Rinnai RB-93TS manual

Rinnai RB-93TS
6.8 · 1
PDF manual
 · 22 pages
English
manualRinnai RB-93TS

Guide to the Appliances

RB-72S

RB-73TS

1
Small
Burner
Left ControlRight ControlBig BurnerBig BurnerBig Burner Big Burner Big Burner

RB-72G

Left ControlRight ControlExtra Small BurnerLeft ControlRight ControlRear Right ControlLeft ControlRight ControlRear Right ControlBig Burner Extra Small Burner

RB-73TG

Small
Burner

RB-92G

Big Burner Big BurnerLeft ControlRight ControlLeft ControlRight ControlRear Right ControlBig Burner Small Burner

RB-93TS

Medium
Burner

常见问题与解决方法

问题 可能导致的原因 解决方法
无点火 (DC)
自动点火功能不工作
燃烧器火焰不均匀。
气体流不正常或没有气
体流出。
厨房里有燃气气味。
其中一个燃烧器上的
安全阀不工作。
电池已经使用(排干)。
电极间隙过大。
点火器连接松动。
清洁产品粘在点火器和燃烧器之间。
燃烧器是湿的。
燃烧器盖未正确盖好。
燃烧器组件未正确装好。
燃烧器头部和主体上的凹槽是脏的。
中间阀阻断了气体供应。
如果气体从气瓶供应,请检查该气瓶
是否为空。
还有一个燃气龙头未关好。气瓶联接
器中可能存在泄漏。
控制旋钮未按下足够长时间。
燃烧器头部和主体上的凹槽是脏的。

如果上述检查后问题仍然存在,请联系Rinnai客户服务中心寻求帮助。

请告知设备附带的铭牌上的设备型号。

对于保修期内的维修呼叫,请注意,需要出示您的购买凭证和有效保修卡

铭牌仅供参考,其规格因型号而异.
25
更换了新电池。
检查间隙,并进行调整。 间隙
应该在45mm左右。
点火器和燃烧器之间的空间必须干
净。
仔细干燥燃烧器盖。
检查盖板是否正确放置。
确保组件正确安装。
清洁燃烧器头和主体上的凹槽。
(取决于型号)
打开所有中间阀。
更换气瓶。

关闭气体龙头。

检查联轴器是否良好。

如果它从炉具泄漏,请致电您

当地的Rinnai客户服务中心。

一旦燃烧器点燃,将控制旋钮向

下按几秒钟。

清洁燃烧器头和主体上的凹槽。

39
MODEL
FOR
PRESSURE
INPUT
SERIAL NO
: RB-72S
: LP
: 3.0
: 11.0
: 701000001
GAS
kPa
kW
CORPORATION

Manual

View the manual for the Rinnai RB-93TS here, for free. This manual comes under the category stoves and has been rated by 1 people with an average of a 6.8. This manual is available in the following languages: English. Do you have a question about the Rinnai RB-93TS or do you need help? Ask your question here

Need help?

Do you have a question about the Rinnai and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Rinnai RB-93TS specifications

Below you will find the product specifications and the manual specifications of the Rinnai RB-93TS.

General
BrandRinnai
ModelRB-93TS
Productstove
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Rinnai RB-93TS below.

Can I use my pans on induction?

Nowadays almost all pans are suitable for induction. You can easily test whether your old pans can also be used on induction by holding a magnet against the bottom of the pan. If the magnet stays on the pan, your old pan is suitable for induction.

How do I reset my induction hob?

Most induction hobs can be reset by disconnecting the hob from power by unplugging it from the power outlet. You will then have to wait at least 60 minutes.

What is a Perilex connection?

A Perilex connection is a special connection that can handle more power than a normal connection. This connection has five holes instead of two and is often used for induction hobs.

Is cooking on induction dangerous?

No, cooking on induction is not dangerous.

Is the manual of the Rinnai RB-93TS available in English?

Yes, the manual of the Rinnai RB-93TS is available in English .

Is your question not listed? Ask your question here

No results