Silva EX Distance manual

Silva EX Distance
6.8 · 2
PDF manual
 · 16 pages
English
manualSilva EX Distance
Visit: www.silva/enviroment
for more information about the
Waste Electrical and Electronic
Equipment (WEEE) Directive.
恭喜您购买Silva计步器
计步器是一台运动监控仪;根据不同的型号它可以计算步数,计算距离、
运动时间和卡路里消耗量
产品综信息
计步器使用钟摆记录步数。 在运动中时钟摆发出咔哒声。 请妥善保管
您的计步器。 它并不防震动或者防水
.
开/关
向外拉开电池舱盖电池插入。 插入电池ex step, ex distance 和
ex plus 型号插入1节LR44,ex connect型号插入2节LR44且重新盖
上电盖。
由于机器在不使用时耗电量非常低,因此计没有配备开/关按钮。
计步器的安置
计步器应以直立位置放置。 如果机器向任何方向倾斜,则它能会记录
不正确的步数。 最佳位置是位于您髋部的腰带上。
设定:
更改距离及体重单位ex distance & ex plus)
制( )和 制( )之
5钟。
注意:这将会重置所累积的步数距离以及卡路里。
设置步长ex distance & ex plus
要得到正确的距离值,需要设置步长。
如何计算您的步长:
1. 行走10步
2. 测量距离。
3. 将距离除以10
4. 所计算出的值即为您的步长。
按MODE模式按钮直至显示KM”或者“MIL。 按下按住SET设置按钮,
当前步长将会闪烁。 重复按SET设置按钮,便将步长增加至正确值
每次按下将会增加1厘0.1英尺)
要设置一个短一些的长,请增加过了大值(240厘米/8.0
英尺)。 然后计步器将会从最短的值开始30厘米/1英尺。 当正确
步长示后请放开SET设钮,在几秒钟后您将返回至距菜单。
经设置。
设置体ex plus
按MODE模式按钮直至显示CAL。 按下按住SET设置按钮,则当前体重
将会闪烁。 重复按SET置按钮,以便将体重增加至正确每次按下将
1 1 )。
置一个低一些的体重,请增加重量直至您超过最大值(135千克或
300磅。 然后计步器将会从最低的值开始30克/60磅。 当正确的
值显示后请放开SET置按钮,在几秒钟后您将回到卡路里菜单。 现在
体重置。
功能:
显示步数
按MODE模式按钮直至显示“STEP
显示距离ex distance & ex plus
按MODE模式按钮直至显示KM”或者“MIL
显示卡路里消耗量ex plus
按MODE模式按钮直至显示文字“CAL。 卡路里消耗量根据您步伐的强
度计算。
重置计步器
按两个按钮2秒钟便重置步伐、距离、卡路里和计时器。
显示有效的步行/慢跑时间
按MODE模式按钮直至显示“TMR”。 在您开始步行时计时器自动开
下来将自停止
其他项:
过滤功能
计步器使用过滤器以止不属于步行/慢跑的一部分的短时不自主运动
要计6步以便
更换电
当显示器上的数字开始变暗时更换电池。
直接向外拉开电池盖。 更换电池型号插入1节LR44,并且重新盖上电
盖。
保护环
本产品包含的所有部件,包括电池,应回收利用,不得丢弃在普通垃圾箱
据当相关用条物品。
保修
Silva 保证其产品在正常使用的情况下有材料和工艺上的重大缺陷
修期为两 (2) 年。 Silva 在此项保修下的责任
于修理或更换产品。 此项有限保修仅适用于原始购买。 如果产品在
修期内出陷,
请与原始购买处联系。 在返回产品时请务必提购买证明
如果没有原始购买证明,退货。 如果产品动、
Silva 提的说明进行装、操作、护,
或者受到异常的物理或电气应力使用不当人为疏忽或者生事故,则该
保修不适用。 保修不包括
品正常的磨损。 Silva 对于因使用本产品造成的任何直接或间接性
果或损坏概不承担任何责任。 在任何情况Silva 的偿责任均不
过您对产品支付的金额。些司法辖区不允许排除限制附带
果性的损失,因此上述限制或排除条文可能不适用于您。 该保修仅在购
买国有效且仅可在购买国进行保修。 如需了更多信息,请登录www.
si lv a .se
手册

ex distance

部分 56053

Manual

View the manual for the Silva EX Distance here, for free. This manual comes under the category not categorized and has been rated by 2 people with an average of a 6.8. This manual is available in the following languages: English. Do you have a question about the Silva EX Distance or do you need help? Ask your question here

Need help?

Do you have a question about the Silva and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Silva EX Distance specifications

Below you will find the product specifications and the manual specifications of the Silva EX Distance.

General
BrandSilva
ModelEX Distance
Productnot categorized
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Silva EX Distance below.

How can I ensure that my pedometer registers the correct number of steps?

To ensure that your Silva EX Distance pedometer registers the correct number of steps, follow these steps: 1. Place the pedometer upright on your belt at the hip to prevent incorrect step registration. 2. Switch between metric and imperial units by pressing and holding both buttons for 5 seconds, but note that this will reset accumulated data. 3. Set the correct stride length by walking 10 steps, measuring the distance, and dividing it by 10 to get your stride length. 4. Adjust the stride length using the SET button to ensure accurate distance calculation. 5. Set your body weight for calorie consumption calculations by pressing MODE until "CAL" is displayed and adjusting the weight using the SET button. 6. Reset the pedometer by pushing both buttons for 2 seconds to clear steps, distance, calories, and timer. 7. Use the filter function to ensure accurate step counting by requiring six consecutive steps for counting to continue.

How do I change the distance and weight units on the pedometer?

To change the distance and weight units on the Silva EX Distance pedometer, follow these steps: 1. Press and hold both buttons for 5 seconds to switch between metric (kilograms, kilometers, and centimeters) and imperial (pounds, miles, and feet). 2. Note that this action will reset the steps, distance, and calories accumulated. 3. To set the stride length for accurate distance measurement, walk 10 steps and measure the distance. Divide the distance by 10 to calculate your stride length. 4. Press MODE until "KM" or "MIL" is displayed, then press and hold SET to adjust the stride length. 5. To set the body weight, press MODE until "CAL" is displayed, then press and hold SET to adjust the weight to the correct value. These steps will help you customize the distance and weight units on your Silva EX Distance pedometer.

Is the manual of the Silva EX Distance available in English?

Yes, the manual of the Silva EX Distance is available in English .

Is your question not listed? Ask your question here

No results