Smith & Wesson M&P 40 manual
View the manual for the Smith & Wesson M&P 40 here, for free. This manual comes under the category not categorized and has been rated by 2 people with an average of a 8.3. This manual is available in the following languages: English. Do you have a question about the Smith & Wesson M&P 40 or do you need help? Ask your question here
General
| Smith & Wesson | |
| M&P 40 | |
| not categorized | |
| English | |
| User manual (PDF) |
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Smith & Wesson M&P 40 below.
How do I disassemble my Smith & Wesson M&P 40 for cleaning and maintenance?
To disassemble your M&P 40, first ensure the firearm is unloaded and the magazine is removed. Push the takedown lever down, pull the slide rearward, and then lift it off the frame. Further instructions for cleaning and maintenance can be found in the manual.
What is the correct procedure for reassembling my M&P 40 after cleaning?
After cleaning, align the slide with the frame rails and push it forward until it clicks into place. Finally, make sure the takedown lever is in the correct position. Detailed reassembly instructions can be found in the manual.
How can I properly adjust the rear sight on my M&P 40?
To adjust the rear sight for windage (left/right), use a suitable tool to drift it in the desired direction. For elevation (up/down) adjustments, turn the elevation screw clockwise for lower impact and counterclockwise for higher impact. Refer to the manual for more precise instructions and sight adjustment details.
What should I do if the slide of my M&P 40 fails to lock back after the last round is fired?
If your slide does not lock back after the last round, check that you are using appropriate ammunition and that your grip is not inadvertently pressing the slide lock lever. Also, make sure your shooting technique isn't interfering with the slide's movement. Consult the manual for additional troubleshooting steps.
How can I safely clear a jam or malfunction with my M&P 40?
In case of a jam or malfunction, begin by ensuring the firearm is pointed in a safe direction and your finger is off the trigger. Then, lock the slide to the rear, remove the magazine, and visually inspect the chamber. Follow the prescribed steps in the manual to clear the specific type of malfunction you encounter. Remember to always prioritize safety and consult the manual for detailed instructions on clearing various types of malfunctions.
Is the manual of the Smith & Wesson M&P 40 available in English?
Yes, the manual of the Smith & Wesson M&P 40 is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Smith & Wesson and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Smith & Wesson owners to provide you with a good answer.
Size of set screw in back sight.
How do I put a new CO2 cartridge in my M & P 40 smith and Wesson BB gun
How do you replace the o ring?
Number of questions: 3