Samsung WW80M642OBW QuickDrive manual

Samsung WW80M642OBW QuickDrive
6.8 · 2
PDF manual
 · 14 pages
English
manualSamsung WW80M642OBW QuickDrive

TRY THE FOLLOWING...

When the door does
not open
The door does not open when the temperature inside your washing machine is
high or when the tub is filled with water.
When the internal air temperature after a wash is higher than 70 °C or the water
temperature is more than 55 °C.
Wait until the internal temperature has dropped.
When the tub is filled with water.
Select Spin to drain the water. Then you will be able to open the door.
For some models, you can open door when “End” is displayed or the end
melody is played.
If you open the door by force, it may result in damage to the product or safety
issues.
When selecting the
Dry function
For the Drying capacity, 1/3 of the wash capacity is reasonable. The maximum
drying rate is 95%.
If you insert more than the maximum drying capacity specified in the user
manual, the drying performance may decrease.
Remove and shake out the laundry. Heat and moisture is removed and the
laundry will be dry.
When inserting
fabric softener
If fabric softener is inserted above the reference line (MAX) of the
fabric softener compartment, fabric softener may enter directly
into the tub.
Insert fabric softener only up to the reference line (MAX) so
that it does not overflow.
If the rinse cap (hereafter cap) is not inserted correctly or there
is foreign material in the cap when using concentrated fabric
softener (liquid fabric softener of a high viscosity), fabric softener
or water may remain.
Check whether the cap is correctly inserted into the detergent
compartment where the fabric softener is inserted.
Open the detergent compartment and press the removal
button inside. Remove and clean it.
When the wash time
increases
The wash time may increase if an unbalance is detected with the load, the
machine will automatically try to balance the load. This process may extend
the wash program time.
Press the Start/Pause button and then check the laundry status. Spread the
laundry evenly and perform the course again.

SELF-TEST

If any error message other than the following error messages is displayed, refer to the user manual.
Indication Symptom Action
When the door is
opened
Is the door opened?
Make sure to operate your washing machine after closing the
door.
When no water is
supplied
Is the tap closed?
Turn on the tap.
Is the filter net of the water supply hose connector blocked?
Remove and clean the filter net of the water supply hose.
When the water does
not drain
Is the drain filter blocked?
Clean the drain filter.
Is the washing machine frozen because of the cold weather?
Add hot water into the tub and let it defrost for about one hour.
When the internal
temperature of the
drum is high
Did the washing machine pause while drying or performing an air
wash?
The cooling fan operates automatically. Therefore wait until the
‘Hot’ indication disappears.
Only the Power and Start/Pause buttons operate while the ‘Hot’
indication displays.
When the internal temperature of the drum is high, the door
does not open. If you open the door by force, it may result in
product damage and safety issues. Therefore wait until the
temperature has dropped.
When water does not
drain because the
internal temperature
does not drop below
55 °C even if thirty
minutes has passed
after the wash has
finished
Have the cold and hot water supply hoses been mixed up?
Connect the cold and hot water supply hoses correctly.
Operate your washing machine again by pressing the Start/
Pause button.
Rinse
cap
MAX
DC68-02209B_EN_DE_FR_ES_IT_PT_RU.indd 2 2008-03-19 ¿ÀÈÄ 3:03:51

Manual

View the manual for the Samsung WW80M642OBW QuickDrive here, for free. This manual comes under the category washing machines and has been rated by 2 people with an average of a 6.8. This manual is available in the following languages: English. Do you have a question about the Samsung WW80M642OBW QuickDrive or do you need help? Ask your question here

Need help?

Do you have a question about the Samsung and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Samsung WW80M642OBW QuickDrive specifications

Below you will find the product specifications and the manual specifications of the Samsung WW80M642OBW QuickDrive.

General
BrandSamsung
ModelWW80M642OBW QuickDrive
Productwashing machine
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Samsung WW80M642OBW QuickDrive below.

What temperature should I use for my laundry?

The washing label of your garment shows the recommended washing temperature.

Do I need to use an anti-scaling agent for my washing machine?

It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.

How do I prevent my washing machine from smelling?

Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.

How do I properly install the Samsung WW80M642OBW QuickDrive washing machine to avoid vibrations and noise?

To properly install the Samsung WW80M642OBW QuickDrive washing machine and avoid vibrations and noise, follow these steps: 1. Choose a suitable location: Install the washing machine on a level and stable surface. Avoid placing it on slippery or uneven floors, as this can cause vibrations and noise during operation. 2. Level the machine: Check if the washing machine is level by adjusting the four leveling adjustment legs. Make sure all four legs are evenly and firmly on the floor. If the machine is not level, lift it slightly and adjust the lowest leveling leg until it is level. 3. Remove shipping bolts: Before using the washing machine, remove the shipping bolts from the back of the unit. These bolts are used to secure the drum during transportation and must be removed to prevent vibrations and noise during operation. Refer to the user manual for detailed instructions on removing the shipping bolts. 4. Clean the filter: Regularly clean the water supply filter and debris filter to ensure proper water flow and prevent blockages. Follow the instructions in the user manual to remove, clean, and reinstall the filters. Remember to always follow the instructions provided in the user manual for the specific model of the Samsung WW80M642OBW QuickDrive washing machine. By properly installing the machine and performing regular maintenance, you can enjoy a quieter and more efficient washing experience.

How can I level the Samsung WW80M642OBW QuickDrive washing machine using the adjustable feet?

To level the Samsung WW80M642OBW QuickDrive washing machine using the adjustable feet, follow these steps: 1. Check if the washing machine is installed on a slippery or uneven surface, as this can cause vibrations and noise. 2. Ensure that the four leveling adjustment legs are evenly and firmly on the floor. If there is excessive noise or vibration, adjustments may be needed. 3. Lift the washing machine slightly and adjust the lowest of the four leveling adjustment legs to make the machine level. 4. Use a spanner to unfasten the locking nut by turning it to the left. 5. Level the washing machine by turning the adjustable feet in and out as necessary, using your hand. 6. Once the machine is level, tighten the locking nut by turning it to the right using a spanner. Remember to remove the shipping bolts from the back of the washing machine before using it. For more detailed instructions, refer to the user manual. Please note that these instructions are specific to the Samsung WW80M642OBW QuickDrive washing machine and may not apply to other models.

How do I clean the water supply filter and debris filter of the Samsung WW80M642OBW QuickDrive washing machine?

To clean the water supply filter and debris filter of the Samsung WW80M642OBW QuickDrive washing machine, follow these steps: 1. Cleaning the water supply filter: - Pull and remove the filter net located inside the water supply hose connector. - Clean the filter thoroughly. - Insert the filter net back into the connector and fasten it securely. 2. Cleaning the debris filter: - Open the filter cover using a coin or a key. - Unscrew the emergency drain cap by turning it counterclockwise. - Pull out the emergency drain tube to drain any remaining water. - Clean the debris filter and the inside of the drain hose. - Hold the cap on the end of the emergency drain tube and allow all the water to flow into a bowl. - Replace the debris filter, the emergency drain cap, and tube, and then close the filter cover. Note: Make sure to install the filter net properly to prevent water leakage or operating errors. If the debris filter is not assembled correctly, it may also cause water leakage or operating errors. Please refer to the user manual for more detailed instructions and illustrations.

Is the manual of the Samsung WW80M642OBW QuickDrive available in English?

Yes, the manual of the Samsung WW80M642OBW QuickDrive is available in English .

Is your question not listed? Ask your question here

No results