Sunstech RPDS200 manual

RP-DS200

INSTRUCTION MANUAL

AM/FM Portable Radio

INSTRUCTION MANUAL

Carefully read and understand instructions contained in this manual before operating the unit. Please refer to

this manual in case of doubts about functions of the product. Keep instructions for future reference.

Safety instructions

possible dangers on the apparatus or on its components the following symbols can be applied.

Power cord protection

To avoid any malfunctions of the unit and to protect against electric shock, fire or personal injury please

observe following instructions.

- Hold the plug firmly when connecting or disconnecting the AC power cord.

- Keep the AC cord away from heating appliances.

- Never put any heavy object on the AC power cord

- Do not attempt to repair or reconstruct the AC power cord in any way.

- Never make or change connections with the power switched on.

- Always make sure that power in your home can support power indicated in rating label of the unit or of its AC

adaptor.

- Do not overcharge multiple sockets or extension cables.

- During storm disconnect the unit from the mains.

- Do not use components or accessories different from the one supplied.

Placement

Do not expose the unit to direct sunlight, near radiators, in closed automobiles where it is possible to reach

high temperatures (over 35°), at high humidity levels (over 90%), in dusty areas as the internal parts may be

seriously damaged. Do not place the unit on sofa or carpet or near other objects but in a well-ventilated area.

Do not place the unit on an unstable surface to avoid falls and damage of the unit and of third party. Place the

unit in a horizontal and stable position, far from vibrations.

Non-use periods

When the unit is not being used, turn it off. When left unused for a long period of time the unit, the unit should

be unplugged from the household AC outlet and batteries should be taken out.

No finger or other objects inside

Touching internal parts of this unit is dangerous. Do not attempt to disassemble the unit. Do not put any

foreign object in the unit.

Keep away from water/magnet

Keep the unit away from flower vases, tubs, sinks, etc. If liquids are spilled into the unit, serious damage could

occur.

Never bring a magnet or magnetized object near the unit.

Stacking

Place the unit in horizontal position and do not place anything heavy on it.

Condensation

Moisture may form in the following conditions:

- Immediately after a heater has been turned on in a steamy or very humid room.

- When the unit is suddenly moved from a cold environment to a warm one.

If moisture forms inside the unit it may not operate properly. In this case turn on the power and wait about

one hour for the moisture to evaporate

DESCRIPTION

1. ANTENNA

2. LCD DISPLAY

3. MODE BUTTON

4. TUNING KNOB (TUNE+ / TUNE-)

5. SET BUTTON

6. RADIO ON / OFF BUTTON

7. PHONE JACK

8. VOLUME KNOB

9. ALARM 2 BUTTON

10. M- (MEMORY-) BUTTON

11. ALARM 1 BUTTON

12. M+ (MEMORY+) BUTTON

13. SNOOZE / SLEEP BUTTON

14. AM/FM BUTTON 19

15. BATTERY COMPARTMENT

16. SPEAKER

17. AC POWER SOCKET

18. HANDLE

19. RESET

THE NORMAL FUNCTION OF THE PRODUCT MAYBE DISTURBED BY STRONG ELECTRO

MAGNETIC INTERFERENCE. IF SO, SIMPLY RESET THE PRODUCT BY DISCONNECTING THE AC

PLUG TO RESUME NORMAL. IN CASE THE FUNCTION COULD NOT RESUME, PLEASE USE THE

PRODUCT IN OTHER LOCATION.

POWER OPERATION

THIS UNIT CAN BE OPERATION FOR BOTH AC 230V / 50HZ AND 4 X “AA” BATTERY (“AA” BATTERY

NOT INCLUDED). WHEN PLAYING THE UNIT BY BATTERIES, PLEASE DISCONNECT THE AC

POWER CORD FROM THE AC POWER SOCKET (17). PLEASE MAKE SURE THE POWER IS OFF,

WHEN YOU DISCONNECT THE POWER CORD. IF YOU FORGET THE TURN OFF THE POWER

WHEN YOU DISCONNECT THE POWER CORD, THE ELECTRICITY CURRENT WILL REMAIN IN LCD

DISPLAY. PLEASE PRESS RESET (19) AT THE BACK OF RADIO UNIT, THEN THE UNIT WILL RESET.

CONNECTING THE RADIO

PLUG THE AC CORD INTO THE AC POWER SOCKET (17). THEN PLUG THE ANOTHER END INTO

THE AC OUTLET. WHEN ELECTRICAL POWER HAS BEEN INTERRUPTED AND RESTORED, THE

CLOCK DISPLAY (2) WILL DEFAULT THE CALENDAR AS 1 JANUARY 2009 12:00AM.

LCD BACKLIGHT

LCD BACKLIGHT WILL TURN ON BY PRESSING ANY BUTTON OF THE UNIT, THE BACKLIGHT WILL

TURN OFF AUTOMATICALLY AFTER 10 SECONDS.

TIME SETTING

TURN THE TUNE+ / - KNOB (4) TO SELECT 12 / 24 CLOCK DISPLAY FORMAT. PRESS THE SET

BUTTON (5) ONCE, THEN TURN THE TUNE +/- KNOB TO SET THE CORRECT HOUR. ONCE THE

HOUR IS SET, PRESS THE SET BUTTON (5) ONCE AGAIN, TURN THE TUNE +/- KNOB TO SET THE

CORRECT MINUTE. KEEP TURNING THE TUNE+/- KNOB (4) THE TIME WILL ADVANCE FAST

TUNING. PRESS THE SET BUTTON (5) AGAIN TO CONFIRM ONCE THE TIME IS SET. THE UNIT

WILL RETURN TO THE CLOCK MODE AUTOMATICALLY IF NO BUTTON IS PRESSED WITHIN 15

SECONDS.

CALENDAR SETTING

WHEN LCD DISPLAY SHOWS THE TIME, PRESS MODE BUTTON (3) ONCE, IT WILL SHOW

CALENDAR MODE. PRESS SET BUTTON (5) ONCE TO SELECT THE YEAR, TURN THE TUNE+/-

KNOB (4) TO SET THE CORRECT YEAR. PRESS SET BUTTON (5) AGAIN TO SELECT THE MONTH,

TURN THE TUNE +/- KNOB (4) TO SET THE MONTH. THEN PRESS SET BUTTON (5) AGAIN TO

SELECT THE DATE, TURN THE TUNE +/- KNOB (4) TO SET THE DAY. PRESS THE SET BUTTON (5)