Siemens WT46W572DN manual

Siemens WT46W572DN
9 · 3
PDF manual
 · 2 pages
English
manualSiemens WT46W572DN

Dryer

This leaflet provides you with a brief overview of the important information and improvements
that you need to know about your new dryer before using it for the first time.
If you think that the laundry is slightly too damp, use the fine adjustment for the drying
result. You can find instructions on how to set required degrees of dryness in the
section “Fine adjustment of the drying result” or “Adjust drying level” in your
instructions for use.
If you are drying thin and thick or multi-layered fabrics together, these will dry
differently. To ensure that the laundry dries evenly, you must sort it according to the
type of fabric and the structure. If required, select a time programme to finish the
drying.
Take note of whether the drying cycle was interrupted after a service display (for
example, Empty the container or Please empty the condensation container, or Clean
the fluff filter or Please clean the lint filter), which means that the drying cycle is not
yet complete. Correct the fault and continue the programme. See the chapter “What
to do if...” in the instructions for use.

Residual moisture from the laundry

The laundry feels slightly damper
The laundry is not evenly dry…
The laundry is still noticeably damp…

The main points to begin with en

During drying, fluff and hair from the laundry is trapped by the fluff filter.
A blocked or partially cleaned fluff filter reduces the flow of air. This
means that the dryer does not reach its maximum performance. The
fluff filter must therefore be cleaned after each drying cycle. Rinse the
filter regularly under running water and carefully dry it. See also the
notes on “Care and cleaning” in the instruction manual.

After each drying cycle

Cleaning the fluff filter
After each drying cycle, empty the condensation container because,
under certain circumstances, the next drying programme will be
cancelled as a result of the condensation container being full. You must
also regularly clean the filter in the condensation container under
running water or in the dishwasher. See also the information on “Care
and cleaning” in the instruction manual.
Emptying the condensation container
Further important information can be found in your instructions for use and installation manual
or care instructions. Pay particular attention to the chapter “What to do if...” and “After-sales
service”.
1
2
Warm laundry feels damper than it actually is.
Thanks to the heat pump technology, your laundry is always dried at gentle
temperatures in any programme.
However, you must observe the maximum load and type of laundry in order to
achieve optimum results.
You must also observe the information in the chapter “Notes on laundry” in the
instructions for use.
The fluff filters and condensation containers must always be
cleaned or emptied after each drying cycle.
9110/ 9000689281

*689281*

View the manual for the Siemens WT46W572DN here, for free. This manual comes under the category dryers and has been rated by 3 people with an average of a 9. This manual is available in the following languages: English. Do you have a question about the Siemens WT46W572DN or do you need help? Ask your question here

Need help?

Do you have a question about the Siemens and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

The Siemens WT46W572DN is a freestanding dryer with a heat pump drying system. It has an energy efficiency class of A, making it an energy-saving option. The dryer has an adjustable spin speed feature, allowing users to select the desired speed for their laundry. It comes with a 1.45 meter cord length, providing flexibility in placement options. With a maximum delay start of 24 hours, the user can set the dryer to start at a convenient time. The door hinge is located on the right side, and the dryer operates with a noise level of 65 dB, which may be considered moderate. The drum volume of the Siemens WT46W572DN is 112 liters, providing ample space for a 7 kg load. The maximum spin speed is 1400 RPM, allowing for effective drying performance. The dryer has a width of 598 mm and a depth of 625 mm, ensuring it can fit into most laundry spaces. Its design focuses on functionality, making it suitable for a variety of households. In conclusion, the Siemens WT46W572DN is a freestanding dryer with an A energy efficiency class. It features a heat pump drying system, adjustable spin speed, and a 1.45 m cord length. The delayed start timer can be set up to 24 hours in advance, and the right-side door hinge provides convenience during use. With a noise level of 65 dB and a drum volume of 112 L, it offers sufficient capacity for a 7 kg load. The dryer operates at a maximum spin speed of 1400 RPM and has dimensions of 598 mm in width and 625 mm in depth.

General
BrandSiemens
ModelWT46W572DN | WT46W572DN
Productdryer
EAN4242003557204
LanguageEnglish
FiletypeUser manual (PDF)
Power
Energy efficiency classA
AC input voltage220 - 240 V
AC input frequency50 Hz
Connected load1000 W
Annual energy consumption107 kWh
Current10 A
Design
Appliance placementFreestanding
Loading typeFront-load
Drying systemHeat pump
Cord length1.45 m
Door hingeRight
Drum volume112 L
Product colorWhite
Built-in displayYes
Display typeLCD
CertificationCE, VDE
Performance
Adjustable spin speedYes
Noise level65 dB
Maximum spin speed1400 RPM
Drum capacity7 kg
Ergonomics
Delay start (max)24 h
Delayed start timerYes
Child lockYes
Drum interior lightYes
Remaining time indicationYes
Weight & dimensions
Width598 mm
Depth625 mm
Height842 mm
Weight55000 g
Packaging data
Package dimensions (WxDxH)630 x 680 x 870 mm
Package weight56000 g
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Siemens WT46W572DN below.

What is a condenser dryer?

A condenser dryer is a dryer in which condensation ends up in a reservoir.

What is a drain dryer?

A drain dryer is a dryer in which the warm air and condensation are drained through a hose.

What is the best thing to do about a smelly dryer?

It is best to wipe the dryer drum with a damp cloth and some lemon cleaner.

There is a burning smell from my dryer, now what?

Check the following: - That the fluff filter is clean. - That the bottom of the dryer is free of dust. - That the drain hose is clean. If the above does not help, a mechanic should be called in.

What is the weight of the Siemens WT46W572DN?

The Siemens WT46W572DN has a weight of 55000 g.

What certifications does the Siemens WT46W572DN have?

The Siemens WT46W572DN has the following certifications: CE, VDE.

What is the height of the Siemens WT46W572DN?

The Siemens WT46W572DN has a height of 842 mm.

What is the width of the Siemens WT46W572DN?

The Siemens WT46W572DN has a width of 598 mm.

What is the depth of the Siemens WT46W572DN?

The Siemens WT46W572DN has a depth of 625 mm.

What energy label does the Siemens WT46W572DN have?

The Siemens WT46W572DN has energy label A.

Does the Siemens WT46W572DN have adjustable spin speed?

Yes, the Siemens WT46W572DN has adjustable spin speed. This means that the user can customize the spin speed to their preference or the requirements of the load, allowing for more control and flexibility in the drying process.

Is there a delayed start timer in the Siemens WT46W572DN?

Yes, the Siemens WT46W572DN has a delayed start timer. This feature allows the user to set a specific time for the dryer to start, which can be especially convenient for those who want to take advantage of off-peak electricity rates or have the laundry ready at a specific time.

What is the maximum spin speed of the Siemens WT46W572DN?

The maximum spin speed of the Siemens WT46W572DN is 1400 RPM. This high spin speed helps to efficiently remove excess moisture from the clothes, resulting in shorter drying times and potentially saving energy.

How noisy is the Siemens WT46W572DN during operation?

The Siemens WT46W572DN has a noise level of 65 dB. While not completely silent, this noise level is considered relatively low and should not cause significant disturbance during use.

What is the drum volume of the Siemens WT46W572DN?

The drum volume of the Siemens WT46W572DN is 112 L. This indicates the capacity of the dryer, referring to the amount of laundry it can accommodate. With a drum volume of 112 L, the Siemens WT46W572DN offers a decent capacity of 7 kg for efficient and effective drying.

How can I adjust the drying result to make it finer?

To adjust the drying result to make it finer on the Siemens WT46W572DN dryer, follow these steps: 1. Start by selecting the desired drying program on the control panel. 2. Once the program is selected, you can fine-tune the drying result by adjusting the degrees of dryness. 3. Look for the "Fine adjustment of the drying result" or "Adjust drying level" section in the instruction manual for specific instructions on how to set the required degrees of dryness. 4. Follow the instructions provided in the manual to increase or decrease the drying level according to your preference. 5. After making the necessary adjustments, start the drying cycle and monitor the drying process. 6. If you find that the laundry is still slightly damp or not evenly dry, you can further adjust the drying result by repeating the steps above and making finer adjustments to the degrees of dryness. By following these steps, you can customize the drying result to achieve the desired level of dryness for your laundry.

What is the recommended way to sort laundry according to fabric type and structure?

To sort laundry according to fabric type and structure on the Siemens WT46W572DN dryer, follow these steps: 1. Before loading the dryer, remove any objects from the laundry pockets, such as lighters or metal parts, to prevent damage to the dryer or clothing. 2. Refer to the instruction manual for the maximum load quantity and follow the recommended guidelines to avoid overloading the dryer. 3. Sort the laundry according to fabric type and structure. Separate delicate fabrics from heavier fabrics and avoid mixing different fabric types together. 4. Consider sorting laundry based on the care labels on the clothing. For example, separate items that require special care, such as wool or silk, from regular cotton or synthetic fabrics. 5. If necessary, select a specific time program to accommodate different fabric types. This allows you to adjust the drying time and temperature settings for optimal results. 6. Load the sorted laundry into the dryer, ensuring that the drum is not overloaded and that the items are evenly distributed. 7. Start the drying cycle according to the selected program and monitor the drying process. 8. Once the drying cycle is complete, remove the dry laundry promptly to prevent wrinkles or creases from setting in. By following these steps, you can effectively sort your laundry according to fabric type and structure, ensuring that each item receives the appropriate care during the drying process.

How do I clean the fluff filter and condensation container after each drying cycle?

To clean the fluff filter and condensation container after each drying cycle on the Siemens WT46W572DN dryer, follow these steps: 1. After each drying cycle, clean the fluff filter to ensure optimal performance. Locate the fluff filter, usually located inside the dryer door or on the front panel. 2. Remove the fluff filter from its housing and rinse it under running water to remove any lint or debris. Make sure to clean it thoroughly and dry it before placing it back into the dryer. 3. Additionally, empty the condensation container after each drying cycle to prevent any interruption in the next drying program. The condensation container is typically located at the bottom of the dryer. 4. Remove the condensation container carefully and empty the collected water. You can either pour the water out or use a suitable container to collect it. 5. Clean the filter in the condensation container under running water or in the dishwasher to remove any accumulated lint or residue. Ensure that the filter is completely dry before placing it back into the condensation container. 6. Refer to the "Care and cleaning" section in the instruction manual for more detailed instructions on cleaning the fluff filter and condensation container. By following these steps, you can effectively clean the fluff filter and empty the condensation container after each drying cycle, ensuring the proper functioning of your Siemens WT46W572DN dryer.

How do I empty the condensation container?

To empty the condensation container on the Siemens WT46W572DN dryer, follow these steps: 1. After each drying cycle, locate the condensation container, which is typically located at the bottom of the dryer. 2. Carefully remove the condensation container from its housing by pulling it out. 3. Hold the container over a sink or suitable container to collect the water. 4. Pour out the collected water from the condensation container. 5. If needed, clean the filter in the condensation container under running water or in the dishwasher to remove any lint or residue. 6. Ensure that the filter is completely dry before placing it back into the condensation container. 7. Once the condensation container is empty and the filter is clean and dry, carefully insert the container back into its housing. 8. Ensure that the condensation container is securely in place before starting the next drying cycle. By following these steps, you can easily empty the condensation container on the Siemens WT46W572DN dryer after each drying cycle, ensuring the proper functioning of the appliance.

Are there any specific notes on laundry and maximum load quantity that I should be aware of?

When using the Siemens WT46W572DN dryer, there are specific notes on laundry and maximum load quantity that you should be aware of. Here are the key points: 1. Sort your laundry according to fabric type and structure to ensure even drying. Thin and thick or multi-layered fabrics may dry differently, so it's important to separate them. 2. Pay attention to the maximum load quantity specified in the instruction manual. Overloading the dryer can affect drying performance and efficiency. 3. After each drying cycle, clean the fluff filter to maintain optimal airflow. Rinse the filter under running water and dry it thoroughly before placing it back in the dryer. 4. Empty the condensation container after each drying cycle to prevent interruption in the next program. The container collects water extracted from the laundry during the drying process. 5. Regularly clean the filter in the condensation container under running water or in the dishwasher to remove lint or residue. 6. If the drying cycle is interrupted due to a service display, such as "Empty the container" or "Please clean the fluff filter," address the issue and continue the program as instructed in the manual. By following these guidelines, you can ensure efficient drying and maintain the performance of your Siemens WT46W572DN dryer.

Is the manual of the Siemens WT46W572DN available in English?

Yes, the manual of the Siemens WT46W572DN is available in English .

Is your question not listed? Ask your question here

No results