Primo AS2 manual

Primo AS2
8.6 · 1
PDF manual
 · 2 pages
English
manualPrimo AS2
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu

Installation

Making the tap hole:
• Locatethetapholeperforationsontheundersideofthesink.
• Placethesinkinthecorrectposition.
• Useanawlandahammertohittheedgeofthetapholeperforationfromthevisiblesideofthesink.
Take care to hit softly and carefully.
To cut out the worktop:
• Placethesinkupside-downontheworktopwhereitwillbemounted.
• Drawtheperimeterofthesinkontheworktopwithapencil.
• Removethesinkanddrawadottedline,1cminsidetheperimeter.
• Makethecutoutwithsuitabletoolsalongthedottedline.
Inserting the sink in the hole of the working surface:
Sinksareprovidedwithpre-mountedhooks.Proceedasfollowstoinstallcorrectly
• Placethespecialincludedsealantalongthewholeperimeterofthesinkthatwillbeincontactwiththesurface.
• Placethesinkintheholeandmakesureitiscentered,thenlockthehookswiththeadjustmentscrewsfromthecenter
outwardsincrisscrossorder.
Drain connection
• Followtheinstructionsattachedtothedrainttings.

This Guarantee is Valid Providing that

• Theproducthasbeeninstalledbyasuitablyqualiedperson.
• Installationhasbeencarriedoutinaccordancewithinstructionsandcurrentlegislation.
• Proofofpurchasecanbeproduced.
• Theproducthasbeenusedfordomesticpurposesonly.
• Theproducthasnotbeentamperedwithorrepairattemptedormodiedbyanyunauthorisedperson.
• All products have been installed in accordance with WRAS regulations and local water by laws

This Guarantee does not Cover

• Damagebymisuse,neglectortransit.
• UseofpartsnotusedorrecommendedbyCDA.
• Routinemaintenance,generalwear&tearandinstallationfaults.
• Productsusedforcommercialorprofessionalpurposes.
Yoursinkisguaranteedagainstdefectsinmaterialsand/orworkmanshipfor5years.
AtthediscretionofCDA,shouldafaultarisethesinkmayberepairedorreplaced
andagreedrettingmaybereimbursedonreceiptonafaultysink/part,oncethey
havebeeninspectedanddeemedfaulty.

View the manual for the Primo AS2 here, for free. This manual comes under the category cutting machines and has been rated by 1 people with an average of a 8.6. This manual is available in the following languages: English. Do you have a question about the Primo AS2 or do you need help? Ask your question here

Need help?

Do you have a question about the Primo and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

General
BrandPrimo
ModelAS2
Productcutting machine
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Primo AS2 below.

Is the manual of the Primo AS2 available in English?

Yes, the manual of the Primo AS2 is available in English .

Is your question not listed? Ask your question here

No results