Name: Scosche TA2046B
Brand: Scosche
SKU: 291553
Rating: 60 (1 reviews)

manualScosche TA2046B

SI 11/05 - TA2046B (3000003)

If you have any further questions, call our toll free technical help line at: 1-800-621-3695x3

TA2046B

2000-UP TOYOTA MULTI KIT

LIABILITY DISCLAIMER

This instruction booklet is based on carefully documented data and research of automobile dash disassembly, wire harness/

codes and information pertaining to installation of this kit (TA2046B) in 2000-UP Toyota Multi Kit Vehicles. Scosche Industries,

Inc. can not be held responsible for discrepancies/inconsistencies that may occur due to the automobile manufacturing

changes or options, or damage that may occur in the automobile during the installation of components while using this booklet.

Thank you for purchasing the Scosche TA2046B Kit. This kit was manufactured with the highest of quality standards.

NOTES: • See your vehicle's instructions for any special tools your installation might require.

• Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting instructions.

INTRODUCTION / PRELIMINARY

5625

LEFT

MULTI-

MOUNT

BRACKET

5624 LEFT

HIGHLANDER

BRACKET

5588 REAR

MOUNTING

SUPPORT

BRACKET

5404

POCKET

5589 RIGHT

HIGHLANDER

BRACKET

5587 RIGHT

MULTI-MOUNT

BRACKET

5586

MOUNTING

PANEL

5614

TRIM RING

2000-05 TOYOTA MR2 SPYDERRADIO REMOVAL:

1. Use panel removal tool to remove left and right plastic side panels, extract (2) Philips screws from behind each panel.

2. Remove climate control knobs and extract (2) Philips screws.

3. Remove radio trim bezel.

4. Remove ashtray and extract (1) 10mm bolt on the right side, carefully pry out ashtray trim bezel.

5. Extract (4) Philips screws securing the radio, disconnect and remove from dash.

2004-05 TOYOTA RAV4RADIO REMOVAL:

1. Using a panel removal tool, remove the side trim along the sides of the radio and climate controls.

2. Remove four (4) 10mm bolts securing radio to dash. Disconnect and remove.

See Illustration "D"See Illustration "E"2001-UP TOYOTA HIGHLANDERRADIO REMOVAL:

1. Using panel removal tool, remove trim around radio and climate control bracket that holds the A/C vents .

2. Remove the 10mm bolts holding the radio and climate control bracket. Disconnect and remove.

See Illustration "B"See Illustration "C"2000-05 TOYOTA ECHORADIO REMOVAL:

1. Remove left and right air conditioning control knobs and extract (2) #2 Philips screws from behind.

2. Using panel removal tool, remove top air conditioning panel, and extract (2) #2 Philips screws holding top brackets of

radio.

3. Release air conditioning bracket from left to right side by pressing together on tabs.

NOTE: You do not have to disconnect, just remove it out of the way of radio bracket.

4. Remove ashtray.

5. Using panel removal tool, carefully pry radio trim bezel towards you.

6. Extract (2) #2 screws from ashtray location.

7. Carefully disconnect and remove radio.

For Factory Wiring Codes go to: www.scosche-cars.com

FACTORY WIRING CODES

CAR STEREO CONNECTORS

PROVIDE EASY CONNECTION OF YOUR CAR

STEREO TO FACTORY WIRING HARNESS.

TA02

1987-UP Toyota

MOUNTING BRACKETS ASSEMBLY

A. ATTACHING MOUNTING BRACKETS (FRONT):

Align the two (2) "L" wedges with location opennings on the kit panel.

Pressure fit, push into locations until in place.

B. ATTACHING MOUNTING BRACKETS (BACK):

Align mounting hole of mounting bracket with hole locator on

pocket slide bracket on hole locator on pocket.

KIT PANEL ASSEMBLY

A. ATTACHING THE REAR BRACKET:

Align the two (2) screw emboss locations to the matching locations

on pocket. When aligned, slide the bracket together. Screw the two

(2) supplied screws to screw emboss locations.

2001-03 TOYOTA RAV4RADIO REMOVAL:

1. Extract (4) 5mm hex screws from radio trim bezel and pry off using panel removal tool.

2. Extract (4) 10mm bolts securing radio, pull away, disconnect and remove.

See Illustration "E"

ILLUSTRATION "A"

ILLUSTRATION "B"

ILLUSTRATION "C"

ILLUSTRATION D"

ILLUSTRATION "E"

2000-05 TOYOTA CELICARADIO REMOVAL

1. Remove shift knob and ashtray.

2. Unsnap shifter and ashtray bezel, unplug, lift away and remove.

3. Extract (2) Philips screws from bottom of temperature control panel.

4. Remove temperature control knobs and extract (1) Philips screw from behind each knob. Remove circulation slider.

5. Unsnap radio bezel, unplug, lift away and remove.

See Illustration "A" and "B"USE SHADED BRACKETS

VEHICLE APPLICATIONS

TOYOTA

2000-05 CELICA ................... 2

2000-05 ECHO ...................... 2

2001-UP HIGHLANDER......... 2

2000-05 MR2 SPYDER ......... 2

2004-05 RAV4 ....................... 2

2001-03 RAV4 ....................... 2

View the manual for the Scosche TA2046B here, for free. This manual comes under the category Car Kits and has been rated by 1 people with an average of a 6. This manual is available in the following languages: English. Do you have a question about the Scosche TA2046B or do you need help? Ask your question here

Need help?

Do you have a question about the Scosche and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Scosche owners to provide you with a good answer.

Number of questions: 0