SpeakerCraft IRE 3.0 manual

SpeakerCraft IRE 3.0
7.4 · 1
PDF manual
 · 2 pages
English
manualSpeakerCraft IRE 3.0
PRINTER’S INSTRUCTIONS:INSTR,INSTL,IRE-3.0 • LINEAR P/N: 223105B • INK: BLACK •MATERIAL: 20LB. GLOSS WHITE PAPER • SIZE: 4.250” X 14.000” FOLD TO 4.250” X 3.500”• FOLDING: 4 PARALLEL FAN-FOLDS, FINISH WITH LOGO SHOWING • SCALE: 1-1223105B • IMAGE 2
6
6
4
2
5
4
2
8
3
7
7
2

IRE-3.0

IR Emitter
with Visible LED

SmartPath

INSTALLATION INSTRUCTIONS
LIT03300 (rev1)
223105B
2
940 Columbia Avenue, Riverside, CA 92507
Phone 1-800-448-0976
Fax 951-787-8747
www.speakercraft.com
LIMITED 5-YEAR WARRANTYSpeakerCraft Inc. warrants to the original retail purchaser only that this SpeakerCraft product will be free from defects in materials and workmanship, for a period of 5-years, provided it was purchased from a SpeakerCraft Authorized Dealer. Defective products must be shipped, together with proof of pur
-
chase, prepaid insured to the SpeakerCraft Authorized Dealer from whom they were purchased, or to the SpeakerCraft factory at the address listed on this installation instruction manual. Freight collect shipments will be refused. It is preferable to ship this product in the original shipping container to lessen the chance of transit damage. In any case, the risk or loss or damage in transit is to be borne by the purchaser. If upon examination at the Factory or SpeakerCraft Authorized Dealer it is determined that the unit was defective in materials or workmanship at any time during this warranty period, SpeakerCraft or the SpeakerCraft Authorized Dealer will, at its option, repair or replace this product at no additional charge, except as set forth below. If this model is no longer available and can not be repaired effectively, SpeakerCraft, at its sole option may replace the unit with a current model of equal or greater value. In some cases where a new model is substituted, a modification to the mount
-
ing surface may be required. If mounting surface modification is required, SpeakerCraft assumes no responsibility or liability for such modification. All replaced parts and product become the property of SpeakerCraft Inc. Products replaced or repaired under this
warranty will be returned to the original retail purchaser, within
a reasonable time, freight prepaid.This warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inadequate packing or shipping procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, or service, repair or
modification of the product which has not been authorized or approved by SpeakerCraft. This warranty also excludes normal cosmetic deterioration caused by environmental conditions. This warranty will be void if the Serial number on the product has been removed, tampered with or defaced.This warranty is in lieu of all other expressed warranties. If the
product is defective in materials or workmanship as warranted above, the purchaser’s sole remedy shall be repair or replacement
as provided above. In no event will SpeakerCraft be liable for any incidental or consequential damages arising out of the use or inabil
-
ity to use the product, even if SpeakerCraft Inc. or a SpeakerCraft Inc. Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply. All implied warranties on the product are limited to the duration of this expressed warran
-
ty. Some states do not allow limitation on the length of an implied Warranty. If the original retail purchaser resides in such a state, this limitation does not apply.
ELT03300

SpeakerCraft

®
SpeakerCraft
®
Note 4: The emitter shell and EZ-Docker
port, though dark in appearance, are transparent to Infrared. This allows IR commands to pass through them, permitting local hand held remote control as well as through the IRE-3.0.

View the manual for the SpeakerCraft IRE 3.0 here, for free. This manual comes under the category Remote Controllers and has been rated by 1 people with an average of a 7.4. This manual is available in the following languages: English. Do you have a question about the SpeakerCraft IRE 3.0 or do you need help? Ask your question here

Need help?

Do you have a question about the SpeakerCraft and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other SpeakerCraft owners to provide you with a good answer.

Number of questions: 0

General
SpeakerCraft
IRE 3.0 | ELT03300
Remote Controller
English
User manual (PDF)
Weight & dimensions
Cable length2.4 m
Design
Product colourBlack
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the SpeakerCraft IRE 3.0 below.

Is your question not listed? Ask your question here

No results