Samsung WW80M642OBW QuickDrive manual

Samsung WW80M642OBW QuickDrive
6.8 · 2
PDF manual
 · 14 pages
English
manualSamsung WW80M642OBW QuickDrive

useful tips for your drum washing machine

The descriptions and images in this document may differ from your actual
purchased product. For more information, refer to the user manual.

INSTALLING YOUR WASHING MACHINE

Installing your washing machine in the location which is slippery
or uneven, will result in vibrations and noise.
If there is too much noise or vibration, check whether the four
levelling adjustment legs are evenly and firmly on the floor.
If the washing machine is not level, lift the washing machine
slightly and adjust the lowest of the four levelling adjustment legs.
Before using your washing machine, you must remove the
shipping bolts from the back of the unit.
For more information on removing the safety devices, refer to the user manual.

LEVELLING YOUR WASHING MACHINE WITH THE LEVELLING FEET

Refer to the descriptions appropriate to your washing machine.
1. Level your washer by turning the
adjustable nut in and out, as shown
in the figure.
2. When your washing machine is
level, tighten the locking nut using
the (-) driver.
1. Unfasten the locking
nut by turning it to the
left using a spanner.
2. Level your washing
machine by turning
the adjustable feet in
and out as necessary
by hand.
3. Fasten the locking
nut by turning it to the
right using a spanner.

CLEANING THE FILTER

Cleaning the water supply filter

If the filter net is not installed, it may cause a water leakage and operating error. Make sure to install it.
1. Pull and remove the filter net. 2. Clean the filter. 3. Insert the filter net and fasten
its connector firmly.

Cleaning the debris filter

When water does not drain well or ‘5E’ blinks on the display, clean the debris filter. The product appearance
may differ from your washing machine. (However, the cleaning descriptions are the same.)
1. Open the filter
cover using a coin
or a key.
4. Unscrew the
emergency drain
cap by turning it
counter clockwise.
2. Unscrew the
emergency drain
cap and pull out the
emergency drain
tube to drain off the
remaining water.
5. Clean the debris
filter and the inside
of the drain hose.
3. Hold the cap on
the end of the
emergency drain
tube and allow all
the water to flow
into a bowl.
6. Replace the
debris filter, the
emergency drain
cap and tube and
then close the filter
cover.
If you open the debris filter when water remains inside the tub, water may flow out.
If the debris filter is assembled incorrectly or not installed, it may cause a water leakage or operating error.
Therefore make sure to assemble it correctly.

MAKE SURE YOU KNOW...

Adding the
laundry
Adding laundry
Press the Add laundry(Stop&Add) button and add the laundry when the Add
laundry lamp turns on.
If you add the laundry during a spin cycle, it starts again with the initial set time
regardless of the remaining time.
Washing
bedding
Wash bedding using only the Bedding course.
You can wash acrylic, mixed spinning and woolen bedding.
When washing general clothes, the washing machine may
not operate in the optimal status.
Wash only one bedding item at a time regardless of size.
Insert bedding rolled up into a ball.
The center of gravity is distributed evenly causing less
vibrations and noise.
Do not wash electric blankets or carpets.
When spinning blankets, cotton bedding, and woolen bedding,
too much noise and vibrations may occur and the wash cannot
be completed as spinning is not performed.
Locking nut
Adjustable nut
Spanner
(-) Driver
Nut
Adjustable feet
Spanner
Inside
Debris
filter
Wash
individually.
Make sure that the leveling feet
legs are level with the floor.
DC68-02209B_EN_DE_FR_ES_IT_PT_RU.indd 1 2008-03-19 ¿ÀÈÄ 3:03:50

Manual

View the manual for the Samsung WW80M642OBW QuickDrive here, for free. This manual comes under the category washing machines and has been rated by 2 people with an average of a 6.8. This manual is available in the following languages: English. Do you have a question about the Samsung WW80M642OBW QuickDrive or do you need help? Ask your question here

Need help?

Do you have a question about the Samsung and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Samsung WW80M642OBW QuickDrive specifications

Below you will find the product specifications and the manual specifications of the Samsung WW80M642OBW QuickDrive.

General
BrandSamsung
ModelWW80M642OBW QuickDrive
Productwashing machine
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Samsung WW80M642OBW QuickDrive below.

What temperature should I use for my laundry?

The washing label of your garment shows the recommended washing temperature.

Do I need to use an anti-scaling agent for my washing machine?

It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.

How do I prevent my washing machine from smelling?

Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.

How do I properly install the Samsung WW80M642OBW QuickDrive washing machine to avoid vibrations and noise?

To properly install the Samsung WW80M642OBW QuickDrive washing machine and avoid vibrations and noise, follow these steps: 1. Choose a suitable location: Install the washing machine on a level and stable surface. Avoid placing it on slippery or uneven floors, as this can cause vibrations and noise during operation. 2. Level the machine: Check if the washing machine is level by adjusting the four leveling adjustment legs. Make sure all four legs are evenly and firmly on the floor. If the machine is not level, lift it slightly and adjust the lowest leveling leg until it is level. 3. Remove shipping bolts: Before using the washing machine, remove the shipping bolts from the back of the unit. These bolts are used to secure the drum during transportation and must be removed to prevent vibrations and noise during operation. Refer to the user manual for detailed instructions on removing the shipping bolts. 4. Clean the filter: Regularly clean the water supply filter and debris filter to ensure proper water flow and prevent blockages. Follow the instructions in the user manual to remove, clean, and reinstall the filters. Remember to always follow the instructions provided in the user manual for the specific model of the Samsung WW80M642OBW QuickDrive washing machine. By properly installing the machine and performing regular maintenance, you can enjoy a quieter and more efficient washing experience.

How can I level the Samsung WW80M642OBW QuickDrive washing machine using the adjustable feet?

To level the Samsung WW80M642OBW QuickDrive washing machine using the adjustable feet, follow these steps: 1. Check if the washing machine is installed on a slippery or uneven surface, as this can cause vibrations and noise. 2. Ensure that the four leveling adjustment legs are evenly and firmly on the floor. If there is excessive noise or vibration, adjustments may be needed. 3. Lift the washing machine slightly and adjust the lowest of the four leveling adjustment legs to make the machine level. 4. Use a spanner to unfasten the locking nut by turning it to the left. 5. Level the washing machine by turning the adjustable feet in and out as necessary, using your hand. 6. Once the machine is level, tighten the locking nut by turning it to the right using a spanner. Remember to remove the shipping bolts from the back of the washing machine before using it. For more detailed instructions, refer to the user manual. Please note that these instructions are specific to the Samsung WW80M642OBW QuickDrive washing machine and may not apply to other models.

How do I clean the water supply filter and debris filter of the Samsung WW80M642OBW QuickDrive washing machine?

To clean the water supply filter and debris filter of the Samsung WW80M642OBW QuickDrive washing machine, follow these steps: 1. Cleaning the water supply filter: - Pull and remove the filter net located inside the water supply hose connector. - Clean the filter thoroughly. - Insert the filter net back into the connector and fasten it securely. 2. Cleaning the debris filter: - Open the filter cover using a coin or a key. - Unscrew the emergency drain cap by turning it counterclockwise. - Pull out the emergency drain tube to drain any remaining water. - Clean the debris filter and the inside of the drain hose. - Hold the cap on the end of the emergency drain tube and allow all the water to flow into a bowl. - Replace the debris filter, the emergency drain cap, and tube, and then close the filter cover. Note: Make sure to install the filter net properly to prevent water leakage or operating errors. If the debris filter is not assembled correctly, it may also cause water leakage or operating errors. Please refer to the user manual for more detailed instructions and illustrations.

Is the manual of the Samsung WW80M642OBW QuickDrive available in English?

Yes, the manual of the Samsung WW80M642OBW QuickDrive is available in English .

Is your question not listed? Ask your question here

No results