Rinnai RB-93TS manual

Rinnai RB-93TS
6.8 · 1
PDF manual
 · 22 pages
English
manualRinnai RB-93TS

Installation Guide

Electrical installation
Please install a DC 1.5v battery into the battery casing at the bottom of the
Hob. (Fig 4)
When the battery is exhausted; or the spark become weak, a new battery should be
replaced. The battery compartment is located as shown in the diagram. Place the battery in
the correct polarity as shown.
Warning: Please take out the battery if the hob is not use for a long time.
Fig 4
FRONT
11
Gas Connection (Fig. 5)
The end of the inlet connection point of the gas hob has a 1/2” thread that allows for:
Fixed connection.
Connection using a flexible hose (For LPG only). In this case, it is necessary to insert the
accessory and the O-Ring as shown in Fig. 5. In this case, you must prevent the pipe
from coming into contact with moving parts of the kitchen unit being inserted (for
example, a drawer) and prevent access to any spaces which might become obstructed.
Warning! If any connection is handled, check for gas leakage. The manufacturer is not liable
for any connection leaking, after being handled.
A) Gas connector
B) O-Ring
C) LPG adaptor
D) LPG hose
E) Hose clip
Fig 5
A
B
C
E
D

安装指引

安装安装
与安装,调节和转换气种有关的所有操作必须由授权的安装人员执行,遵守气体和电力供应商
的适用法规,标准和规范。
在开始之前,请关闭设备的电力和气体供应。
建议您联系当地的Rinnai客户服务中心,以转换其他气种
与安装,调节和转换气种有关的所有操作必须由授权的安装人员执行,遵守气体和电力供应商
的适用法规,标准和规范。
在开始之前,请关闭设备的电力和气体供应。
建议您联系当地的 客户服务中心,以转换其他气种Rinnai
设备旁边的物体必须由不可燃材料制成。 用于粘合的层压覆盖物和胶必须是耐热的。
本设备不能安装在冰箱,洗衣机和洗碗机等之上。
如灶具安装在烤箱上方,那么烤箱必须有一个电源冷却风扇在安装手册中检查烤箱的尺寸。
如果安装了抽油烟机,则必须遵守安装手册的说明,始终保持至灶具的最小距离为550 mm
准备台面 (Fig 2 & Fig 3)准备台面
在台面上开一个合适的孔
推荐在离灶具底部10mm处放置一块不可燃阻隔版 (e.g.如金属或胶合板) 。这样就能防止进入
灶具底部。
如果是木质类台面,用特殊胶水清漆开孔台面。这样就能防止台面下方积聚水分而变得潮湿
器具安装器具安装
粘合密封胶 (灶具下侧)是出厂附带的: 任何情况下都不要移除它们。密封确保整个工作表面
是水密的,并防止水渗漏。
为了将设备安装到厨房柜中,首先将炉放置在正确的位置。 插入灶具。 按下灶的侧面
直到其整个周边被支撑。
移开灶具 (Fig 1)
1) 关闭燃气
2) 移开燃气软管
3) 抬起灶具
29
Fig 1

Manual

View the manual for the Rinnai RB-93TS here, for free. This manual comes under the category stoves and has been rated by 1 people with an average of a 6.8. This manual is available in the following languages: English. Do you have a question about the Rinnai RB-93TS or do you need help? Ask your question here

Need help?

Do you have a question about the Rinnai and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Rinnai RB-93TS specifications

Below you will find the product specifications and the manual specifications of the Rinnai RB-93TS.

General
BrandRinnai
ModelRB-93TS
Productstove
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Rinnai RB-93TS below.

Can I use my pans on induction?

Nowadays almost all pans are suitable for induction. You can easily test whether your old pans can also be used on induction by holding a magnet against the bottom of the pan. If the magnet stays on the pan, your old pan is suitable for induction.

How do I reset my induction hob?

Most induction hobs can be reset by disconnecting the hob from power by unplugging it from the power outlet. You will then have to wait at least 60 minutes.

What is a Perilex connection?

A Perilex connection is a special connection that can handle more power than a normal connection. This connection has five holes instead of two and is often used for induction hobs.

Is cooking on induction dangerous?

No, cooking on induction is not dangerous.

Is the manual of the Rinnai RB-93TS available in English?

Yes, the manual of the Rinnai RB-93TS is available in English .

Is your question not listed? Ask your question here

No results