R300WN22MOD manual R300WN22MOD
10 · 1
PDF manual
 · 15 pages
English R300WN22MOD
Instruction Manual
Déclaration d’exposition à la radiation:
Cet équipement respecte les limites d’exposition aux rayonnements IC dénies pour un
environnement non contrôlé. Cet équipement doit être installé et mis en marche à une
distance minimale de 20 cm qui sépare l’élément rayonnant de votre corps.Lémetteur ne doit
ni être utilisé avec une autre antenne ou un autre émetteur ni se trouver à leur proximité.
FCC ID: SCDOW141000001
IC: 11232A-R300WN22MOD
FCC ID: SCDOW161000001
IC: 11232A-300WN22MOD5

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.
Important Notice
This product MUST be installed by a professional installer who is familiar with local building
and safety regulations, where appropriate, and is licensed by applicable authorities. The
professional installer is responsible for making sure grounding is available and that it meets
the relevant local and national electrical codes. Failure to employ a professional installer may
render the product warranty void and it may also expose the end user or service provider to
legal and nancial liabilities. expressly disclaims any and all liabilities for injury,
damage, or violation of regulations due to improper installation of outdoor units or antennas.
Always remember to protect the AP by installing grounding lines as it is necessary to protect
your outdoor installations from lightning strikes and the build-up of static electricity. The AP
must be grounded properly before powering up, as direct grounding of an outdoor AP is
critical and must be done correctly to protect your networks from harsh outdoor environments
and destructive ESD surge.
CAUTION: Be sure that earth grounding is available and that it meets local and national
electrical codes. If in doubt always consult with a qualied electrician to make sure the outdoor
installation is properly grounded. For additional lightning protection, lightning rods, lightning
arrestors or RJ45 surge protectors may be used to compliment the installation.

View the manual for the R300WN22MOD here, for free. This manual comes under the category Wifi repeaters and has been rated by 1 people with an average of a 10. This manual is available in the following languages: English. Do you have a question about the R300WN22MOD or do you need help? Ask your question here

Need help?

Do you have a question about the and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other owners to provide you with a good answer.

Number of questions: 0

R300WN22MOD | R300WN22MOD
Wifi repeater
65030857758, 650308577584, 0065030857758
User manual (PDF)
Antenna gain level (max)10 dBi
Antenna featuresIntegrated antenna
Antenna typeInternal
Maximum data transfer rate300 Mbit/s
Networking standardsIEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3u
2.4 GHz
5 GHz
Frequency band2.4 - 2.4835 GHz
Number of users32 user(s)
Full duplex
Maximum outdoor range3700 m
ModulationDSSS, OFDM
Quality of Service (QoS) support
ChipsetAtheros - AR9341
International Protection (IP) codeIP67
LED indicatorsActivity, LAN, Power, Signal strength
Product colourGrey
PlacementPole, Wall
Housing materialAluminium, Plastic
CertificationCE, FCC, RoHS, TAA, REACH
Security algorithmsAES, TKIP, WEP, WPA
Auto Wireless Distribution System (WDS)
Supported protocolsCSMA/CA
Ports & interfaces
Internal RJ-45 ports quantity2
Ethernet LAN (RJ-45) ports0
USB 2.0 ports quantity0
WAN connectionWi-Fi
Input current1 A
AC input voltage100 - 240 V
Output current0.5 A
Output voltage48 V
Power plug typeType N
Power consumption (max)13.5 W
Power over Ethernet (PoE)
Packaging content
AC adapter included
PoE adapter included
Mounting kit
Quick start guide
Operational conditions
Operating relative humidity (H-H)0 - 100 %
Operating temperature (T-T)-30 - 60 °C
Storage temperature (T-T)-30 - 85 °C
Weight & dimensions
Width100 mm
Depth161 mm
Height58 mm
Weight679 g
Packaging data
Package weight1300 g
Package height86 mm
Package depth355 mm
Package width215 mm
Management features
Web-based management
Logistics data
Products per master (outer) case10 pc(s)
Master (outer) case height385 mm
Master (outer) case width455 mm
Master (outer) case length470 mm
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the R300WN22MOD below.

Is your question not listed? Ask your question here

No results