight or bright light. If
this occurs, try moving the unit.
o Beware that use of this remote control could cause the unin-
tentional operation of other devices that can be controlled by
infrared rays.

Installing batteries

Remove the cover from the back of the remote control and insert
two AA batteries with their ¥/^ oriented as shown in the case.
Replace the cover.

When to replace batteries

If the distance required between the remote and the main unit
decreases or if the unit stops responding to the remote buttons,
replace both batteries with new ones. Dispose of the used batteries
according to the instructions on them or requirements set by your
local municipality.

Manual

View the manual for the Teac W-1200 here, for free. This manual comes under the category cassette players and has been rated by 5 people with an average of a 8.9. This manual is available in the following languages: English. Do you have a question about the Teac W-1200 or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Teac and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Teac W-1200 specifications

Below you will find the product specifications and the manual specifications of the Teac W-1200.

The Teac W-1200 is a cassette deck that features two decks for enhanced audio playback. With a built-in microphone and microphone input, it allows for convenient recording and playback options. It offers various I/O ports including USB 2.0 B, 6.3mm Out, RCA In, and RCA Out, allowing for versatile connectivity options. In terms of dimensions, the Teac W-1200 has a width of 435 millimeters, a depth of 285.8 millimeters, and a height of 145 millimeters. With a weight of 4600 grams, it is a relatively lightweight and compact device. The package also includes a remote control for seamless operation from a distance. This cassette player offers a 6.3mm headphone connectivity option, enabling users to enjoy private listening experiences. It comes equipped with a single 6.3mm headphone output. The Teac W-1200 offers multiple cassette playback modes, including forward, pause, repeat, and stop. These playback options provide flexibility and control over audio playback. In summary, the Teac W-1200 is a cassette deck with two decks, built-in microphone, and microphone input. It features various I/O ports such as USB 2.0 B, 6.3mm Out, RCA In, and RCA Out. With its compact dimensions of 435mm x 285.8mm x 145mm and weight of 4600g, it is a portable and lightweight device. Additionally, it includes a remote control for convenient operation and a 6.3mm headphone output for private listening. Its diverse cassette playback modes, including forward, pause, repeat, and stop, provide users with enhanced playback options.

General
BrandTeac
ModelW-1200 | W-1200-B
Productcassette player
EAN4907034221967
LanguageEnglish
FiletypeUser manual (PDF), Datasheet (PDF)
Technical details
Device typeCassette deck
Number of decks2 deck(s)
Microphone inYes
I/O portsUSB2.0 B, 6.3mm Out, RCA In, RCA Out
Handheld remote controlYes
Cassette playback modesForward, Pause, Repeat, Stop
AutostopYes
Channels quantity2 channels
Cassette deck technologyLogic
Color
Product colorBlack
Audio
Built-in microphoneYes
Frequency range30 - 1500 Hz
Weight & dimensions
Width435 mm
Depth285.8 mm
Height145 mm
Weight4600 g
Display
Display type-
Ports & interfaces
Headphone connectivity6.3 mm
Headphone outputs1
Power
Power consumption (typical)22 W
Input voltage230 V
Input frequency50 Hz
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Teac W-1200 below.

What is the weight of the Teac W-1200?

The Teac W-1200 has a weight of 4600 g.

What is the height of the Teac W-1200?

The Teac W-1200 has a height of 145 mm.

What is the width of the Teac W-1200?

The Teac W-1200 has a width of 435 mm.

What is the depth of the Teac W-1200?

The Teac W-1200 has a depth of 285.8 mm.

How do I properly insert a cassette tape into the Teac W-1200?

Ensure that the cassette tape is properly aligned and flat, then gently insert it into the cassette slot of the Teac W-1200 until it clicks into place.

Why is my cassette tape not playing or producing any sound?

Make sure the cassette tape is properly seated in the tape deck and that it is not tangled or twisted. Also, check that the playback function is selected and the volume is turned up. If the issue persists, clean the tape heads with a head cleaning cassette to remove any dirt or debris.

How can I record audio from an external source using the Teac W-1200?

Connect your desired audio source (such as a microphone or another audio player) to the LINE IN jacks on the back of the Teac W-1200. Set the input selector to LINE and adjust the input level to an appropriate setting. Then, press the Record button and the Play button together to start recording.

How can I enhance the audio quality when recording with the Teac W-1200?

Ensure that the recording input level is properly adjusted to prevent distortion or clipping. Experiment with different recording levels until you achieve a balanced and clear sound. Additionally, using high-quality blank cassette tapes will contribute to better recording results.

Can I connect the Teac W-1200 to external speakers or headphones?

Absolutely! The Teac W-1200 has a built-in speaker, but you can also connect external speakers or headphones to the LINE OUT or HEADPHONES jack on the back of the unit for a more personalized listening experience.

Does the Teac W-1200 have a built-in microphone?

Yes, the Teac W-1200 has a built-in microphone. This means that the user can use the cassette player to record their own audio directly onto the cassette.

How many cassette decks does the Teac W-1200 have?

The Teac W-1200 has 2 cassette decks. This allows the user to play and record on separate decks, providing more versatility and convenience.

Can the Teac W-1200 be controlled remotely?

Yes, the Teac W-1200 comes with a remote control. This allows the user to control the cassette player from a distance, providing added convenience and ease of use.

What types of input and output ports does the Teac W-1200 have?

The Teac W-1200 has USB2.0 B, 6.3mm Out, RCA In, and RCA Out ports. This means that the user can connect the cassette player to other devices such as computers, speakers, and amplifiers for playback and recording.

Does the Teac W-1200 have autostop feature?

Yes, the Teac W-1200 has an autostop feature. This means that the cassette player will automatically stop playing or recording when the end of the tape is reached. This helps protect the cassette and prevents any damage from occurring.

Is the manual of the Teac W-1200 available in English?

Yes, the manual of the Teac W-1200 is available in English .

Is your question not listed? Ask your question here

No results