StarTech.com HD202A manual

StarTech.com HD202A
7.5 · 1
PDF manual
 · 2 pages
English
manualStarTech.com HD202A
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modications not expressly approved by StarTech.com could void
the user’s authority to operate the equipment.
Industry Canada Statement
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-
party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which
this manual applies by the third-party company in question. StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the
property of their respective holders.
Warranty Information
This product is backed by a two-year warranty.
For further information on product warranty terms and conditions, please refer to www.startech.com/warranty.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their ocers, directors, employees or agents)
for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of prots, loss of
business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product.
Some states do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations
or exclusions contained in this statement may not apply to you.
Safety Measures
• If product has an exposed circuit board, do not touch the product under power.
Mesures de sécurité
• Si l’un des circuits imprimés du produit est visible, ne pas touchez le produit lorsqu’il est sous tension.
安全対策
• 製品に露出した状態の回路基盤が含まれる場合、電源が入っている状態で製品に触らないでください
Misure di sicurezza
• Se il prodotto ha un circuito stampato visibile, non toccare il prodotto quando è acceso.
Säkerhetsåtgärder
• Rör aldrig vid enheter med oskyddade kretskort när strömmen är påslagen.
FR: fr.startech.com
DE: de.startech.com
ES: es.startech.com
NL: nl.startech.com
IT: it.startech.com
JP: jp.startech.com
StarTech.com Ltd.
45 Artisans Cres
London, Ontario
N5V 5E9
Canada
StarTech.com Ltd.
Unit B, Pinnacle 15
Gowerton Rd,
Brackmills
Northampton
NN4 7BW
United Kingdom
StarTech.com LLP
2500 Creekside
Parkwy
Lockbourne, Ohio
43137
U.S.A.

Removing a Regional Power Clip

To remove a Regional Power Clip from the Universal Power Adapter:

1. Push the Release Button on the Universal Power Adapter.

2. Slide the Regional Power Clip upward aligning the Side Tabs on the Regional

Power Clip with the notches on the Universal Power Adapter.

3. Pull the Regional Power Clip away from the Universal Power Adapter.

EDID Specications

Audio EDID

Conguration of

Output Device

HDMI Output (Audio)

SPDIF Output

(Audio)

L/R Output

(Audio)

Pass (Default)

Dolby/DTS 7.1 Dolby/DTS 7.1 x x

Dolby/DTS 5.1 Dolby/DTS 5.1 Dolby/DTS 5.1 x

PCM 7.1 PCM 7.1 PCM 2.0 PCM 2.0

PCM 5.1 PCM 5.1 PCM 2.0 PCM 2.0

PCM 2.0 PCM 2.0 PCM 2.0 PCM 2.0

2.0CH

x PCM 2.0 PCM 2.0 PCM 2.0

5.1CH

Dolby/DTS 7.1 Dolby/DTS 5.1 Dolby/DTS 5.1 x

5.1CH: The Extractor passes 5.1CH EDID settings through the Video Source
Device connected to the HDMI IN Port and to the Display Device (video and

5.1CH audio).

Installing the Mounting Brackets

1. Align a Mounting Bracket with the two Mounting Holes on the side of the

Extractor.

Note: The Extractor has four Mounting Holes, two on each side.
2. Insert the Bracket Screws (x2) through the Mounting Bracket and into the

Mounting Holes.

3. Tighten the Mounting Screws using a Phillips Head Screwdriver, be careful not to

over-tighten.

4. Before installing the Mounting Bracket on the mounting surface, contact a

professional. Product mounting should be completed by a certied professional as

per the local safety and building code guidelines.

Connecting a Regional Power Clip

1. Select a Regional Power Clip.

2. Align the two Side Tabs on the Regional Power Clip with the notches on the face of

the Universal Power Adapter.

3. Slide the Regional Power Clip down until you hear an audible click, connecting

the contact prongs on the Regional Power Clip with the contact prongs on the

Universal Power Adapter.

Manual

View the manual for the StarTech.com HD202A here, for free. This manual comes under the category audio / video converters and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the StarTech.com HD202A or do you need help? Ask your question here

Need help?

Do you have a question about the StarTech.com and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

StarTech.com HD202A specifications

Below you will find the product specifications and the manual specifications of the StarTech.com HD202A.

General
BrandStarTech.com
ModelHD202A | HD202A
Productaudio / video converter
EAN0065030878609
LanguageEnglish
FiletypeUser manual (PDF)
Ports & interfaces
Host interfaceHDMI
Output interface-
Video inHDMI
Video outHDMI
Audio outputRCA + Toslink
Power
Operating current1 A
Input voltage100 - 240 V
Input current0.4 A
Operating voltage5 V
Power plug typeType M
External power adapterYes
Packaging data
AC adapter includedYes
Package weight470 g
Package height50 mm
Package depth192 mm
Package width152 mm
Included power plug typesANZ, EU, NA, UK
Mounting bracket(s) includedYes
Screws includedYes
Number of screws2
Operational conditions
Operating temperature (T-T)0 - 45 °C
Storage temperature (T-T)-20 - 70 °C
Operating relative humidity (H-H)10 - 90 %
Weight & dimensions
Width80 mm
Depth90 mm
Height22 mm
Weight320 g
Features
Converter type-
Product colorBlack
Video
Maximum video resolution4096 x 2160 pixels
Video resolutions1280 x 720,1920 x 1080,1920 x 1200,3840 x 2160,4096 x 2160 pixels
Maximum refresh rate60 Hz
Audio
Audio output channels5.1 channels
Logistics data
Harmonized System (HS) code85176990
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the StarTech.com HD202A below.

What is the weight of the StarTech.com HD202A?

The StarTech.com HD202A has a weight of 320 g.

What is the height of the StarTech.com HD202A?

The StarTech.com HD202A has a height of 22 mm.

What is the width of the StarTech.com HD202A?

The StarTech.com HD202A has a width of 80 mm.

What is the depth of the StarTech.com HD202A?

The StarTech.com HD202A has a depth of 90 mm.

Is the manual of the StarTech.com HD202A available in English?

Yes, the manual of the StarTech.com HD202A is available in English .

Is your question not listed? Ask your question here

No results