Rinnai RB-93TS manual

Rinnai RB-93TS
6.8 · 1
PDF manual
 · 22 pages
English
manualRinnai RB-93TS

Trouble shooting Guide

Fault Possible cause Solution
No ignition (DC)
The automatic ignition
function does not work
The burner flame is not
uniform.
The flow of gas does not
appear normal or no gas
comes out.
The kitchen smells of
gas.
The safety valves on
one of the burners are
not working.
The battery have been used (drained)
up.
Electrode gap excessive
Ignitor connections loose
Cleaning products stuck between the
ignitor and the burners.
The burners are wet.
The burner covers are not correctly
positioned.
The burner components are not
correctly positioned.
The grooves on the burner head & body
are dirty.
The gas supply is blocked via
intermediary valves.
If the gas is supplied from a gas
cylinder, check that this is not empty.
A gas tap has been left on. There may
be a leak in the gas cylinder coupling.
The control knob was not held down
for long enough.
The grooves on the burner head & body
are dirty.
If problem persists after the above check, please contact Rinnai Customer Care Centre for
Assistance.
Please quote the model number of your appliance as shown on the rating plate attached to your
equipment.
For service call under warranty, please note that it is necessary to produce your proof of purchase
and valid warranty card.
Rating plate is for illustration purpose only and its specifications vary across models.
25
Replaced a new battery
Check gap, and adjust. The gap
should be around 4 to 5mm.
The space between the ignitor and
the burner must be clean.
Dry the burner covers carefully.
Check that the covers are correctly
positioned.
Ensure the components are
correctly positioned.
Clean the grooves on the burner
head & body.
( depending on model)
Open all intermediary valves.
Change the gas cylinder.
Turn off the gas taps.
Check that the coupling is sound.
Call your local Rinnai customer care
centre if it is leaking from the hob.
Once the burner is lit, hold the
control knob down a few seconds
longer.
Clean the grooves on the burner
head & body.
19
MODEL
FOR
PRESSURE
INPUT
SERIAL NO
: RB-72S
: LP
: 3.0
: 11.0
: 701000001
GAS
kPa
kW
CORPORATION
产品指引
RB-72S
RB-73TS
21
小炉头
左旋钮
右旋钮
大炉头 大炉头
RB-72G
超小炉头
右后旋钮
RB-73TG
RB-92G
小炉头
RB-93TS
中炉头
大炉头 大炉头
左旋钮
右旋钮
大炉头
左旋钮
右旋钮
右后旋钮
左旋钮
右旋钮
大炉头
超小炉头
小炉头
大炉头 大炉头 大炉头
右旋钮
左旋钮
右后旋钮
左旋钮
右旋钮

Manual

View the manual for the Rinnai RB-93TS here, for free. This manual comes under the category stoves and has been rated by 1 people with an average of a 6.8. This manual is available in the following languages: English. Do you have a question about the Rinnai RB-93TS or do you need help? Ask your question here

Need help?

Do you have a question about the Rinnai and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Rinnai RB-93TS specifications

Below you will find the product specifications and the manual specifications of the Rinnai RB-93TS.

General
BrandRinnai
ModelRB-93TS
Productstove
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Rinnai RB-93TS below.

Can I use my pans on induction?

Nowadays almost all pans are suitable for induction. You can easily test whether your old pans can also be used on induction by holding a magnet against the bottom of the pan. If the magnet stays on the pan, your old pan is suitable for induction.

How do I reset my induction hob?

Most induction hobs can be reset by disconnecting the hob from power by unplugging it from the power outlet. You will then have to wait at least 60 minutes.

What is a Perilex connection?

A Perilex connection is a special connection that can handle more power than a normal connection. This connection has five holes instead of two and is often used for induction hobs.

Is cooking on induction dangerous?

No, cooking on induction is not dangerous.

Is the manual of the Rinnai RB-93TS available in English?

Yes, the manual of the Rinnai RB-93TS is available in English .

Is your question not listed? Ask your question here

No results