Samsung RF27T5501B1 manual

Samsung RF27T5501B1
7.5 · 1
PDF manual
 · 2 pages
manualSamsung RF27T5501B1
If you have further questions or your refrigerator has damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864).

Before installation or calling service

1. Leveling & Door Alignment

For details, refer to “Leveling the Refrigerator” in the User Manual.
Insert a at-blade screwdriver into a slot on the control lever, turn it clockwise or counter-
clockwise to level the refrigerator.
You should level the refrigerator when it is empty. To level
the refrigerator, adjust the Leveling Leg Control by turning it
clockwise or counterclockwise with a at head screwdriver until
the Leveling Legs contact the oor.
Control Lever
Flat-blade screw driver(-)

Door Alignment

Open the freezer drawer to gain access to the adjustable hinge pin.
Adjust the door height difference by inserting a Snap Ring (A) as shown between the door and
the grommet(B).
Insert one snap ring only of the
correct thickness.
Keep the snap rings out of reach
of children.

2. Automatic Ice Maker does not work

Allow your refrigerator to operate and cool down for 24 hours (1 full day) before
dispensing large quantities of ice.
To ll the ice bucket to maximum capacity, dispense a few cubes 8 and 16 hours
after installation.
If Ice Maker Off is lit, the ice maker will not make ice.
To activate the ice maker, press the Ice Make button on the control panel so Ice Maker Off
is no longer lit. (applicable models only)

3. Water line is not connected

Leaving the water line disconnected may cause the water valve to become noisy.
The valve will generate a buzzing sound over time. If the water line is not connected to the
refrigerator or turned off, make sure that the ice making function is set to “Ice Maker Off”.
Also, do not attempt to use the water dispenser.

4. Small ice cubes, ice cubes with bubbles, or slow water dispensing

If the water lter is clogged, it may produce small ice cubes or bubbles inside the cubes.
Please replace the lter cartridge.
After replacing the lter, please dispense at least 3 gallons (2-3 minutes) of water to remove
any trapped air from the water line.

5. Water is not cool enough

The rst glass of water may not be cold enough because the stored water in the water tank
has not cooled completely.
Dispense several glasses of water until the water is cool enough.

6. Water dispenser dripping

If the water line is not inserted into the coupler properly, air could
penetrate into the water line causing water to drip from the water
1. The Water Line must be fully inserted to the center of the transparent
coupler (Type A) or the Guide Lines (Type B) to prevent water leakage
from the dispenser.
Center of
Transparent coupler
The Guide Lines
Type A Type B

7. Fridge or freezer Compartments are warm

Allow your refrigerator to operate and cool down for 24 hours (1 full day) to reach the
temperature you set.
Also, when you put room temperature or warmer food into your refrigerator, it may need
an additional 24 hours to reach the set temperature.

8. Moisture forms on outside/inside of refrigerator

Wipe off the condensation with a dry towel. (This may occur during hot and humid weather.)
If the condensation appears on the doors, turn off the Energy Saving* function.
( * applicable models only)
If you open the doors frequently or for too long, it may cause moisture to form inside the

9. Noise Clicks, Pops, Cracks, Snaps

You may hear these noises occasionally from inside the refrigerator. This is normal.
These sounds occur when various items contract or expand while temperatures inside the
fridge are changing, especially during defrosting. You may also hear these noises when
electronic devices, including the ice maker, are operating.

10. Display (applicable models only)

Filter indicator: The lter Indicator turns red after you use about 300 gallons of water
(about 6 months of usage). Replace the water lter, and then reset the indicator
(it will be Blue or off) by holding the lter reset button for 3 seconds.
Ice off: Press the “Ice Maker” button to turn the ice making function off.
Cooling Off (Show Room) mode: If the Display shows the “0F 0F” (or OFF) code, it means
that the Cooling Off function is activated and the refrigerator is not cooling.
To cancel the Cooling Off mode, press the multiple buttons on the display specied in the
user’s manual.

11. Food stored in refrigerator is frozen

If food with too much moisture is stored near the cooling vents, it may get frozen.
Be sure to keep moist food away from the cooling vents.

12. Moving the Refrigerator

When moving the refrigerator, pull or push it straight forward or backward.
Do not wiggle it from side to side.
Door Tube
DA68-02659B-00.indd 1 2019. 1. 15. �� 1:31

View the manual for the Samsung RF27T5501B1 here, for free. This manual comes under the category Refrigerators and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Samsung RF27T5501B1 or do you need help? Ask your question here

Need help?

Do you have a question about the Samsung and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Samsung owners to provide you with a good answer.

Number of questions: 0

User manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Samsung RF27T5501B1 below.

Is your question not listed? Ask your question here

No results