The LED will start flashing after powering on for 40-50 seconds.
2 RST
Press button for 10 seconds continuously to reset to default.
3 5V DC
Power port
4 LAN1
Connects to internet and provides PoE function
5 LAN2
Connects other devices for network expansion
6 Audio in
Connects to microphone
7 Audio out
Connects to speaker
8 SPK+
Connects to “+” loud speaker
9 SPK-
Connects to “-” loud speaker
10 3.3V
Power supply for devices, max. 500mA
11 5V
Power supply for devices, max. 200mA
12 GND
Ground
13
1, 2, 3, 4
Output port, output current 8mA. When any IP phone is dialed to VPA-100,
press 1* to enable/disable port1 output. For other ports, press 2* for port2, 3* fo
r
port3 and 4* for port4.
14
View the manual for the Planet VPA-100 here, for free. This manual comes under the category Network cards/adapters and has been rated by 1 people with an average of a 7.4. This manual is available in the following languages: English. Do you have a question about the Planet VPA-100 or do you need help? Ask your question here
Do you have a question about the Planet and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Planet owners to provide you with a good answer.
Need help?
Do you have a question about the Planet and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Planet owners to provide you with a good answer.
Number of questions: 0