Rane MLM82S manual

Rane MLM82S
(1)
  • Number of pages: 4
  • Filetype: PDF

Manual-1

MLM82S

MIC/LINE MIXER

OPERATORS MANUAL

MLM82S CONNECTION

When connecting the MLM82S to other components in your

system for the rst time, leave the power cord for last. is gives

you a chance to make mistakes and correct them without dam-

age to your fragile speakers, ears and nerves.

MIC/LINE INPUTS 1-4

e four XLR jacks provided on the MLM82S are balanced

MIC/LINE inputs. ey will also accept unbalanced connec-

tors. Use only shielded cable for inputs. For best noise rejection

use two-conductor-plus-shielded wire, even for unbalanced

operation. Connect the shield at both ends to help insure proper

grounding. See the Sound System Interconnection RaneNote

included with this manual for all cable adaptations. Rane follows

the AES recommended practice of pin 2 positive, pin 3 negative,

and pin 1 to shield. Switch any input connected to a microphone

to the MIC position (out) using the associated switches on the

rear panel. When connecting line level signals, switch the input

to the LINE position (in). A single phantom power switch is

provided for the four MIC inputs. If LINE is selected, Phantom

Power is disabled for that input.

QUICK START

is section is provided as a convenience for those in a rush. If you are experienced with this unit or other Rane products, these few

words will refresh your memory.

INPUTS 1 through 4 may be microphone or line level. e choice between the two is made by setting the LINE push buttons
on the REAR of the unit next to the MIC/LINE INPUT JACKS. Each microphone input may be assigned to A, B or A+B outputs

using the front panel ASSIGN switches.

INPUTS 5 through 8 are stereo line inputs which may be set to mono using the recessed MONO switches located on the front

panel.

Internal switches allow setting output signal levels for MIC or LINE. e factory default setting is LINE. If the MLM82S is con-
nected directly to a power amplier, equalizer or recorder input, choose LINE level. If the MLM82S is connected to a microphone

jack of an existing sound system, choose MIC level.

Once Inputs, Outputs, and power are properly connected, with the OUTPUT LEVELS counterclockwise (o ), set the Input
LEVELS as high as possible without causing the SIG/OL indicators to blink red except during extreme signal peaks. Now slowly

raise the OUTPUT LEVELS as desired.

STEREO LINE INPUTS 5-8

e ¼" connectors are line-level balanced/unbalanced Inputs.

If the MLM82S is to be used with unbalanced sources, consult

the Sound System Interconnection RaneNote included with this

manual for proper wiring. Stereo Inputs use both A and B jacks

at each INPUT. INPUTS 5 through 8 also serve as mono Inputs

when the front panel MONO switch is engaged.

OUTPUTS

e MLM82S’s OUTPUTS are balanced. e same wiring

conventions as the XLR Inputs apply. e type of device follow-

ing the MLM82S must be considered when setting the internal

Output Level switch. Choose between LINE (0 dB) or MIC (-40

dB) output, the factory setting is LINE. If the MLM82S is con-

nected directly to a power amplier input, choose LINE level. If

the MLM82S is connected to a microphone jack on an existing

sound system, choose MIC level. For unbalanced OUTPUT

connections do not tie pin 3 (i.e. “–”) to ground.

WEAR PARTS: is product contains no wear parts.

10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
MLM82S
MIC / LINE MIXER
OUTPUTS
1
MONO MIC / LINE INPUTS
5
STEREO LINE INPUTS
OL
A+B
ASSIGN
MONO
SIG / OL
2
A+B
ASSIGN
SIG / OL
3
A+B
ASSIGN
SIG / OL
4
6
MONO
7
MONO
8
MONO
A
OL
B
A+B
ASSIGN
SIG / OL
LEVELLEVELLEVELLEVELLEVELLEVELLEVELLEVELLEVELLEVEL
Rane MLM82S

Need help?

Number of questions: 0

Do you have a question about the Rane MLM82S or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Rane MLM82S owners to properly answer your question.

View the manual for the Rane MLM82S here, for free. This manual comes under the category Mixers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Rane MLM82S or do you need help? Ask your question here

Rane MLM82S specifications

General
Brand Rane
Model MLM82S
Product Mixer
Language English
Filetype PDF

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Rane MLM82S.

Is your question not listed? Ask your question here