With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
Step 4:Secure the cords
Bundle the cables and cords.
Using the supplied cord strap, bundle the cables and cords.
Step 5:Turn on the monitor and
computer
Press the1 (power) switch.
The 1 (power) indicator of the monitor lights up in green.
Turn on the computer.
The installation of your monitor is complete. If necessary, use the
monitor’s controls to adjust the picture.
If no picture appears on your screen
•Check that the power cord and the video signal cable are
properly connected.
•If NO INPUT SIGNAL appears on the screen:
The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
•If CABLE DISCONNECTED appears on the screen:
Check that the video signal cable is properly connected.
•If OUT OF RANGE appears on the screen:
Reconnect the old monitor. Then adjust the computer’s
graphics board within the following ranges.
For more information about the on-screen messages, see “Trouble
symptoms and remedies” on page 18.
No need for specific drivers
The monitor complies with the “DDC” Plug & Play standard and
automatically detects all the monitor’s information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.
to AC IN
to a power outlet
power cord (supplied)
Cord strap
(supplied)
The illustration of the back of the monitor shown here is that of
the SDM-E76D.
The same applies for the other models.
Analog RGBDigital RGB
(SDM-E76D/
SDM-E96D only)
Horizontal
frequency
28–80 kHz28–64 kHz
Vertical
frequency
56–75 Hz60 Hz
Resolution1280 × 1024 or less1280 × 1024 or less
Manual
View the manual for the Sony SDM-976D here, for free. This manual comes under the category monitors and has been rated by 1 people with an average of a 5.9. This manual is available in the following languages: English. Do you have a question about the Sony SDM-976D or do you need help? Ask your question here
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Sony SDM-976D below.
What screen dimensions does my monitor have?
The size of your monitor is usually expressed in inches, 1 inch is 2.54 centimetres. The size is the diagonal size of your monitor, so you measure the screen from bottom left to top right.
What is HDMI?
HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.
Is the manual of the Sony SDM-976D available in English?
Yes, the manual of the Sony SDM-976D is available in English .
Need help?
Do you have a question about the Sony and is the answer not in the manual?
Question and answer
Number of questions: 0