Shure ANI4OUT manual

Shure ANI4OUT
8.6 · 1
PDF manual
 · 23 pages
English
manualShure ANI4OUT
Input
(1) RJ45
Outputs
ANI4OUT-XLR (4) XLR connector
ANI4OUT-BLOCK (4) 3-pin block connector
Configuration
Impedance Balanced
Polarity
Non-inverting, any input to any output
Power Requirements
Power over Ethernet (PoE), Class 0
Power Consumption
10W, maximum
Weight
663 g (1.5 lbs)
Dimensions
H x W x D
4 x 14 x 12.8 cm (1.6 x 5.5 x 5.0 in.)
Control Application
HTML5 Browser-based
Operating Temperature Range
−6.7°C (20°F) to 40°C (104°F)
Storage Temperature Range
−29°C (-20°F) to 74°C (165°F)

Audio

Frequency Response
20 to 20,000 Hz
Input (Dante Digital Audio)
Channel Count 4
Sampling Rate 48 kHz
Bit Depth 24
Latency
Does not include Dante latency
0.71 ms
Dynamic Range (Dante-to-Analog)
20 Hz to 20 kHz, A-weighted, typical
117 dB
Total Harmonic Distortion
@ 1 kHz, -20 dBFS Output, 0 dB analog gain
<0.05%
Output Clipping Level
Line +20 dBV
Aux +0 dBV
Mic -26 dBV
Analog Output Level
Selectable Line 0 dB
Aux - 20 dB
Mic -46 dB
Output Impedance
150 Ω
Built-in Digital Signal Processing
Per Channel Equalizer (4-band Parametric), Mute, Invert Polarity,
Gain (140 dB range)
System Audio Summing

Networking

Cable Requirements
Cat 5e or higher (shielded cable recommended)

Specifications

Architect Specifications

ANI4OUT | Audio Network Interface

Overview

The Shure Audio Network Interface shall convert 4 channels of Dante™ digital audio into discrete analog output signals. The interface shall provide
connectivity with analog devices (audio processors, video codecs, and loudspeaker systems, for example) to fully integrate networked audio and analog
equipment in a single system. Available in XLR and block connector versions, each box uses a single network cable to receive audio and power through
Power over Ethernet (PoE). The web application shall control built-in digital signal processing, including channel settings, parametric equalization, and
audio summing from any computer connected to the same network.

Model Variations

ANI4OUT-XLR: Four XLR outputs (balanced audio)
ANI4OUT-BLOCK: Four 3-pin block connector outputs (balanced audio)
Two mounting solutions are available for installing the Audio Network Interface:
CRT1 | 19" Rack Tray (optional accessory): Supports up to 3 devices; mountable in a rack or under a table
53A27742 | Single-unit Mounting Tray (included accessory): Supports a single device for mounting under a table

Manual

View the manual for the Shure ANI4OUT here, for free. This manual comes under the category hand blenders and has been rated by 1 people with an average of a 8.6. This manual is available in the following languages: English. Do you have a question about the Shure ANI4OUT or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Shure and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Shure ANI4OUT specifications

Below you will find the product specifications and the manual specifications of the Shure ANI4OUT.

General
BrandShure
ModelANI4OUT | ANI4OUT-XLR
Producthand blender
EAN0042406475457
LanguageEnglish
FiletypeUser manual (PDF), Datasheet (PDF)
Audio
Frequency range20 - 20000 Hz
Dynamic range117 dB
Total Harmonic Distortion (THD) + noise0.05 %
Channels quantity4 channels
Balanced line output level20 dB
Power
Power consumption (typical)10 W
External power supplyYes
Operational conditions
Operating temperature (T-T)-6.7 - 40 °C
Storage temperature (T-T)-29 - 74 °C
Network
Ethernet LANYes
Design
Product colorBlack
Ports & interfaces
Ethernet LAN (RJ-45) ports1
XLR inputs4
Weight & dimensions
Width140 mm
Depth128 mm
Height40 mm
Weight663 g
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Shure ANI4OUT below.

What is the weight of the Shure ANI4OUT?

The Shure ANI4OUT has a weight of 663 g.

What is the height of the Shure ANI4OUT?

The Shure ANI4OUT has a height of 40 mm.

What is the width of the Shure ANI4OUT?

The Shure ANI4OUT has a width of 140 mm.

What is the depth of the Shure ANI4OUT?

The Shure ANI4OUT has a depth of 128 mm.

Is the manual of the Shure ANI4OUT available in English?

Yes, the manual of the Shure ANI4OUT is available in English .

Is your question not listed? Ask your question here

No results